Brondi FX-400 Twn Bedienungsanleitung

Brondi Babyphone FX-400 Twn

Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Brondi FX-400 Twn (48 Seiten) in der Kategorie Babyphone. Dieser Bedienungsanleitung war fĂĽr 3 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/48
FX-400 professional Twin
PMR446
Private mobile radio
Instruction manual – English
- 2 -
1. LCD Screen
Channel Number. Changes from 1 to 8 as selected by the
user.
CTCSS Code. Changes from 1 to 38 as selected by the user.
Displays the Battery change level. When the bars are
reduced, the battery needs recharging.
TX Displayed when transmitting a signal.
RX Displayed when receiving a signal.
DCM Displayed when the Dual Watch function is turned ON.
VOX Displayed when the VOX feature is enabled.
SC Displays when the PMR is scanning all channels.
Displayed when the Key Lock feature is activated.
Displays the current Speaker volume level.
Displays when the call signal is ON.
Displays when the vibrator function is activated.
Antenna
LC
D Screen
- Displays the
current channel
selection and other
radio symbols.
PTT (PUSH to
TALK) button
–Press and hold to
transmit.
CALL button
-Press to send
ringing tone to
MENU Button
-Press to change
to switch between
m
odes.
Speaker
PWR(POWER)
Button – Press
and hold to turn
the unit ON or
OFF.
MIC (Microphone)
Ear/Mic/Charger
jack
UP/DOWN
Buttons –
Press to change
channels, volume,
and to select
- 3 -
2. Installation
2.1 Removing the Belt Clip
a. Pull the Belt Clip latch forward(away from the
FX-400)
b. While pulling the Belt Clip latch, push up the
Belt Clip as shown in Figure1.
2.2 Installing the Belt Clip
a. Slide the Belt Clip into the slot as shown in
Figure2.
b. A “click” indicates the Belt Clip is locked into
position.
2.3 Installing the Batteries
Caution: Observe the proper battery polarity orientation when installing batteries. Incorrect
positioning can damage both the batteries and the unit.
a. Pull up the battery cover latch, Lift up Battery Compartment Cover.
b. Install the rechargeable batteries by following the orientation as shown in Figure 3 (the
arrow is showing and pointing upward.)
c. Replace the Battery Compartment Cover. See Figure 4.
Important
Read these Safety Warnings before you charge the batteries.
When placing the FX-400 in the charger, use only the rechargeable batteries supplied
with the FX-400.
Don’t try to recharge non-rechargeable batteries.
Make sure the battery compartment cover is securely locked in place when you are
charging the batteries.
Dispose of used batteries safely and in a way that will not harm the environment- never
try to burn them or put them anywhere, they could get burnt or punctured.
Don’t leave dead batteries in your FX-400 units.
They might leak if you do.
Belt Clip latch
Figure 1
Figure 2
Figure 3
Figure 4


Produktspezifikationen

Marke: Brondi
Kategorie: Babyphone
Modell: FX-400 Twn

Brauchst du Hilfe?

Wenn Sie Hilfe mit Brondi FX-400 Twn benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Babyphone Brondi

Bedienungsanleitung Babyphone

Neueste Bedienungsanleitung fĂĽr -Kategorien-