Dormakaba PT21 Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Dormakaba PT21 (6 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 13 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/6
Narrow Headers - 1” and 1-1/4”
with PT21/PT21M for single or paired doors
Installation instructions
933820 – 08-2018
| | EN
2Narrow Headers with PT21/PT21M 08-2018933820
dormakaba Narrow Headers 1“ and 1-1/4“ with PT21 /PT21M
Installation Instructions
Table of Contents
Table of contents
1  Technical specifications 3
1.1 Overview 3
1.1.1 General information 3
1.1.2 Intended use 3
1.1.3 Glass requirements/fittings/mounting 3
1.1.4 Requirements for glass panel 3
1.1.5 Safety instructions 3
1.1.6 Symbols used - Safety/Installation 3
1.1.7 Maintenance, care, repair 3
1.1.8 Disposal 3
1.2 Pin diameter specifications 4
2  Installation instructions 4
2.1 Install narrow header for single or paired door:
PT21/PT21M 4
2.2 Secure cover 5
2.3 PT21/PT21M adjustments 5
dormakaba Narrow Headers 1“ and 1-1/4“ with PT21 /PT21M
Installation Instructions
Narrow Headers with PT21/PT21M 933820 08-2018 3
Technical specifications
1.1 Overview
These instructions are for installation of 1” and 1-1/4”
headers for the following mounting and style versions:
1. Glass mounting
1.1.1 General information
• dormakaba requires use of tempered laminated or
tempered monolithic glass.
• dormakaba glass hardware is not suitable for
applications in rooms where chemicals (e.g.
chlorine) are used such as indoor swimming pools,
saunas, or salt-water pools.
• Do not swing doors with excessive force. Install
limiting stop to prevent door from opening too far.
1.1.2 Intended use
• To house the PT21M overhead concealed pivot.
1.1.3 Glass requirements/fittings/mounting
• The substructure/wall must be able to bear
permanent loads, be level (max. tolerance: 1/16”
[2] per 39” [1m]).
• Fasteners must be sufficiently dimensioned for the
substructure/wall and weight of the door.
• When adjusting glass elements, always stick to the
required clearance for the respective hardware.
Adjust clearance so glass does not come in contact
with any hard surfaces such as glass, metal or
concrete.
• Do not use excessive force when installing the glass
(avoid over tightening screws.)
1.1.4 Requirements for glass panel
• dormakaba requires use of fully tempered glass,
which complies with ASTM C 1036 and ASTM C
1048. Secondary heat soaking processes are
recommended but not required. This applies to
both tempered monolithic and tempered laminated
glass.
• Clamping area must be flat and uncoated (no
self-cleaning coating!)
• Never use glass with conchoidal fractures and/or
damaged edges.
1.1.5 Safety instructions
• Installation requires two people.
• Only properly qualified and specially trained staff is
authorized to mount dormakaba glass hardware.
• Due to crushing hazards and possible injury caused
by breakage of glass during mounting,
corresponding protective clothing (especially gloves
and protective goggles) is required.
• Never clamp metal glass fitting hardware directly
to glass surface.
1.1.6 Symbols used - Safety/Installation
CAUTION
Mounting components must meet the
requirements of substructure/wall and door
weight. Please read the technical information
for fittings.
WARNING
Risk of breaking glass. When installing the
door, support the door panel with a block of
wood or similar object.
TIPS AND RECOMMENDATIONS
Universal PT21 pin diameter: 5/8” [15]
MUNDUS PT21M pin diameter: 9/16” [14]
1.1.7 Maintenance, care, repair
• Immediately replace damaged parts.
• Always use original dormakaba parts.
• Clean clamping area with alcohol-based standard
commercial cleaning agent before mounting the
glass hardware.
• Use a damp clothe for occasional cleaning.
• Always use silicone - and oil-free cleaners (e.g.
acetone).
• Check glass hardware at regular intervals for
proper positioning, smooth operation and correct
adjustment.
• High traffic door systems require inspection by
properly qualified staff (specialized companies or
installation firms.)
1.1.8 Disposal
Disposal in accordance with local, state and national
regulations.
1  Technical specifications


Produktspezifikationen

Marke: Dormakaba
Kategorie: Nicht kategorisiert
Modell: PT21

Brauchst du Hilfe?

Wenn Sie Hilfe mit Dormakaba PT21 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Dormakaba

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-