Baumr-AG Hercules HPS2600E Bedienungsanleitung

Baumr-AG Holzspalter Hercules HPS2600E

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Baumr-AG Hercules HPS2600E (19 Seiten) in der Kategorie Holzspalter. Dieser Bedienungsanleitung war für 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/19

User Manual

[Revision 6 ].0 July 2022

READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY

DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by

this manual may vary in appearance, assembly, inclusions, specifications, description and packaging.

Electric Log Splitter - HPS2600E

E&OE © -AG 2 2022 Baumr

Safety

Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or

equipment or property damage if not understood or followed. Safety messages have the following symbols:

You WILL be KILLED or

SERIOUSLY INJURED if you do

not follow instructions.

You CAN be KILLED or

SERIOUSLY INJURED if you do

not follow instructions.

You CAN be INJURED if you do

not follow instructions or equipment

d amage may occur.

It is vital that you read and understand this

user manual before using the product,

including safety warnings, and any assembly

and operating instructions. Keep the manual

for future reference.

Safety precautions and recommendations

detailed here must be fully understood and

followed to reduce the risk of injury, fire,

explosion, electrical hazard, and/or property

damage.

Safety information presented here is generic

in nature some advice may not be –

applicable to every product. The term

"equipment" refers to the product, be it

electrical mains powered, battery powered or

combustion engine powered.

• - Before Use If you are not familiar with the

safe operation/handling of the equipment or

are in any way unsure of any aspect of

suitability or correct use for your

application, you should complete training

conducted by a person or organization

qualified in safe use and operation of this

equipment, including fuel/electrical handling

and safety.

• Do NOT operate the equipment in

flammable or explosive environments, such

as in the presence of flammable liquids,

gases or dust. The equipment may create

sparks or heat that may ignite flammable

substances.

• Keep clear of moving parts.

• Equipment may be a potential source of

electric shock or injury if misused.

• Do NOT operate the equipment if it is

damaged, malfunctioning or is in an

excessively worn state.

• Do NOT allow others to use the equipment

unless they have read this manual and are

adequately trained.

• - risk Keep packaging away from children

of suffocation! Operators must use the

equipment correctly. When using the

equipment, consider conditions and pay

due care to persons and property.

General Work Area Safety

• Work areas should be clean and well it.

• Do not operate the equipment if

bystanders, animals etc are within

operating range of the equipment or the

general work area.

• If devices are provided for connecting dust

extraction / collection facilities, ensure

these are connected and used properly.

Dust collection can reduce dust-related

hazards.

General Personal Safety

• Wear appropriate protective equipment

when operating, servicing, or when in the

operating area of the equipment to help

protect from eye and ear injury, poisoning,

burns, cutting and crush injuries. Protective

equipment such as safety goggles,

respirators, non slip safety footwear, hard -

hat, hearing protection etc should be used

for appropriate equipment / conditions.

Other people nearby should also wear

appropriate personal protective equipment.

Do not wear loose clothing or jewellery,

which can be caught in moving parts. Keep

hair and clothing away from the equipment.

• Stay alert and use common sense when

operating the equipment. Do not over-

reach. Always maintain secure footing and

balance.

• Do not use the equipment if tired or under

the influence of drugs, alcohol or

medication.

• This equipment is not intended for use by

persons with reduced physical, sensory or

mental capabilities.

General Fuel Safety

• Petrol/fuel/gasoline is extremely flammable

– keep clear of naked flames or other

ignition sources.

• Do not spill fuel. If you spill fuel, wipe it off

the equipment immediately if fuel gets on –

your clothing, change clothing.

• Do NOT smoke near fuel or when

refuelling.

• Always shut off the engine before

refuelling.

• Do NOT refuel a hot engine.

• Open the fuel cap carefully to allow any

pressure build up in the tank to release -

slowly.

• Always refuel in well ventilated areas.

• Always check for fuel leakage. If fuel

leakage is found, do not start or run the

engine until all leaks are fixed.

General Carbon Monoxide Safety-

• Using a combustion engine indoors CAN

KILL IN MINUTES. Engine exhaust

contains carbon monoxide - – a poison you

cannot smell or see.

• Use combustion engines OUTSIDE only,

and far away from windows, doors and

vents.

General Equipment Use and Care

• The equipment is designed for domestic

use only.

• Handle the equipment safely and carefully.

• Before use, inspect the equipment for

misalignment or binding of moving parts,

loose components, damage or any other

condition that may affect its operation. If

damaged, have the equipment repaired by

an authorised service centre or technician

before use.

• Prevent unintentional starting of the

equipment - ensure equipment and power

switches are in the OFF position before

connecting or moving equipment. Do not

carry equipment with hands or fingers

touching any controls. Remove any tools or

other items that are not a part of the

equipment from it before starting or

switching on.

