Chief SLM207 Bedienungsanleitung
Chief
Beamerzubehör
SLM207
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Chief SLM207 (1 Seiten) in der Kategorie Beamerzubehör. Dieser Bedienungsanleitung war für 29 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8802-000273 Rev01
©2009 Milestone AV Technologies,
a Duchossois Group Company
05/09
SSB-207, SSM-207, SLB-207 and SLM-207 Interface Brackets
SSB-207, SSM-207, SLB-207 and SLM-207 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUPIMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the interface bracket onto the bottom of the projector and align the outside holes in the bracket with the threaded inserts in the bottom
of the projector.
4. Place a nylon spacer on the lamp door. Slide spacer between the projector and bracket so it lines up with the threaded insert of your
projector and the counter sink hole in the bracket.
5. Using the M4 x 10mm mounting screws with washers and one M4 x 20mm screw, position screws and washers into the mounting holes.
Tighten all fasteners at this time, securing the bracket to the projector.
NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation instructions in the
All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (1) Spacer, Nylon, .500 x .194 x .500
(4) 10-24 Thumb Nuts ** (3) Washer, Flat, M4
(1) All-Points Security Kit (1) Screw, Flat head, M4 x 20mm
(3) Screw, Pan head, M4 x 10mm
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style
interface bracket installation.
SLB-207 SLM-207
Towards front of
projector
Towards front of
projector
(Note: SSB-style interface bracket connections
a
r
e
e
n
c
i
r
c
l
e
d
)
(Note: SSM-style interface bracket connections
a
r
e
e
n
circled)
Produktspezifikationen
| Marke: | Chief |
| Kategorie: | Beamerzubehör |
| Modell: | SLM207 |
| Produktfarbe: | Schwarz |
| Paketgewicht: | 2000 g |
| Menge pro Packung: | 1 StĂĽck(e) |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Chief SLM207 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Beamerzubehör Chief
28 Mai 2024
28 Mai 2024
27 Mai 2024
26 Mai 2024
26 Mai 2024
25 Mai 2024
23 Mai 2024
23 Mai 2024
21 Mai 2024
20 Mai 2024
Bedienungsanleitung Beamerzubehör
- Beamerzubehör Da-Lite
- Beamerzubehör BenQ
- Beamerzubehör Manhattan
- Beamerzubehör Sony
- Beamerzubehör Optoma
- Beamerzubehör Lindy
- Beamerzubehör Vogel's
- Beamerzubehör Vision
- Beamerzubehör Omnitronic
- Beamerzubehör Barco
- Beamerzubehör NEC
- Beamerzubehör NewStar
- Beamerzubehör Insignia
- Beamerzubehör Projecta
- Beamerzubehör Peerless-AV
- Beamerzubehör AV:link
- Beamerzubehör Chipolino
- Beamerzubehör Sopar
- Beamerzubehör Kanto
- Beamerzubehör Christie
- Beamerzubehör Premier Mounts
- Beamerzubehör Herma
- Beamerzubehör Tempest
- Beamerzubehör Elite Screens
- Beamerzubehör Smart Media
Neueste Bedienungsanleitung fĂĽr -Kategorien-
7 Juni 2024
7 Juni 2024
28 April 2024
9 April 2024
3 April 2024
1 April 2024
1 April 2024