Eliminator Lighting Amber Fog 400 LED Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung fĂŒr Eliminator Lighting Amber Fog 400 LED (3 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂŒr 15 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/3
- 2 -
Warning:
- The smokemachine must be placed at least 100 cm away from inammable materials such as curtains,
books, etc. Make sure that the housing cannot be touched by accident.
- Use only water-based smoke uid recommended by your dealer. sinfen
- Poor smoke liquid caused permanent damage, bad eect, clogging, spitting of unevaporated liquid etc.
- Never add ammable uids (oil, gas, perfume) to the fog liquid.
- Always keep enough smoke liquid in the tank.
Use of the device without liquid will cause damage to the pump and heater.
- Do not obstruct the openings on top of the case to guarantee a good ventilation.
- ut any objects on the smoke machine. Don’t p
- For indoor use only.
- During installation, nobody should stand beneath the mounting area.
- Prior to the rst use, have the unit checked by a qualied person.
- The unit contains voltage carrying parts. DO NOT open the smokemachine
- Never plug or unplug the unit with wet hands.
- If the plug and/or mains lead are damaged, they need to be repaired by a qualied technician.
- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a mains outlet. It
needs to be repaired by a qualied technician.
- Only connect this unit to an earthed mains outlet of 220- Vac/50Hz . 240
- Always unplug the unit during a thunderstorm or when it is not in use.
- If the unit has not been used for a longer period of time, condensation can occur inside the housing. Please
let the unit reach room temperature prior to use.
- When you unplug the unit from the mains always pull the plug, never the lead.
- In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a solid chain, a
steel cable, etc. which has to be fastened separately from the mounting bracket.
- The supplied bracket is the main xing and must be used to solidly mount the light eect.
- In order to avoid accidents in public premises, the local legal requirements and safety regulations/warnings
must be fullled.
- Keep out of the reach of children.
Location
Select a location where it is easy to ll the tank. It is also possible to hang the unit by means of the supplied
holder and xing screws.
Intro : A compact 700W smoke machine with orange LEDs for an astonishing and unique flame eect while
producing fog. The smoke machine has a built in reservoir for the smoke uid. The LEDs flame eect can be
switched o on the back of the smoke machine. Smoke production can be activated on the supplied remote
control.
Installation and Use
Unpack the fog machine. Do not connect yet the net cable. Fill the uid tank by means of a funnel. Plug the unit
into a mains outlet. Thus the heating element is automatically switched on. Depending on the room temperature,
it takes about 3 minutes until the working temperature is reached. Then the thermostat is clicking and the LED
on the manual control lights up. Push the switch once and the smoke machine will produce a nice thick fog.
Once the smoke machine has reached its working temperature (the LED is lit) the smoke machine can produce
fog for a while. After this period of time, the fog generator is cooled so much down that the thermostat switches
o. Wait a while until the working temperature is reached again. It is recommended to produce smoke with small
pauses in between so that the temperature is maintained and th e thermostat doesn’t switch off.
Make sure that there is always enough liquid smoke contained in the tank. Use of the smoke machine without
liquid can permanently damage the unit. Once the smoke machine generates little smoke or pump generate
another 'rattling' sound i turn o the unit direct. Check the uid level and ll the tank when it is empty, check the
hose and lter blockages and restore it. Plug in the unit and check if the problem is resolved. If problem persists,
switch unit direct off to prevent further damage and contact your dealer.Switching the unit off :Switch the unit off
by unplugging it from the mains. Otherwise the 700W heating element will draw unnecessarily current.
- -3
Maintenance
Refilling the fluid reservoir should be done carefully. Remove the plug from the mains first! Then unscrew the
cap of the reservoir and fill it by means of a suitable funnel. Use only the origina smoke liquid. This fluid
is environmentally friendly, biodegradable and leaves no residue when used correctly. Make sure the smoke
liquid to become contaminated, close the cap of the liquid smoke can and after filling tank right.
After 40 hours, the smoke machine must be cleaned to avoid deposits in the machine, pump and heater.
Clean procedure
Run clean procedure in a ell-ventilated area w
Remove smoke liquid from the tank, add cleaning solution to tank
Switch smoke machine and wait until it is warm up
Pre the button to switch the liquid pumped through the machine ss
Perform the above operation until the tank is empty
Fill the tank with liquid smoke
Specifications
Power pply: ........................................................... 230V~/50Hz su
Heating element: ........................................................... 400 watts
Heat up time: ................................................................ 3 minutes
Smoke production: ............................................ ca. 75 m3/minute
Tank capacity: .......................................................250ml / 8.45oz
Dims: ............................................................. 250 x 160 x 140mm
Weight .................................................................................2.5 kg
Do t attempt to make y r irs y rself. This w ld invalid your wa ty.Do t make y chano an epa ou ou rran no an nge he un ous to t i This wt. ld also
invalid y r wa ty.The wa ty is not lic le in case of acci ts or m s caus by inappr riate use or disrespect of theou rran rran app ab den da age ed op
warnings c tained in this m l.sinfen c t ld res sible for rs l injuries caus by a disres ct of t safety on anua anno be he pon pe ona ed pe he
reco tion warnings. This is also lic le to all m in whatevermmenda s and app ab da ages form.
1 Year Limited Warranty: Eliminator Lighting warranty is valid from the date of purchase. Our
1 y m v s u uring s only. Ser num r, r h ear li ited warranty co er man fact defect ial be place of pu chase wit
dated valid receipt must be submitted at time of service. Eliminator Lighting warranty does not cover
items or parts prone to wear and tear: lamps, fuses, brushes and belts. Eliminator Lighting warranty
is only valid with-in the United States.
WARRANTY


Produktspezifikationen

Marke: Eliminator Lighting
Kategorie: Nicht kategorisiert
Modell: Amber Fog 400 LED

Brauchst du Hilfe?

Wenn Sie Hilfe mit Eliminator Lighting Amber Fog 400 LED benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Eliminator Lighting

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂŒr -Kategorien-