Brula D plus - tief - deep Bedienungsanleitung
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Brula D plus - tief - deep (19 Seiten) in der Kategorie Härten. Dieser Bedienungsanleitung war für 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/19
2
General
Introduction
You have opted for a BRULA basic stove firebox. We would like to congratulate you
on your choice and thank you for showing confidence in our product.
With this product you are getting premium quality basic stove technology for a
healthy radiant heat and stylish heating.
We hope you enjoy using our "fiery" products.
These assembly and operating instructions serve to familiarise you with the
assembly and correct handling of this fireplace in order to ensure smooth operation.
Please take the time to read these assembly and operating instructions carefully.
Our warranty and guarantee only apply if all points for the correct assembly and
operation of the fireplace are observed as described below.
Keep the assembly and installation instructions in a safe place so you can refer to
how to operate the fireplace correctly time and time again (e.g., at the start of a new
heating period).
The basic stove principle
The basic stove (also known as a storage stove) is synonymous with long-lasting
and healthy heating. And these are precisely the advantages offered by this stove
system. Compared to a hot air system which uses the principle of convection and
essentially only heats up the air, a basic stove emits warmth into the room slowly
and evenly in the form of healthy radiant heat, something which is valued in
particular by allergy sufferers.
And this is how it works:
Once the fire has been lit in the combustion chamber, the heating gases are drawn
through a draught system made of firebricks which absorb and store the heat. The
draught system is designed so that the heating gases must firstly pass through the
entire stove before escaping through the chimney. This means that the generated
heat is emitted by the stove over a long period of time. The radiant heat created in
this way does not heat up the air but rather the objects which it encounters, just like
a ray of sun.
BRULA GmbH
Weidacher Str. 17
87471 Durach/Allgäu, Germany
Tel. +49(0)831-564070
Fax +49(0)831-56407-50
info@brula.de
3
Operating instructions
General requirements
Please note that national and local provisions must be satisfied when installing the
BRULA basic stove firebox.
Please consult your competent district master chimney sweep about this prior to
installation. He will advise you on the suitable chimney as well as all other
requirements which are of relevance for the setup and commissioning of your basic
stove. A sufficient combustion air supply must be ensured in particular, especially
with a very well sealed building shell, flat ventilation systems etc. in order to
guarantee smooth operation.
Your chimney sweep will be able to help here too. He will also check that the
fireplace has been connected properly. The basic stove firebox described here is
tested according to EN 15250 BlmschV (level 2) (German Federal Immission
Protection Ordinance) and may be attached to a chimney with multiple connections
provided that the chimney's technical conditions allow this. If the basic stove is
attached to a chimney with multiple connections, the heating door used must be self-
closing. This ensures that the door closes automatically after adding more fuel and
thus the supply pressure of the chimney is not affected.
Installation site / fire protection regulations
When setting up the basic stove, the valid fire protection regulations of the German
Fire Code Ordinance (FeuVo) and the specifications of the stove and air heating
construction trade (TROL) with respect to fire and heat protection must be observed.
The specified minimum distances to combustible objects and walls must be
maintained and the flooring must also be protected.
Note:
Only set up the fireplace on surfaces with a sufficient load bearing capacity. If the
load bearing capacity is not sufficient, suitable measures must be taken (e.g., plate
for load distribution) to remedy this.
Connection to the chimney
All connections from the stove to the chimney must be tight and firm. Always use a
wall lining to connect the connecting piece to the chimney.
Produktspezifikationen
| Marke: | Brula |
| Kategorie: | Härten |
| Modell: | D plus - tief - deep |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Brula D plus - tief - deep benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Härten Brula
15 August 2024
13 August 2024
12 August 2024
6 August 2024
14 Juli 2024
Bedienungsanleitung Härten
- Härten Quigg
- Härten Perel
- Härten OneConcept
- Härten Qlima
- Härten Toolland
- Härten Dimplex
- Härten El Fuego
- Härten Faber
- Härten Livin Flame
- Härten Manor House
- Härten Xaralyn
- Härten Dovre
- Härten Blumfeldt
- Härten Hwam
- Härten Napoleon
- Härten DRU
- Härten Edilkamin
- Härten Element4
- Härten Franco Belge
- Härten Global Fires
- Härten Godin
- Härten Haas-Sohn
- Härten Hergom
- Härten Icon Fires
- Härten Italiana Camini
- Härten JAcobus
- Härten Jydepejsen
- Härten K-Stove
- Härten Kago
- Härten Kalfire
- Härten Landmann
- Härten M-design
- Härten Mondena
- Härten Norsk Kleber
- Härten Olsberg
- Härten Ruby Fires
- Härten Saey
- Härten Spartherm
- Härten Stuv
- Härten Thermocet
- Härten Thermorossi
- Härten Wanders
- Härten Well Straler
- Härten Barbas
- Härten Barbecook
- Härten BlackLine
- Härten Altech
- Härten Bellfires
- Härten Bocal
- Härten Austroflamm
- Härten Brunner
- Härten Big Fire
- Härten Boley
Neueste Bedienungsanleitung fĂĽr -Kategorien-
5 Oktober 2024
26 September 2024
23 September 2024
23 September 2024
22 September 2024
20 September 2024
17 September 2024
17 September 2024
16 September 2024
10 September 2024