Bosch RDE2124628 Bedienungsanleitung

Bosch Wasserkocher RDE2124628

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Bosch RDE2124628 (20 Seiten) in der Kategorie Wasserkocher. Dieser Bedienungsanleitung war für 6 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/20
6 720 888 208 (2019/10) DIV
Installation instructions
Montaj Kılavuzu
RDE2124628
Table of Contents
RDE2124628 – 6 720 888 208 (2019/10)
2
Table of Contents 1 Safety information
This appliance is intended for domestic use and the
household environment only.
Please read this installation instruction manual
carefully, then act accordingly! Store for future
reference. These installation instructions must be
included when transferring this appliance to a new
owner.
The appliance may only be connected and put
into operation by a qualified professional.
Install and operate the appliance as described in
the text and illustrations. We do not accept liability
for damage resulting from failure to heed these
instructions.
The supplied water connection nozzles must be
used and installed as shown in the supplementary
sheets. Make sure that a check valve is installed in
the cold water supply line.
This appliance is intended for use up to an altitude
of 2,000 m above sea level.
The appliance may only be installed and stored in a
frost-free room (due to residual water).
WARNING:
Risk of electric shock!
Switch off the mains voltage supply immediately if a
fault occurs.
Disconnect the power supply before opening the
appliance.
Immediately shut off the cold water supply to the
appliance should it leak.
These installation instructions are intended for
plumbers, heating engineers and electricians. All
instructions must be observed. Failure to comply with
instructions may result in material damage and
personal injury, including possible loss of life.
Read the installation instructions (heat source,
heating controller, etc.).
Observe the safety instructions and warnings.
Observe national and regional regulations,
technical rules and guidelines.
The statutory regulations of the respective country,
as well as those of the local electricity and water
suppliers, must be adhered to.
The continuous-flow heater is a Class I appliance
and be connected to the protective earth.must
1 Safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
2 Installation instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
2.1 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
3 Technical data. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
4 Special accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
5 Transport . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
6 Environmental protection/disposal. . . . . . . . . . . . . . . . . . . . . 5
Installation instructions
3
6 720 888 208 (2019/10)
CAUTION:
Earthed water pipes may give the appearance
of a connected protective earth.
The appliance must be permanently connected to
installed pipes. The conductor cross-section
must comply with the installed appliance power.
To guarantee compliance to relevant safety
regulations, an all-pole separator must be fitted
during installation. The contact opening must be at
least 3 mm.
Ensure that the inlet water pressure, maximum and
minimum, is according with the value specified by
the manufacturer ( chapter 3).
The cold water supply temperature must not be
higher than 55 °C.
In accordance with EN60335-2-35, when the
appliance is intended to supply water for
showering, the output temperature must be limited
to 55°C.
The continuous-flow heater is only suitable for
closed (pressurised) operation.
The tap and outlet fittings must be approved for
operation with closed (pressurised) continuous-
flow heater systems.
If the output temperature of the water leaving the
tap is higher than the set temperature, then this is
because the supply water temperature from the
domestic system is too hot, e. g. due to its being
heated by a solar energy unit.
The continuous-flow heater can be operated with
cold or pre-warmed water (for example, from a solar
energy unit water supply). Observe the technical
data and the special accessories for this purpose.
The water’s specific electrical resistivity must not
be less than 1,300 Ωcm. Ask the local water utility
company regarding the electrical resistivity of the
water.
The continuous-flow heater is suitable for
connection to DVGW-tested plastic pipes.
Disconnect the electrical connection cable from
the supply and shut off the water supply before
connecting the appliance!
Connect the water supply and then connect
the electrical supply.
Only make the openings which are required for
installation on the rear of the appliance. If the
appliance is reinstalled, the unused openings must
be provided with watertight sealing.
Do not touch electrically live parts after installation.
Do not use aggressive or abrasive cleaning
detergents!
Do not use a steam cleaner.
Repairs must only be carried out by an authorised
technician. Improper repairs can lead to risk of
serious injury to the user.
Safety of electrical devices for domestic use and
similar purposes
The following requirements apply in accordance with
EN 60335-2-35 in order to prevent hazards from
occurring when using electrical appliances:
“This appliance can be used by children of 3 years and
older, as well as by people with reduced physical,
sensory or mental capabilities or lacking in experience
and knowledge, if they are supervised and have been
given instruction in the safe use of the appliance and
understand the resulting dangers. Children shall not
play with the appliance. Cleaning and user
maintenance must not be performed by children
without supervision.”
“If the power cable is damaged, it must be replaced by
the manufacturer, its customer service department or
a similarly qualified person, so that risks are avoided.”
Congratulations on purchasing this BOSCH appliance.
You have acquired a top-quality product, which will
give you a lot of enjoyment.
2 Installation instructions
These installation instructions describe a continuous-flow heater
with AquaStop.
Install the appliance as shown in the illustrations. The illustrations
can be found in the centre of the instruction manual. Observe the
instructions in the text.
2.1 Installation
Unpacking/Removing the cover (Fig. 1)
Unpack the appliance and check for transport damage. If any compo-
nents are damaged, then do not connect the appliance.
Check that your appliance contains all components included in the scope
of delivery: appliance, installation set with supplementary sheets,
installation instructions, operating instructions.
Please dispose of the packaging and the old appliance
in an environmentally-friendly manner.
When removing the cover, please note the following: The cover is
fastened by a central closure behind the service flap.
Preparations for installation (Fig.2)
Important: Only use the supplied installation set. The supplied water
connection nozzles must be installed!
Shut off water supply. The electrical connection (connection cable)
must be disconnected from the power supply. Unscrew the fuse
or switch off the circuit breaker.
Install the water connection nozzles according to the instructions
on the supplementary sheet.


Produktspezifikationen

Marke: Bosch
Kategorie: Wasserkocher
Modell: RDE2124628

Brauchst du Hilfe?

Wenn Sie Hilfe mit Bosch RDE2124628 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Wasserkocher Bosch

Bedienungsanleitung Wasserkocher

Neueste Bedienungsanleitung für -Kategorien-