Cisco Aironet 1600i Bedienungsanleitung

Cisco Zugangspunkt Aironet 1600i

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Cisco Aironet 1600i (38 Seiten) in der Kategorie Zugangspunkt. Dieser Bedienungsanleitung war für 2 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/38
G ETTING S GTARTED UIDE
Cisco Aironet 1600 Series Access Points
First Published: December, 2012
Last Updated: March 31, 2015
1About this Guide
2Introduction to the Access Point
3Safety Instructions
4Unpacking
5Configurations
6Access Point Ports and Connectors
7Configuring the Access Point
8Mounting the Access Point
9Deploying the Access Point on the Wireless Network
10 Troubleshooting
11 Declarations of Conformity and Regulatory Information
12 Access Point Specifications
2
1 About this Guide
This Guide provides instructions on how to install and configure your Cisco Aironet 1600 Series
Access Point. The 1600 Series Access Point is referred to as the 1600 series or the access point in this
document.
2 Introduction to the Access Point
The 1600 series offers dual-band radios (2.4 GHz and 5 GHz) with integrated and external antenna
options. The access points support full interoperability with leading 802.11n clients, and support a
mixed deployment with other access points and controllers.
The 1600 series access point is available in controller-based mode and supports:
Simultaneous single-band or dual-band (2.4 GHz/5 GHz) radios
Integrated antennas on 1602I access point models (AIR-CAP1602I-x-K9, AIR-AP1602I-UXK9)
External antennas on 1602E access point models (AIR-CAP1602E-x-K9, AIR-AP1602E-UXK9)
Note Thex in the model numbers represents the regulatory domain. Model numbers
containing -UX, support the universal regulatory domain. For information on supported
regulatory domains, see Regulatory Domains section on page 6.
The features of the 1600 series are:
Processing sub-systems (including CPUs and memory) and radio hardware which supports:
Network management
ClientLink 2.0—BeamForming to 802.11n clients as well as legacy 802.11a/g OFDM clients
VideoStream
Location
WIDS/WIPS
Security
Radio Resource Management (RRM)
Rogue detection
Management Frame Protection (MFP)
32 MB flash size
802.11af/at
CDP (Cisco Discovery Protocol)
3
2.4 GHz and 5 GHz 802.11n radios with the following features:
3TX x 3RX
2 spatial streams, 300 Mbps PHY rate
DPD (Digital Pre-Distortion) technology
Radio hardware is capable of explicit compressed beamforming (ECBF) per 802.11n standard
3 Safety Instructions
Translated versions of the following safety warnings are provided in the translated safety warnings
document that is shipped with your access point. The translated warnings are also in the Translated
Safety Warnings for Cisco Aironet Access Points, which is available on Cisco.com.
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury.
Before you work on any equipment, be aware of the hazards involved with electrical
circuitry and be familiar with standard practices for preventing accidents. Use the
statement number provided at the end of each warning to locate its translation in the
translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Warning
Read the installation instructions before you connect the system to its power source.
Statement 1004
Warning
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Warning
This product relies on the buildings installation for short-circuit (overcurrent)
protection. Ensure that the protective device is rated not greater than:
20A.
Statement 1005


Produktspezifikationen

Marke: Cisco
Kategorie: Zugangspunkt
Modell: Aironet 1600i

Brauchst du Hilfe?

Wenn Sie Hilfe mit Cisco Aironet 1600i benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Zugangspunkt Cisco

Bedienungsanleitung Zugangspunkt

Neueste Bedienungsanleitung für -Kategorien-