Drawmer DS501 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Drawmer DS501 (15 Seiten) in der Kategorie Effektmaschine. Dieser Bedienungsanleitung war für 12 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/15
i
DRAWMER
DS501
POWER GATE
OPERATOR’S MANUAL
CONTENTS
SAFETY CONSIDERATION page 1
INSTALLATION page 1
INTRODUCTION page 2
CONTROL DESCRIPTIONS page 4
OPERATION page 6
IF A FAULT DEVELOPS page 11
CONTACTING DRAWMER page 11
TECHNICAL SPECIFICATION page 12
BLOCK DIAGRAM page 13
ii
COPYRIGHT
This manual is copyrighted © 2001 by Drawmer Electronics, Ltd. With all
rights reserved. Under copyright laws, this manual may not be duplicated in
whole or in part without the written consent of Drawmer.
ONE YEAR LIMITED WARRANTY
Drawmer Electronics Ltd., warrants this product to conform substantially to
the specifications of this manual for a period of one year from the original
date of purchase when used in accordance with the specifications detailed in
this manual. In the case of a valid warranty claim, your sole and exclusive
remedy and Drawmer’s entire liability under any theory of liability will be to,
at Drawmer’s discretion, repair or replace the product without charge, or, if
not possible, to refund the purchase price to you. This warranty is not
transferable. It applies only to the original purchaser of the product.
For warranty service please call your local Drawmer dealer. Alternatively call
Drawmer Electronics Ltd. at +44 (0)1709 527574. Then ship the defective
product, with transportation and insurance charges pre-paid, to Drawmer
Electronics Ltd., Coleman Street, Parkgate, Rotherham, S62 6EL UK. Write the
RA number in large letters in a prominent position on the shipping box.
Enclose your name, address, telephone number, copy of the original sales
invoice and a detailed description of the problem. Drawmer will not accept
responsibility for loss or damage during transit.
This warranty is void if the product has been damaged by misuse,
modification or unauthorised repair.
THIS WARRANTY IS IN LIEU OF ALL WARRANTIES, WHETHER ORAL OR
WRITTEN, EXPRESSED, IMPLIED OR STATUTORY. DRAWMER MAKES NO
OTHER WARRANTY EITHER EXPRESS OR IMPLIED, INCLUDING, WITHOUT
LIMITATION, ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS
FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT. PURCHASER’S
SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY SHALL BE REPAIR
OR REPLACEMENT AS SPECIFIED HEREIN.
IN NO EVENT WILL DRAWMER ELECTRONICS LTD. BE LIABLE FOR ANY
DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES
RESULTING FROM ANY DEFECT IN THE PRODUCT, INCLUDING LOST
PROFITS, DAMAGE TO PROPERTY, AND, TO THE EXTENT PERMITTED BY
LAW, DAMAGE FOR PERSONAL INJURY, EVEN IF DRAWMER HAS BEEN
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states and specific countries do not allow the exclusion of implied
warranties or limitations on how long an implied warranty may last, so the
above limitations may not apply to you. This warranty gives you specific legal
rights. You may have additional rights that vary from state to state, and
country to country.
In the interests of product development, Drawmer reserve the right to modify
or improve specifications of this product at any time, without prior notice.
DS501 OPERATORS’ MANUAL 1
SAFETY CONSIDERATIONS
CAUTION - MAINS FUSE
TO REDUCE THE RISK OF FIRE REPLACE THE MAINS FUSE ONLY WITH THE SAME
TYPE, WHICH MUST BE A CLASS 3, 230 VOLT, TIME DELAY TYPE, RATED AT 80mA
WHERE THE MAINS INPUT VOLTAGE SWITCH IS SET TO 230 VOLTS AC. AND
160mA WHERE THE MAINS INPUT VOLTAGE IS 115 VOLTS AC. ALL FUSES MUST
COMPLY WITH IEC 60127-2. THE FUSE BODY SIZE IS 20mm x 5mm.
CAUTION - MAINS CABLE
DO NOT ATTEMPT TO CHANGE OR TAMPER WITH THE SUPPLIED MAINS CABLE.
CAUTION - SERVICING
DO NOT PERFORM ANY SERVICING. REFER ALL SERVICING TO
QUALIFIED SERVICE PERSONNEL.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS
EQUIPMENT TO RAIN OR MOISTURE.
INSTALLATION
This product is designed for standard 19" rack mounting and occupies 1U of rack
space. Use four M6 pan head screws to secure the unit into the rack. Fibre or plastic
washers may be used to prevent the front panel becoming marked by the mounting
bolts.
!Care should be taken in the choice of positioning. The unit should not be
mounted where other equipment obstructs the normal air flow.
Avoid mounting the unit directly above power amplifiers or power supplies
that radiate significant amounts of heat.
!The DS501 should not be operated near any water or in a location where
moisture might be present.


Produktspezifikationen

Marke: Drawmer
Kategorie: Effektmaschine
Modell: DS501

Brauchst du Hilfe?

Wenn Sie Hilfe mit Drawmer DS501 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Effektmaschine Drawmer

Bedienungsanleitung Effektmaschine

Neueste Bedienungsanleitung für -Kategorien-