Hanwha SPD-150 Bedienungsanleitung
Hanwha
Digital-Decoder
SPD-150
Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Hanwha SPD-150 (40 Seiten) in der Kategorie Digital-Decoder. Dieser Bedienungsanleitung war fĂĽr 50 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/40
NETWORK VIDEO DECODER
User Manual
SPD-150
Copyright
©2017 Hanwha Techwin
Co., Ltd. All rights reserved.
Trademark
Each of trademarks herein is registered. The name of this product and other trademarks mentioned in this manual are the registered trademark of
their respective company.
Restriction
Copyright of this document is reserved. Under no circumstances, this document shall be reproduced, distributed or changed, partially or wholly,
without formal authorization.
Disclaimer
Hanwha Techwin
makes the best to verify the integrity and correctness of the contents in this document, but no formal guarantee shall be
provided. Use of this document and the subsequent results shall be entirely on the user’s own responsibility. Hanwha Techw in reserves the right
to change the contents of this document without prior notice.
Design and specications are subject to change without prior notice.
The initial administrator ID is “admin” and the password should be set when logging in for the rst time.
Please change your password every three months to safely protect personal information and to prevent the damage of the
information theft.
Please, take note that it’s a user’s responsibility for the security and any other problems caused by mismanaging a password.
Network Video Decoder
User Manual
English _3
â—Ź OVERVIEW
IMPORTANT SAFETY INSTRUCTIONS
Read these operating instructions carefully before using the unit.
Follow all the safety instructions listed below.
Keep these operating instructions handy for future reference.
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean the contaminated area on the product surface with a soft, dry cloth or a damp cloth.
(Do not use a detergent or cosmetic products that contain alcohol, solvents or surfactants or oil
constituents as they may deform or cause damage to the product.)
7) Do not block any ventilation openings, Install in accordance with the manufacturer's instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding- type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug has two blades and a third grounding prong. The
wide blade or the third prong are provided for your safety. if the provided plug does not fit into your outlet,
consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or when unused for long periods of
time.
14) Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
15) This product is intended to be supplied by Listed Power Unit marked "Class 2" or "LPS" and rated 12 Vdc,
Min. 1.8 A.
16) The wired LAN hub providing power over the Ethernet (PoE) in accordance with IEEE 802-3af shall be a
UL Listed device with the output evaluated as a Limited Power Source as defined in UL60950-1.
17) Associated Ethernet wiring shall be limited to inside the building.
overview
Standards Approvals
J `Any changes or modifications in construction of this device which are not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
M
`
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
`
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
Produktspezifikationen
Marke: | Hanwha |
Kategorie: | Digital-Decoder |
Modell: | SPD-150 |
Installiertes Betriebssystem: | Eingebettetes LINUX |
Breite: | 178 mm |
Tiefe: | 187.8 mm |
Gewicht: | 680 g |
Produktfarbe: | Grau |
Höhe: | 34 mm |
Anzahl USB 2.0 AnschlĂĽsse: | 2 |
Gleichstrom-Anschluss (DC): | Ja |
Betriebstemperatur: | 0 - 40 °C |
Relative Luftfeuchtigkeit in Betrieb: | 20 - 85 % |
Zertifizierung: | CE, FCC |
Netzteil Eingansgsspannung: | 12 V |
Anzahl Ethernet-LAN-AnschlĂĽsse (RJ-45): | 1 |
Stromverbrauch (max.): | 8.4 W |
Gehäusematerial: | Metall |
Ethernet LAN Datentransferraten: | 10,100,1000 Mbit/s |
Anzahl Kanäle: | 49 Kanäle |
UnterstĂĽtzte Video-Modi: | 480p, 720p, 1080p |
UnterstĂĽtzte Videoformate: | H.264, H.265, MPEG |
Rack-Einbau: | Nein |
Maximale Framerate: | 120 fps |
Maximale Video-Auflösung: | 3840 x 2160 Pixel |
Ethernet Schnittstellen Typ: | Gigabit Ethernet |
Verkabelungstechnologie: | 10/100/1000BaseE-T(X) |
Anzahl der HDMI-Ausgänge: | 1 |
VGA (D-Sub)-AusgangsanschlĂĽsse: | 1 |
Rack-Kapazität: | 1U |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Hanwha SPD-150 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Digital-Decoder Hanwha
21 Mai 2023
Bedienungsanleitung Digital-Decoder
- Digital-Decoder Belkin
- Digital-Decoder Hama
- Digital-Decoder Philips
- Digital-Decoder TechniSat
- Digital-Decoder Schwaiger
- Digital-Decoder Denver
- Digital-Decoder König
- Digital-Decoder Telefunken
- Digital-Decoder Thomson
- Digital-Decoder Trevi
- Digital-Decoder Kenwood
- Digital-Decoder SEG
- Digital-Decoder Telestar
- Digital-Decoder Pioneer
- Digital-Decoder Nokia
- Digital-Decoder Megasat
- Digital-Decoder Ferguson
- Digital-Decoder Hyundai
- Digital-Decoder Loewe
- Digital-Decoder Strong
- Digital-Decoder GOCLEVER
- Digital-Decoder Marmitek
- Digital-Decoder Xoro
- Digital-Decoder Opticum
- Digital-Decoder Edision
- Digital-Decoder Humax
- Digital-Decoder Kathrein
- Digital-Decoder Wisi
- Digital-Decoder Black Box
- Digital-Decoder Viessmann
- Digital-Decoder EVOLVEO
- Digital-Decoder Vodafone
- Digital-Decoder DataVideo
- Digital-Decoder Engel Axil
- Digital-Decoder Hikvision
- Digital-Decoder Planet
- Digital-Decoder Dreambox
- Digital-Decoder TechnoTrend
- Digital-Decoder Formuler
- Digital-Decoder Laser
- Digital-Decoder Media-tech
- Digital-Decoder SetOne
- Digital-Decoder Vantage
- Digital-Decoder Amiko
- Digital-Decoder Dahua Technology
- Digital-Decoder Gefen
- Digital-Decoder Teradek
- Digital-Decoder Crestron
- Digital-Decoder Atlona
- Digital-Decoder WyreStorm
- Digital-Decoder Tams Elektronik
- Digital-Decoder Majestic
- Digital-Decoder Matrox
- Digital-Decoder I-CAN
- Digital-Decoder Golden Media
Neueste Bedienungsanleitung fĂĽr -Kategorien-
8 August 2024
24 Juni 2024
24 Juni 2024
24 Juni 2024
20 Juni 2024
20 Juni 2024
7 Juni 2024
7 Juni 2024
7 Juni 2024
7 Juni 2024