Chauvet MT-07 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Chauvet MT-07 (12 Seiten) in der Kategorie Monitor. Dieser Bedienungsanleitung war für 2 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/12
English EN
Español ES
Français FR
Deutsch DE
Nederlands NL
Quick Reference Guide
Model ID: MT07
Scan the QR code to
access the product page,
warranty terms, and the
complete User Manual
1
EN
QUICK REFERENCE GUIDE
MT-07 QRG Rev. 1
Safety Notes
These Safety Notes include important information about installation, use, and maintenance of the MT-07.
FCC Statement of Compliance
This device complies with Part 15 Part B of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment do interference to es cause harmful
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
What is Included
AC Power
This product comes with an auto-ranging battery charger that can work with an input voltage range of 100–240 VAC, 50/
60 Hz and outputs 26.1 VDC, 780 mA.
• CAUTION:
• When transferring the product from extreme temperature environments, (e.g., cold truck to warm humid
ballroom) condensation may form on the internal electronics of the product. To avoid causing a failure,
allow the product to fully acclimate to the surrounding environment before connecting it to power.
• ALWAYS:
• Disconnect from power before cleaning the product.
• DO NOT:
• Open this product. It contains no user-serviceable parts.
• Connect this product to a dimmer or rheostat.
• Operate this product if the housing or cables appear damaged.
• Operate this product outdoors or in any location where dust, excessive heat, water, or humidity may affect
it (adhere to standards for the published IP rating).
• The maximum ambient temperature is 113 °F (45 °C). Do not operate this product at higher temperatures.
• The minimum startup temperature is -4°F (-20°C). Do not start the product at lower temperatures.
• The minimum ambient temperature is -22°F (-30°C). Do not operate the product at lower temperatures.
• To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
• In the event of a serious operating problem, stop using immediately.
• MT-07 module removal tool
• Battery charger
• Battery pack (installed)
• Carry case
• Quick Reference Guide
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
glish
EN
2
MT-07 QRG Rev. 1
QUICK REFERENCE GUIDE
Operation
Before operating this product, read the Safety Notes.
1. Identify which module to remove.
2. Place the MT-07 firmly and flat against the center of the module.
3. Press and hold the trigger.
4. Pull the MT-07 back until the module comes free from the connector.
5. Hold the trigger until the module is secure (hold the module with a hand or place it on a surface).
Battery Charge Notes
Rechargeable lithium-ion batteries are potentially hazardous and can present a serious FIRE HAZARD, SERIOUS
INJURY, and/or PROPERTY DAMAGE if damaged, defective, or improperly used.
• ALWAYS:
• Charge using a manufacturer-provided charger while the product is powered off.
• Charge the battery in temperatures between 32°–95°F (0°–35°C).
• Allow a depleted battery to charge for a few minutes before turning on the product. If the battery is
completely discharged, the device cannot be turned on immediately when the charger is connected.
• Keep at least 3 ft (1 m) distance to any heat source and away from flammable materials.
• Keep the lid of any charging case open while charging.
• Keep batteries away from children.
• Follow local regulations when disposing of batteries.
• Replace with a Dyson V6 battery or its equivalent.
• DO NOT:
• Continue charging if the battery becomes hot, smokes, swells, or gives off an odor during charging.
• Leave the product unattended while charging.
• Charge the battery in a closed container.
• Charge for more than 24 hours.


Produktspezifikationen

Marke: Chauvet
Kategorie: Monitor
Modell: MT-07

Brauchst du Hilfe?

Wenn Sie Hilfe mit Chauvet MT-07 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Monitor Chauvet

Bedienungsanleitung Monitor

Neueste Bedienungsanleitung für -Kategorien-