GE DDC4500SWH Bedienungsanleitung

GE Wäschetrockner DDC4500SWH

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für GE DDC4500SWH (3 Seiten) in der Kategorie Wäschetrockner. Dieser Bedienungsanleitung war für 4 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/3
DDC4500SWH – GE 5.4 Cu. Ft. Large Capacity Modular Commercial Gas Dryer
Specification Revised 8/04
370342
GE Appliances
Dryer Dimensions (in inches)
Exhaust Options:
Shipped with exhaust to the rear.
Gas model
recommended exhaust duct length is 15 feet of 4" rigid ducting
with two 90° elbows and 4" a dampered wall cap.
(See Installation Instructions.)
Requirements:
Gas
– 115 Volts, 60 Hertz single phase. An individual branch
circuit, properly grounded for a 3-prong outlet, fused for 15- or
20-amp is required for each dryer. Gas rate input, 22000 BTU/
Hr. Maintains the thermostatically controlled heat flow to dry
clothes gently. Longer cool down period on Permanent Press
cycle helps prevent heat-set wrinkles. Separate thermostat
controls lower temperatures for Knit cycle drying. Factory
equipped for natural gas. Tested for LP gas. A conversion kit is
required for LP gas. Check installation instructions for correct
kit number. Have a qualified technician install the conversion
kit. Equipped with energy saving Glo-Bar ignition.
77
27
27
Gas Dryer
only
Access
Panel
Access
Panel
11-3/4
41-5/8
3-1/2
3/4
1-7/8
2-3/8
Dimensions and specifications shown here are correct at the time this sheet was printed. Before
proceeding with construction or rough-in, check installation instructions that came with your unit
Specifications, dimensions and design are subject to change without notice
Note:
Wall anchor chain provided for gas models only
Front View
Rear View
For answers to your Monogram,
®
GE Pro le
or
GE
®
appliance questions, visit our website at
GEAppliances.com or call GE Answer Center
®
service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
DDC4500SWH – GE 5.4 Cu. Ft. Large Capacity Modular Commercial Gas Dryer
Specification Revised 8/04
370342
GE Appliances
For complete information, see installation instructions packed with your dryer
Important Note:
GE Kit Number WE14X70 needed when converting rear exhaust to bottom or side. (On large
capacity models.)
Ducting Materials:
For best performance, this dryer should be vented with 4" diameter all rigid metal exhaust duct
If all rigid metal” duct cannot be used, then flexible all metal” venting can be used, but it wil
reduce the maximum recommended duct length
Exhaust Length Calculation
1. Determine the number of 90° turns needed for your installation. If you exhaust to the sid
or bottom of dryer, add one turn.
2. The maximum length of 4' rigid (aluminum or galvanized) duct which can be tolerated is shown
in the table. The maximum length for flexible ducts are less than for rigid duct
A turn of 45° or less may be ignored. Two 45° turns within the duct length should be treated as a
90° elbow. A turn over 45° should be treated as a 90° elbow
Exhausting the dryer to the outside is strongly recommended
to prevent large amounts
of moisture and lint from being blown into the room. Gas dryers or any dryer located in a close
must
be exhausted to the outside
Caution:
For personal safety do not terminate exhaust into a chimney, under any enclosed
house floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard
or moisture could cause damage. Never terminate the exhaust into a common duct or plenum
with a kitchen exhaust, since the combination of lint and grease could create a fire hazard
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting
etc. The wall cap must also be located at least 12" above the ground or any other obstruction
with the opening pointed Down.
Other terminations, such as louvered wall boxes, are acceptable provided they are equivalent to
a 4" opening dampered wall cap.
Special Installation Requirements
Alcove or Closet Installation:
• If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.
• The dryer MUST be exhausted to the outside.
• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:
0" either side
3" front and rear
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".
Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open
area equally distributed.
If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in. of open area
equally distributed.
The closet should be vented to the outdoors to prevent gas pocketing in case of a gas leak in the supply line.
• No other fuel-burning appliance shall be installed in the same closet with the dryer.
Bathroom or Bedroom Installation:
• The dryer MUST be exhausted to the outdoors.
The installation must conform with the local codes, or in the absence of local codes, with the National
Fuel Gas Code, ANSI Z223.
Minimum Clearances other than Alcove or Closet Installation:
• Minimum clearances to combustible surfaces
0" both sides
3" rear
For answers to your Monogram,
®
GE Pro le
or
GE
®
appliance questions, visit our website at
GEAppliances.com or call GE Answer Center
®
service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
B
2-1/2
A
4
Best Performance
Maximum Length of 4" Dia.
Rigid Metal
Duct
Maximum Length of 4" Dia.
Flexible Metal
Duct
Exhaust Hood Type
Exhaust Hood Type
Domestic
Dryer Models
Number
of
9
Turns
Cat. No.
WX8X59
(Preferred)
A
4" Opening
B
2-1/2"
Opening
Cat. No.
WX8X58
(Preferred)
A
4" Opening
B
2-1/2"
Opening
Spacemaker
®
Models
DSKS433EW
WSM2780T
0
2
3
46
ft.
38
ft.
31
ft.
24
ft.
37
ft.
30
ft.
22
ft.
15
ft.
30
ft.
25
ft.
20
ft.
16
ft.
24 ft.
20
ft.
14
ft.
10
ft.
Spacemaker
®
Model
DSKP233EW
0
3
43
ft.
33
ft.
23
ft.
36
ft.
26
ft.
16
ft.
30
ft.
24
ft.
16
ft.
24
ft.
18
ft.
10
ft.
Spacemaker
®
Model
WSM2700T
0
2
3
56 ft.
4
6
ft.
34
ft.
32 ft.
42 ft.
36
ft.
28
ft.
18
ft.
30 ft.
22
ft.
16
ft.
10
ft.
22 ft.
14
ft.
10
ft.
1
5 ft.
Spacemaker
®
Models
WSM2420T
WSM2480T
0
2
43 ft.
33
ft.
23
ft.
36 ft.
26
ft.
16
ft.
30 ft.
24
ft.
16
ft.
24 ft.
8
ft.
10
ft
Dryer Exhausting Information Use Metal Duct Only
DDC4500SWH – GE 5.4 Cu. Ft. Large Capacity Modular Commercial Gas Dryer
Specification Revised 8/04
370342
GE Appliances
Features and Benefits
• Large Capacity (5.4 Cu. Ft.
• Commercial Modular Two-Unit Dryer System
• Automatic Dry Control
• Up-Front Lint Filter
• 3 Cycles: Cottons, Permanent Press, Delicates/Synthetic/Knits
• 3 Heat Selections
• Porcelain Drum Interior
• Front Serviceable
• Extra-Large Door Opening
• Reversible Door
• Model DDC4400SWH – White (Electric
• Model DDC4400SAD – Almond (Electric)
• Model DDC4500SWH White (Gas)
• Model DDC4500SAD Almond (Gas)


Produktspezifikationen

Marke: GE
Kategorie: Wäschetrockner
Modell: DDC4500SWH

Brauchst du Hilfe?

Wenn Sie Hilfe mit GE DDC4500SWH benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Wäschetrockner GE

Bedienungsanleitung Wäschetrockner

Neueste Bedienungsanleitung für -Kategorien-