Grandstream GDS3702 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Grandstream GDS3702 (43 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 136 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/43
For Warranty and RMA information, please visit
www.grandstream.com
Grandstream Networks, Inc.
126 Brookline Ave, 3rd Floor
Boston, MA 02215. USA
Tel : +1 (617) 566 - 9300
Fax: +1 (617) 249 - 1987
www.grandstream.com
2
Intercom Access System
Quick Installation Guide
Content
English......................................................1
简体中文................................................10
EspaĂąol..................................................19
Français.............................................28
Deutsch................................................37
Italiano................................................46
РусскК................................................55
PortuguĂŞs............................................... 64
Polski.......................................................73
~ ~ ~ ~1 2
EN
PRECAUTIONS
PACKAGE CONTENTS
• Do not attempt to disassemble or modify the device.
• Strictly follow the requirement of power source.
• Do not expose this device to temperatures out the range
of -30 °C to 60 °C for operating and -35°C to 60°C for storage
• If the temperature is under -30 degree, the device will take
about 3 minutes to heat up itself before booting and
operating.
• Do not expose this device to environments outside of the
following humidity range: 10-90 RH (non-condensing).%
• Please strictly follow the instruction to install or hire
professionals to install properly.
1 x GDS3702 1 x Installation
Bracket
4 x Rubber Gaskets 6 x Bracket Screws
and Anchors
6 x Back Panel Screws
4 x Anti-tamper
Screws
1 x Anti-tamper
Hex Key
1 x Drilling
Template
1 x Wiegand
Cable
1 x Frame Back Cover
MOUNTING GDS3702
Step 2:
Pull Cat5e or Cat6 cable (not provided) through the rubber gasket
selecting the correct size and the back cover panel piece, please
refer to GDS3702 WIRING TABLE at the end of QIG for Pin connections.
Step 1:
Refer to the “drilling template” to drill holes at targeted place on
wall then mount the installation bracket using the four screws and
anchors provided (screwdriver not provided). Connect and tighten
“Ground” wire (if available) to the bracket ground marked with
printed icon .
On-Wall (Surface) Mounting
Note:
Needle nose plier highly recommended and 2.5mm at screwdriver
required (not provided). Stripping outer plastic shield of the cable
in less than 2 inches suggested. Do NOT leave bare metal outside
the socket by over stripping the inner plastic shield of the wires.
1x Quick Installation Guide


Produktspezifikationen

Marke: Grandstream
Kategorie: Nicht kategorisiert
Modell: GDS3702

Brauchst du Hilfe?

Wenn Sie Hilfe mit Grandstream GDS3702 benĂśtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Grandstream

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂźr -Kategorien-