Cisco Aironet 1142N Bedienungsanleitung

Cisco Zugangspunkt Aironet 1142N

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Cisco Aironet 1142N (36 Seiten) in der Kategorie Zugangspunkt. Dieser Bedienungsanleitung war für 7 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/36

GETTING S GTARTED UIDE

Cisco Aironet 1140 Series Autonomous Access Point

1About this Guide

2Safety Instructions

3Overview

4Obtaining and Assigning an IP Address

5Mounting the Access Point

6Configuring Basic Settings

7Troubleshooting

8Access Point Specifications

9Obtaining Documentation and Submitting a Service Request

10 Declarations of Conformity and Regulatory Information

78-18997-01

1 About this Guide

This Guide explains how to install and configure your Cisco Aironet 1140 Series Autonomous Access

Point. This guide also provides mounting instructions and limited troubleshooting procedures.

2 Safety Instructions

Translated versions of the following safety warnings are provided in the translated safety warnings

document that is shipped with your access point. The translated warnings are also in the Translated

Safety Warnings for Cisco Aironet Access Points, which is available on your documentation CD and

cisco.com.

Warning

IMPORTANT SAFETY INSTRUCTIONS

This warning symbol means danger. You are in a situation that could cause bodily injury.

Before you work on any equipment, be aware of the hazards involved with electrical

circuitry and be familiar with standard practices for preventing accidents. Use the

statement number provided at the end of each warning to locate its translation in the

translated safety warnings that accompanied this device.

Statement 1071

SAVE THESE INSTRUCTIONS

Warning

Read the installation instructions before you connect the system to its power source.

Statement 1004

Warning

This product must be connected to a Power-over-Ethernet (PoE) IEEE 802.3af compliant

power source or an IEC60950 compliant limited power source.

Statement 353

Warning

This equipment must be externally grounded using a customer-supplied ground wire

before power is applied. Contact the appropriate electrical inspection authority or an

electrician if you are uncertain that suitable grounding is available.

Statement 366

Warning

Installation of the equipment must comply with local and national electrical codes.

Statement 1074

Warning

This product relies on the building’s installation for short-circuit (overcurrent)

protection. Ensure that the protective device is rated not greater than:

20A.

Statement 1005

Warning

Do not operate your wireless network device near unshielded blasting caps or in an

explosive environment unless the device has been modified to be especially qualified for

such use.

Statement 245B

Warning

In order to comply with FCC radio frequency (RF) exposure limits, antennas should be

located at a minimum of 7.9 inches (20 cm) or more from the body of all persons.

Statement 332

Caution When mounting the access point to a wall or ceiling, be sure to use appropriate fasteners.

The fasteners used must be capable of maintaining a minimum pullout force of 20 lbs (9

kg) and must use all 4 indented holes on the low-profile mounting bracket.

Caution This product and all interconnected equipment must be installed indoors within the same

building, including the associated LAN connections as defined by Environment A of the

IEEE 802.af Standard.

Note The access point is suitable for use in environmental air space in accordance with section

300.22.C of the National Electrical Code and sections 2-128, 12-010(3), and 12-100 of the

Canadian Electrical Code, Part 1, C22.1. You should not install the power supply or power

injector in air handling spaces.

Note Use only with listed ITE equipment.

Produktspezifikationen

Marke:	Cisco
Kategorie:	Zugangspunkt
Modell:	Aironet 1142N
Breite:	221 mm
Tiefe:	221 mm
Gewicht:	1040 g
Produktfarbe:	Weiß
Höhe:	47 mm
AC Eingangsspannung:	100 - 240 V
AC Eingangsfrequenz:	50 - 60 Hz
Betriebstemperatur:	0 - 40 °C
Relative Luftfeuchtigkeit in Betrieb:	10 - 90 %
Netzstandard:	IEEE 802.11a, IEEE 802.11g, IEEE 802.11n
Unterstützte Sicherheitsalgorithmen:	AES, EAP-FAST, EAP-TLS, EAP-TTLS, MSCHAPv2, PEAP, TKIP, WPA, WPA2
Stromverbrauch (Standardbetrieb):	12.95 W
Maximale Datenübertragungsrate:	300 Mbit/s
Ethernet LAN Datentransferraten:	10,100,1000 Mbit/s
2,4 GHz:	Ja
Anzahl Kanäle:	11 Kanäle
WAN Port:	Ethernet (RJ-45)
Antenne Zunahmeniveau (max):	4 dBi
Eingebaut:	Ja
LED-Anzeigen:	Ja
Temperaturbereich bei Lagerung:	-30 - 85 °C
Frequenzband:	2.412 - 2.462, 5.28 - 5.32, 5.5 - 5.7, 5.745 - 5.825 GHz
Anzahl enthaltener Produkte:	1 Stück(e)
Speicherkapazität:	128 MB
5 GHz:	Ja
WLAN-Multimedia (WMM)/(WME):	Ja
Antennenfunktionen:	Integrierte Antenne
Flash-Speicher:	32 MB
Wi-Fi Datenrate (max):	300 Mbit/s
MIMO:	Ja
MIMO-Typ:	Multi User MIMO
Kanalabstand:	40 MHz