Gel Blaster Surge Bedienungsanleitung

Gel Blaster Spielzeug Surge

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Gel Blaster Surge (2 Seiten) in der Kategorie Spielzeug. Dieser Bedienungsanleitung war für 21 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/2

WARNING:

Do not change the coloration and markings to make it look more like a ﬁrearm.

That is dangerous and may be a crime. Buyer and user have the duty to obey

all laws about the use and ownership of this toy. Adult supervision required.

Misuse or careless use may cause serious injury, especially to the eye.

Eye protection must be used by the user and any person within range. May be

dangerous up to 100 feet. Read owner’s manual before using. Recommended

for users 9 years or older, and may be more appropriate for users 12 years

and older.

CHANGE BARREL

BARREL TOOLBARREL

TO REMOVE, ROTATE

COUNTER-CLOCKWISE

SINGLE OFF FULL-AUTO

BLASTER MODE SWITCH

STEP 1 - HYDRATE YOUR GELLETS™ !! IMPORTANT !!

Gellets™ must be submerged in water for at least two hours to fully expand to size. They also need to have

plenty of water to absorb (this is very important) - you’ll know there was plenty of water if after 2 hours the Gellets

are still submerged in the water. Failing to completely hydrate Gellets will cause your Gel Blaster® to seem crappy.

Note: Make sure that the Gellets are prepared in an adequate sized container. Gellets will expand 10 times

their original size. Store hydrated Gellets away from the elements and direct sunlight. Gellets last

indeﬁnitely when dehydrated and up to three months when submerged in water.

STEP 2 - CHARGE YOUR BLASTER

The Charging LED light (on the bottom) will show solid red when charging, when fully charged,

the light will turn green. While in use, the light will ﬂash red on the side and the bottom of the

blaster to indicate a low battery.

STEP 3 - FILL YOUR HOPPER

Fill your hopper with hydrated Gellets, make sure all water is drained from

the hopper before installing on your blaster.

STEP 4 - INSTALL HOPPER ONTO BLASTER

Screw the hopper into the Starﬁre feedneck. Then slide the feedneck onto

the top rail of the SURGE with the arrow pointing forward.

IMPORTANT - Make sure you slide the feedneck all the way forward until you feel

and hear a “click”. Failing to do so will cause your Gel Blaster SURGE to misﬁre.

STEP 5 -OPTIONAL: INTERCHANGEABLE BARRELS

Your Gel Blaster currently comes with the Standard Barrel pre-installed (175fps).

To remove the barrel, use the Barrel Tool provided to unscrew the barrel. You can then

install your orange Reduced Velocity Barrel (100fps) for a lighter blasting experience.

IMPORTANT - DO NOT OVERTIGHTEN YOUR BARREL!

STEP 6 - PROTECT YOUR EYES!

Put on your provided eye protection when using your Gel Blaster SURGE. Make sure that others within

ﬁring distance are wearing eye protection too! Do not shoot at people not wearing proper eye-wear.

STEP 7 – POWER ON AND HAVE A BLAST!

Switch between Single and Full-Auto with the Blaster Mode Switch.

CLEAR

HOPPER

STARFIRE

FEEDNECK

HOPPER INSTALL

STATUS LIGHTS

USB-C CHARGING PORT

BATTERY

INDICATORS

SOAK FOR

2 HOURS

TIP

FINS

NOTCH

SIDE UP

TIP

FINS

NOTCH

SIDE UP

SWAP FINS & TIPS INSTALLREMOVE

GELLETS

HYDRATION

VIDEO

ONE GALLON OF WATER

MAKES 10,000 GELLETS™!

WARNING: The Gel Blaster is

not intended to get wet. Don't

submerge your Gel Blaster in

water, and make sure your Gellets are fully

strained of excess water. This will protect

the battery and circuitry within.

GELLETS

HYDRATION

VIDEO

HOW TO HYDRATE YOUR GELLETS™

1. Pour one 10k Gellet pack (included) into a

1-gallon+ container (preferably with a lid)

2. Add 1 gallon of water and wait at least 2hrs

3. Strain your full-size Gellets™ of excess water

4. Now you’re ready to go!

Fill your hopper and start blasting!

