Byron SX-15 Bedienungsanleitung
Byron
Türklingel
SX-15
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Byron SX-15 (2 Seiten) in der Kategorie Türklingel. Dieser Bedienungsanleitung war für 19 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/2
Wire Free Battery Bell Kit
SX-15
The wirefree battery bell kit consists of two
separate units:
1. Push button unit (Transmitter)
2. Door chime unit (Receiver)
These units are completely self-contained
and no wiring between them is necessary.
No wiring is required for this wirfree door bell
kit. When the push button is pressed, it sends
a wirefree signal to activate the door bell.
As the operating range is up to 100 metres
(320 ft. approx.), you can mount the door bell virtually
anywhere in the home, workshop, or office. However,
the operating range of the wirefree signal will be
reduced if the signal is transmitted through a number
of walls or ceilings. Metal, and UPVC doorframes will
also reduce the operating range.
Installation
Push button unit
1. The push button unit is operated by 2 x 3 volt
Lithium batteries (CR2032 - ).included
2. Remove the back of the case by pushing in the tab
on the bottom with a small, flat screwdriver.
3. 2 x 3 volt Lithium batteries (CR2032) have been
installed. Simply pull off the isolating strip to allow
the batteries to make electrical contact.
4. Snap the front cover of push button back on and it
is ready to use.
Replacing the batteries. Remove the locking screw
from the battery fastener in the battery compartment.
Insert 2 x 3 volt Lithium batteries (We recommend
Byron model SX-100 - ), ensure thenot included
battery’s polarity matches the internal markings.
Tighten the screw on the battery fastener to hold the
batteries firm in their compartment. Test to see if the
L.E.D. light comes on.
UM-1
“D”
R20
UM-1
“D”
R20
Installation Guide
a) Bell Push Unit: Using the two holes on the back of push button
as a template,mark the fixing position for the unit. Drill holes,
fit wall plugs (if fixing to masonry) and secure the Bell Push
Unit with screws (self-tapping N3 x 16mm screws - )included
in position, alternatively use the double-sided self-adhesive
pad ( ), by placing onto your front doorframe or aincluded
position nearby. Please note, the latter is not the most theft
resistant option.
Important: Mounting the push button unit onto UPVC doorframes
or metal surfaces will reduce the operating range.
b) Door Chime Unit: This has a slotted hang hole on the rear,
this hole will enable the chime unit to be hooked onto a
screw and be easily removed or relocated to another room.
Drill a hole and fit wall plug (if fixing to masonry) and screw (self-tapping N3
x 16mm screw ) to fixing position. Leave a gap of 3mm between theincluded
screw head and the wall. Locate the keyhole slot on the back of the unit over
the screw.
Battery Bell unit
1. Remove the front cover, insert 2 x 1.5 volt alkaline
batteries (“D”, UM1, R20 size not supplied) into the
battery compartment, ensuring the battery polarity
match the internal markings.
2. Snap the front cover back on, the chime unit is ready
to use.
NOT TO BE USED WITH A TRANSFORMER.
Channel Selection
The unit comes from the factory on a pre-set
radio frequency channel. However, should
your door chime activate intermittently for no
reason at all, it is possible that a similar unit
is operating nearby on the same frequency.
The encoded frequency of the push button
(transmitter) and Door Chime (receiver) can
be changed to avoid this problem.
1. Remove the back of the caseBell Push:
by pushing in the tab on the bottom with
a small, flat screwdriver.
Door Chime Unit: Slide open the battery compartment.
2. There is 4 position dip switch marked 1,2,3,4. Use a small screwdriver to
alter the dip switch levers to the “On” or “Off” position, which can be altered
to achieve total sixteen (16) possible channels.
This
way
up
C
R
2
0
3
2
C
R
2
0
3
2
C
R
2
0
3
2
C
R
2
0
3
2
CR2032 x 2
Door Bell Operation
Press the button on the push button unit once, the LED indicator will light up
during signal transmission for 1 second and the door chime unit will sound.
The sound will stop as soon as the melody ends. For repeat sound, press the
button again. Holding the button in will NOT repeat the sound.
Sound Adjustment
To slightly adjust the sound of the bell, loosen the screw
that holds the dome in place. Turn the dome and then
tighten the screw.
Important
1. Do not mount the Push Button unit onto any metal or
UPVC doorframe as this will reduce the operating
range.
