Celestron NexImage 5 Bedienungsanleitung

Celestron Kamera NexImage 5

Lies die bedienungsanleitung für Celestron NexImage 5 (12 Seiten) kostenlos online; sie gehört zur Kategorie Kamera. Dieses Handbuch wurde von 17 Personen als hilfreich bewertet und erhielt im Schnitt 5.0 Sterne aus 9 Bewertungen. Hast du eine Frage zu Celestron NexImage 5 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Seite 1/12
USERS MANUAL
Model #93711
English
Congratulations on your purchase of the Celestron NexImage 5 Solar System imaging camera.
Your NexImage camera comes with the following:
+ NexImage 5 Camera
+ 1.25” nose piece
+ CD including NexImage iCap and RegiStax processing software
+ USB Cable
Recommended Minimum System requirements:
+ Pentium IV, 2.0 GHz, 1GB RAM
+ Graphics card with 24 or 32 bit
+ Windows XP, Windows Vista, Windows 7 (32 & 64 bit)
+ DirectX 9.0c or higher
1.25”
Nose Piece USB CableNexImage 5 Camera
NexImage iCap and
Registax processing
software
Fig 1
1
Quick start
1. Place the CD into your computer’s CD rom drive.
2. Install both the NexImage iCap and RegiStax software
onto your computer.
3. Thread the 1.25” nose piece into the body of the
NexImage camera. see Fig 2.
4. Slide the 1.25” nose piece of the camera into the eyepiece barrel of your telescope. .see Fig 3
5. Plug the small end of the USB cable into the port on the back of the camera.
6. Plug camera into the USB port of your computer. Once connected, the Found New Hardware
message will appear. Follow the Installation Wizard until the device has been successfully installed.
2
Fig 2
Fig 3


Produktspezifikationen

Marke: Celestron
Kategorie: Kamera
Modell: NexImage 5

Brauchst du Hilfe?

Wenn Sie Hilfe mit Celestron NexImage 5 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten