Chief SLM273 Bedienungsanleitung
Chief
Beamerzubehör
SLM273
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Chief SLM273 (1 Seiten) in der Kategorie Beamerzubehör. Dieser Bedienungsanleitung war für 4 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8802-002070 Rev00
©2010 Milestone AV Technologies,
a Duchossois Group Company
10/10
SSB-273, SSM-273, SLB-273 and SLM-273 Interface Brackets
SSB-273, SSM-273, SLB-273 and SLM-273 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place two spacers onto the bottom of the projector, aligning with two mounting holes in the main body of bracket and the threaded inserts
in the bottom of the projector and ensuring that triangle in bracket points towards front of projector.
4. Position two M4 x 25mm mounting screws with M4 flat washers through the spacers and into the threaded inserts. Place three M4 x 12mm
screws with M4 flat washers into the threaded inserts and mounting holes on interface bracket tabs. Tighten all fasteners at this time,
securing the bracket to the projector.
NOTE: Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions
in the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (3) Screw, Phillips Pan Head, Machine, M4 x 12mm
(4) 10-24 Thumb Nuts ** (2) Screw, Phillips Flat Head, Machine, M4 x 25mm
(1) All-Points Security Kit (2) Spacer, .500 x .316 x .500
(1) 5/32" Security Hex Key (5) Washer, Flat, M4
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific to SSB-style and SSM-style interface bracket installation: All appropriate screws come pre-installed in the circled locations above.
DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style interface bracket installation.
Note: SSB-style interface bracket connections are circled. Note: SSM-style interface bracket connections are circled.
SLB-273 SLM-273
Towards front
of projector Towards front
of projector
Produktspezifikationen
| Marke: | Chief |
| Kategorie: | Beamerzubehör |
| Modell: | SLM273 |
| Produktfarbe: | Schwarz |
| Paketgewicht: | 2000 g |
| Menge pro Packung: | 1 StĂĽck(e) |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Chief SLM273 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Beamerzubehör Chief
28 Mai 2024
28 Mai 2024
27 Mai 2024
26 Mai 2024
26 Mai 2024
25 Mai 2024
23 Mai 2024
23 Mai 2024
21 Mai 2024
20 Mai 2024
Bedienungsanleitung Beamerzubehör
- Beamerzubehör Da-Lite
- Beamerzubehör BenQ
- Beamerzubehör Manhattan
- Beamerzubehör Sony
- Beamerzubehör Optoma
- Beamerzubehör Lindy
- Beamerzubehör Vogel's
- Beamerzubehör Vision
- Beamerzubehör Omnitronic
- Beamerzubehör Barco
- Beamerzubehör NEC
- Beamerzubehör NewStar
- Beamerzubehör Insignia
- Beamerzubehör Projecta
- Beamerzubehör Peerless-AV
- Beamerzubehör AV:link
- Beamerzubehör Chipolino
- Beamerzubehör Sopar
- Beamerzubehör Kanto
- Beamerzubehör Christie
- Beamerzubehör Premier Mounts
- Beamerzubehör Herma
- Beamerzubehör Tempest
- Beamerzubehör Elite Screens
- Beamerzubehör Smart Media
Neueste Bedienungsanleitung fĂĽr -Kategorien-
7 Juni 2024
7 Juni 2024
28 April 2024
9 April 2024
3 April 2024
1 April 2024
1 April 2024