2. Do not immerse either unit in water.
3. Do not expose either unit to high temperatures or
close to fireplace.
4. Do not use different type of batteries, or mix up old
and new batteries.
5. Do not leave exhausted batteries in either unit. If leaving the doorbell for a
long period of time, remove the batteries from all compartments to prevent
leakage.
6. The chime unit is designed for internal use only.
7. Please dispose of old, defective batteries in an environmentally friendly
manner in accordance with the relevant legislation.
8. The unit should not be exposed to or placed near sources of water or direct
heat.
9. Replace batteries only with the same or equivalent type recommended by the
manufacturer.
10. Do not place near a P.I.R. which may interfere with your chime.
3. Select any combination ensuring it is set to the same code on pushboth
button and door chime units. E.g. If the 1 & 2 dipswitches are down in
your push button, then the 1 & 2 dipswitches must be down in your
chime unit.
4. Test to ensure correct operation before final installation.
Trouble Shooting & User Hints
Problem
Chime does not
sound but LED
lights on Push
Button
Possible Causes
1. Units is out of range (max.
range 100m)
2. Push button and chime not
on same channel
Suggested Remedy
Operate the Chime unit within the
operation range (100m)
Re-set the channel (see Channel
Set Up)
Chime does not
sound plus no
lights on Push
Button LED
1. Flat push button battery
2. Wrong polarity of battery in
push button
3. Remove the protective Strip.
Change the battery
Re-insert battery as internal
marking in right polarity
Chime sounds
without push
button being
pressed
A similar wirfree door chime
product is operating nearby
on the same transmitter
frequency
Change transmission channel
(see Channel Set Up)
NOTE: There are no serviceable parts in the unit, do not attempt to repair it.
Specification
A. Push Button unit
Power
Consumption
: 2 x 3volt Lithium batteries (CR2032 - included, replace with
Byron model SX-100)
: 3.0mA - ON
0.003mA - OFF
B. Door Chime unit
Power
Consumption
Operating Temperature
Operating Distance
Selectable Channel
: 2 x 1.5volt batteries (“D”, R20 or UM1 - not included)
Alternatively powered by A/C-D/C 9volt 300mA
adaptor (Byron model SX-36 - not included)
: 100mA - ON
0.3mA - Stand-by
: -10 C to +40 C° °
: 100 metres (320 feet approx.) in open field
: Total sixteen (16) possible channels
Produktspezifikationen
| Marke: | Byron |
| Kategorie: | Türklingel |
| Modell: | SX-15 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Byron SX-15 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Türklingel Byron
14 April 2024
14 April 2024
13 April 2024
28 März 2024
27 März 2024
27 März 2024
22 Februar 2024
12 Februar 2024
4 Februar 2024
17 Januar 2024
Bedienungsanleitung Türklingel
- Türklingel Infiniton
- Türklingel Hama
- Türklingel Nedis
- Türklingel SilverCrest
- Türklingel Panasonic
- Türklingel Profile
- Türklingel Quigg
- Türklingel REV
- Türklingel Alecto
- Türklingel EMOS
- Türklingel Gira
- Türklingel König
- Türklingel Grundig
- Türklingel Elro
- Türklingel EZVIZ
- Türklingel Perel
- Türklingel Lifetec
- Türklingel Honeywell
- Türklingel Cata
- Türklingel Netatmo
- Türklingel Baseline
- Türklingel M-e
- Türklingel Fanvil
- Türklingel Eufy
- Türklingel Grothe
- Türklingel Friedland
- Türklingel Ring
- Türklingel Swann
- Türklingel Mr Handsfree
- Türklingel Elektrobock
- Türklingel Intertechno
- Türklingel Orbegozo
- Türklingel Heidemann
- Türklingel Mercury
- Türklingel Smanos
- Türklingel Steren
- Türklingel X-Sense
- Türklingel ACTi
- Türklingel Aiphone
- Türklingel Chacon
- Türklingel ORNO
- Türklingel Vibell
- Türklingel ZAMEL
- Türklingel NuTone
Neueste Bedienungsanleitung für -Kategorien-
16 April 2024
14 April 2024
11 April 2024
8 April 2024
7 April 2024
6 April 2024
3 April 2024
3 April 2024
2 April 2024
29 März 2024