Flashforge Adventurer 3 Pro 4 Bedienungsanleitung

Flashforge 3D-Drucker Adventurer 3 Pro 4

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Flashforge Adventurer 3 Pro 4 (52 Seiten) in der Kategorie 3D-Drucker. Dieser Bedienungsanleitung war für 3 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/52
用户使用手册
Adventurer 4 Series / 冒险家4 系列
User Guide
EN/CN-A01
P28
4 3D
This guide is only applicable to FLASHFORGE Adventurer 4 Series 3D printer
Content
Notice
Reference
Chapter 1 Adventurer 4 Series
1.1 - Component Introduction
1.2 - Packing Specification
Chapter 2 Introduction of User Interface
2.1 - Build
2.2 - Prepare
2.2.1 - Preheat
2.2.2 - Filament
2.3 - Settings
2.4 - Maintain
2.4.1 - Upgrade
2.4.2 - Log
2.4.3 - Calibration
2.4.4 - ChangeExtruder
2.4.5 - Maintain
Chapter 3 Software Installation
Chapter 4 Preparation of Device
Chapter 5 Print
Chapter 6 Q&A
Chapter 7 Support and Service
02
05
06
06
07
08
08
10
10
11
12
13
13
13
14
15
15
16
16
17
21
27
01
Notice
Safety Notice: please read and strictly follow all the
safety warnings and notice below.
Work Environment Safety
Keep your work place tidy.
Do not operate device in the presence of flammable liquids, gases or dust,
which will cause fire in the high temperature generated by the equipment.
Keep device out of children and untrained peoples reach.
Electrical Safety
Always use the device with a properly grounded outlet. Do not refit device plug.
Ungrounded / improperly grounded / refitted device plugs will increase the risk of
leakage of electricity.
Do not use device in damp environment or under the burning sun. Damp
environment will increase the risk of leakage / exposure to the sun will accelerate
the aging of plastic parts.
To avoid device damage, please use the power supply provided by Flashforge.
Avoid using the device during a thunderstorm.
In case of uncertain accident, please unplug the device if you do not use it for long.
When grounding, plug the power cord into the three-in-one socket and connect to
the external grounding wire through the grounding terminal of the three-in-one
socket.
Check and replace the fuse: To prevent electric shock, please be sure to turn off the
power switch and unplug the power cord before checking or replacing the fuse.
Replace the fuse: Open the fuse box of the three-in-one socket and replace the
fuse with the fuse of 5*20, T10AL250V specification.
Note Every printer has been tested before leaving factory. It is normal and will not
be of trouble if there are filament residue remaining in the extruder or slight
scratches on the plate.
02


Produktspezifikationen

Marke: Flashforge
Kategorie: 3D-Drucker
Modell: Adventurer 3 Pro 4

Brauchst du Hilfe?

Wenn Sie Hilfe mit Flashforge Adventurer 3 Pro 4 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung 3D-Drucker Flashforge

Bedienungsanleitung 3D-Drucker

Neueste Bedienungsanleitung für -Kategorien-