HOW TO STORE YOUR GELLETS™

Keep hydrated Gellets™ ready so you can use

your Gel Blaster whenever you want! Here’s

how to properly store hydrated Gellets.

1. Add water to your ammo container

until all Gellets are submerged

2. Seal the container with a lid

3. Store in a cool place out of direct sunlight

I N S T R U C T I O N S

MORE INFO ABOUT GELLETS™

• Gellets™ will expand 10x their original size!

• Removing excess water is important, wet

Gellets can damage your motor

• Avoid dehydration by making sure your Gellets are

completely submerged in water when not in use

• With proper storage, stadard hydrated Gellets

are usable for up to 3 months!

NEED MORE GELLETS?

SCAN HERE! >>>

Gel Blaster, LLC warrants this Gel Blaster® for a period of one month from the date of consumer purchase to

be free from defects in material and workmanship. Gel Blaster, LLC’s obligation under this warranty is limited

to repair or replacement of the purchased product only (although Gel Blaster, LLC may determine to issue a

refund, in its sole and exclusive discretion), and under no circumstances shall Gel Blaster, LLC be liable

for any loss, damage, injury, cost of repair, consequential damages, incidental damages, or

punitive, treble, or exemplary damages of any kind in connection with the sale, use, failure, or

repair of any product purchased from Gel Blaster, LLC, even if such damages are caused by the

negligence of the released party, whether sole or in combination with others. You hereby waive

any claim by an insurance carrier or other person or entity by way of subrogation, and you hereby

assign any and all such subrogation claims to Gel Blaster, LLC.

Gel Blaster, LLC disclaims any warranty of fitness for a particular purpose and any implied warranty of

merchantability. All implied warranties are hereby disclaimed, and you agree that the only warranty

provided by Gel Blaster, LLC to you is the above.

Gel Blaster, LLC’s liability for any and all claims arising out of or connected with the Gel Blaster® shall be

limited to the amount paid by consumer for the product plus the sum of $100.00.

You and Gel Blaster, LLC agree to mandatory, binding arbitration for any and all claims or causes of action

between the parties arising out of or in connection with your purchase or use of the Gel Blaster®, its accessories,

or otherwise with respect to any claims between you and Gel Blaster, LLC. The arbitration shall take place under

the rules of the American Arbitration Association, Consumer Arbitration Rules, before a single arbitrator. The

Arbitration shall take place in Dallas, Texas. You understand and agree that you are waiving your rights to a trial

by jury. You agree that any claim you have or may ever come to have against Gel Blaster, LLC must be submitted

on an individual basis, and you hereby waive the right to assert such claim collectively, such as in a class or

mass action. As a condition precedent to filing arbitration, you must contact Gel Blaster, LLC with any claim or

dispute, which must be mediated before a mutually agreeable mediator in Dallas, Dallas County, Texas.

You agree to the foregoing terms when you first charge or otherwise seek to use your Gel Blaster® or its accessories.

LIMITED WARRANTY, SUBROGATION WAIVER, WAIVER AND RELEASE, BINDING AGREEMENT TO ARBITRATE, CLASS ACTION WAIVER

** The Gel Blaster® SURGE provides hours of playtime per charge using a powerful lithium polymer battery! But with that power comes the responsibility to take care of your battery.

Abuse, neglect, or misuse can ruin your battery, shorten your playtime, or even cause a fire. If Surge won't take a charge, cease use and charging! Contact support@gelblaster.com

Q: My hopper & feedneck keep sliding off and

won’t feed the Gellets into my Gel Blaster®?

A: Please make sure your hopper is facing the right

direction - the front arrow (on your feedneck) should

be facing toward your ﬁns. If installed correctly, the

hopper and feedneck will click & lock in place.

Q: My Gellets aren’t shooting correctly and

are rolling out of my Gel Blaster’s barrel?

A: This is caused by Gellets that aren’t full size.

To make sure your Gellets are fully hydrated,

please allow your Gellets to be submerged in

water for a minimum of 2hrs before playing.