GE GN94DNSRSA Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für GE GN94DNSRSA (28 Seiten) in der Kategorie Durchlauferhitzer und Boiler. Dieser Bedienungsanleitung war für 44 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/28
1
49-50229-1 03-08 JR
Installation
Indoor Direct Vent Tankless Water Heater
Instructions Models GN75DNSRSA, GN94DNSRSA, GP94DNSRSA
Questions? Call 888.HOTWTER (888.468.9837) or Visit our website at ge.com
BEFORE BEGINNING INSTALLATION
Read these instructions completely and carefully.
IMPORTANT Save these instructions
for local inspector’s use.
IMPORTANT Observe all governing
codes and ordinances.
Be sure to leave theseNote to Installer –
instructions with the Consumer.
Keep these instructionsNote to Consumer –
for future reference.
Proper installation is the responsibility of the
installer.
Product failure due to improper installation
is not covered under the Warranty.
Recognize this symbol as an indication
of Important Safety Information!
WARNING: Read entire manual. Failure to follow all guides and rules could cause personal
injury or property damage.
Check with your state and/or local public works department for plumbing codes. You must follow their
guides as you install the Water Heater.
NOTE: Failure to comply with these installation instructions will void the product warranty, and the
installer will be responsible for any service, repair or damages caused thereby.
SAFETY PRECAUTIONS
WARNING: If the information in these
instructions is not followed exactly, a fire or explosion
may result, causing property damage, personal injury
or death.
FOR YOUR SAFETY!
Do not store or use gasoline or other
flammable vapors or liquids or other
combustible materials in the vicinity of this
or any other appliance. To do so may result
in an explosion or fire.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch;
do not use any phone in your building.
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
If you cannot reach your gas supplier,
call the fire department.
Do not return to your home until authorized
by the gas supplier or fire department.
Improper installation, adjustment, alteration,
service or maintenance can cause property
damage, personal injury or death. Refer to
this manual. Installation and service must
be performed by a qualified installer, service
agency or the gas supplier.
This water heater must be vented outdoors
using approved ducting materials.
Service information and wiring diagram are
located behind front panel.
Service must be performed by a qualified
service agency.
This appliance must be properly grounded and
installed as described in these instructions
.
FOR INDOOR APPLICATIONS ONLY
Installation Instructions
2
SAFETY PRECAUTIONS (cont.)
WARNING: Do not use substitute
materials. Use only parts certified with the
appliance.
This appliance must be installed, inspected and
leak tested by a state- or city-qualified licensed
contractor. It is the responsibility of the person
having the water heater installed to ensure the
installing contractor has proper licenses and
permits for installing water heaters in your
location. GE highly recommends that installers
attend a product knowledge class to ensure
customer satisfaction and warranty coverage.
Failure to comply with state and local codes
pertaining to water heater installations may
void the warranty.
This appliance is not to be installed outdoors.
The installation must conform with local codes or,
in the absence of local codes, with the National
Fuel Gas Code, ANSI Z223.1/NFPA 54, or the
Natural Gas and Propane Installation Code,
CSA B149.1.
The appliance and its appliance main gas valve
must be disconnected from the gas supply piping
system during any pressure testing of that
system at test pressures in excess of 1/2 psi
(3.5 kPa) (13.84 in W.C.).
The appliance must be isolated from the gas
supply piping system by closing its individual
manual shut-off valve during any pressure
testing of the gas supply piping system at test
pressures equal to or less than 1/2 psi (3.5 kPa)
(13.84 in W.C.).
Carefully follow the venting instructions
beginning on page 19 and in the Maintenance
section in the Owner’s Manual for adequate
combustion and ventilation air.
The appliance should be located in an area
where water leakage of the unit or connections
will not result in damage to the area adjacent to
the appliance or to lower floors of the structure.
When such locations cannot be avoided, it
is recommended that a suitable drain pan,
adequately drained, be installed under the
appliance. The pan must not restrict combustion
airflow.
SAFETY PRECAUTIONS (cont.)
The flow of combustion and ventilation air shall
not be obstructed.
This appliance is not suitable for use in an
application such as a pool or spa heater that
uses chemically treated water. (This appliance
is suitable for filling large or whirlpool bath tubs
with potable water.)
If a water heater is installed in a closed-water
supply system, such as one having a backflow
preventer in the cold water supply line, means
shall be provided to control thermal expansion.
Contact the water supplier or local plumbing
inspector on how to control this situation.
Should overheating occur or the gas supply fail
to shut off, turn off the manual gas control valve
to the appliance.
Keep the air intake (at the flue terminal external
to the home) location free of chemicals, such as
chlorine or bleach, that produce fumes. These
fumes can damage components and reduce
the life of your appliance.
CAUTION: DO NOT operate the water
heater if any part of the appliance has been under
water.
CAUTION: BURN HAZARD. Hot exhaust
and vent may cause serious burns. Keep back from
water heater unit. Keep small children and animals
away from unit.
CAUTION: Hot Water outlet pipes leaving
unit can be hot to touch. Insulation must be used
for hot water pipes below 36 due to burn risk to
children.
WARNING: This unit is not intended
or qualified for use in manufactured homes, mobile
homes or recreational vehicles.
DANGER
Read and follow water heater warnings and
instructions. If owners manual is missing, contact
the retailer or manufacturer.
3
Installation Instructions
TOOLS YOU WILL NEED
Pipe Wrenches (2) Gloves
Adjustable Pliers Safety Glasses
Screwdrivers (2)
Wire Cutters
MATERIALS YOU WILL NEED TO SUPPLY
Soap Solution Pipe Fittings Required:
Pipe Compound – Unions
Approved Venting – Ball Valves
5/8 ID PVC Flexible – Drain Valves
Tubing – Pressure Relief Valve
2 Conductor 22 AWG Wire for Remote Control
Single Gang Electrical Box
Wire Nuts
Concrete Wall Anchors (Optional)
Your installation components may vary.
PARTS PROVIDED
Locate the parts packed with the Water Heater.
Gas Valve 3/4 FNPT Ball Valve
4 #10 x 114
Wood Screws
OTHER TOOLS THAT MIGHT BE REQUIRED
Hammer Drill with Concrete Bits
• Saw
Threading Machine with Heads and Oiler
Core Drill with Diamond Head
Torch Set
Copper Tubing Cutter
Steel Pipe Cutter
OTHER MATERIALS THAT MIGHT BE NEEDED
Heat Tape
Pipe Insulation
Electrical Wire and Conduit per Local Code
Air Inlet Screen
Optional Pipe Cover AGTPCM
Optional Remote Controller AGTRC1


Produktspezifikationen

Marke: GE
Kategorie: Durchlauferhitzer und Boiler
Modell: GN94DNSRSA

Brauchst du Hilfe?

Wenn Sie Hilfe mit GE GN94DNSRSA benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Durchlauferhitzer und Boiler GE

Bedienungsanleitung Durchlauferhitzer und Boiler

Neueste Bedienungsanleitung für -Kategorien-