• Do not force the equipment. Use the

correct equipment for your application.

Equipment will perform better and be safer

when used within its design and usage

parameters.

• Use the equipment and accessories etc. in

accordance with these instructions,

considering working conditions and the

work to be performed. Using the equipment

for operations different from those intended

could result in hazardous situations.

• Always keep equipment components

(engines, hoses, handles, controls, frames,

housings, guards etc) and accessories

(cutting tools, nozzles, bits etc) properly

maintained. Keep the equipment clean and,

where applicable, properly lubricated.

• Store the equipment out of reach of

children or untrained persons. To avoid

burns or fire hazards, let the equipment

cool completely before transporting or

storing. Never place or store the equipment

near flammable materials, combustible

gases or liquids etc.

• -The equipment is not weather proof, and

should not be stored in direct sunlight, at

high ambient temperatures or locations that

are damp or humid.

• Do not clean equipment with solvents,

flammable liquids or harsh abrasives.

• For specific equipment safety use and care,

see Equipment Safety.

Electric Log Splitter - HPS2600E

E&OE © -AG 3 2022 Baumr

General Electrical Safety

• Inspect electrical equipment, extension

cords, power bars, and electrical fittings for

damage or wear before each use. Repair or

replace damaged equipment immediately.

• Ensure all power sources conform to

equipment voltage requirements and are

disconnected before connecting or

disconnecting equipment.

• When wiring electrically powered

equipment, follow all electrical and safety

codes.

• Wherever possible, use a residual current

device (RCD).

• High voltage / high current power lines may

be present. Use extreme caution to avoid

contact or interference with power lines.

Electrical shock can be fatal.

General Electrical Safety

• Electrically grounded equipment must have

an approved cord and plug and be

connected to a grounded electrical outlet.

• Do NOT bypass the ON/OFF switch and

operate equipment by connecting and

disconnecting the electrical cord.

• Do NOT use equipment that has exposed

wiring, damaged switches, covers or

guards.

• Do NOT use electrical equipment in wet

conditions or in damp locations.

• Do NOT use electrical cords to lift, move or

carry equipment.

• Do NOT coil or knot electrical cords, and

ensure electrical cords are not trip hazards.

General Service Information

• The equipment must be serviced or

repaired at authorised service centres by

qualified personnel only.

• Replacement parts must be original

equipment manufacturer (OEM) to ensure

equipment safety is maintained.

• Do NOT attempt any maintenance or repair

work not described in this manual.

• After use, the equipment and components

may still be hot allow the equipment to –

cool and disconnect spark plugs and/or

electrical power sources and/or batteries

from it before , changing adjusting

accessories or performing repair or

maintenance.

• Do NOT adjust while the equipment is

r unning.

• Perform service related activities in suitable

conditions, such as a workshop.

• Replace worn, damaged or missing

warning/safety labels immediately.

LOG SPLITTER SAFETY

UNDERSTAND YOUR LOG SPLITTER. Read and understand the owner's manual and labels affixed to the log splitter. Learn its application and

limitations as well as the specific potential hazards peculiar to it

DRUGS, ALCOHOL AND MEDICATION. Do not operate the log splitter while under the influence of drugs, alcohol, or any medication that could

affect your ability to use it properly.

AVOID DANGEROUS CONDITIONS. Put the log splitter on a 60 75cm high, stable, flat, and level work bench where there is plenty of room for -

handling, and help the operator stay alert. Bolt the log splitter to the work surface if it tends to slip, walk, or slide. Keep your work area clean and

well lighted. Cluttered areas invites injuries. Do not use the log splitter in wet or damp areas or expose it to rain. Do not use it in areas where fumes

from paint, solvents or flammable liquids pose a potential hazard.

INSPECT YOUR LOG SPLITTER. Check your log splitter before turning it on. Keep guards in place and in working order. Form a habit of checking

to see that keys and adjusting wrenches are removed from tool area before turning it on. Replace damaged, missing or failed parts before using it.

DRESS PROPERLY. Do not wear loose clothing, gloves, neckties or jewellery (rings, wristwatches). They can be caught in moving parts. Protective

electrically nonconductive gloves and non skid footwear are recommended when working. Wear protective hair covering to contain long hair, -

preventing it from get caught in machinery.

PROTECT YOUR EYES AND FACE. Any log splitter may throw foreign objects into the eyes. This can cause permanent eye damage. Always wear

safety goggles. Everyday eyeglasses have only impact resistant lenses. They are not safety glasses. Do not put the log splitter on the ground for

operations. This is awkward operating position that the operator has to bring his face close to the machine, and thus risks being struck by wood

chips or debris.

EXTENSION CORDS. Improper use of extension cords may cause inefficient operation of the log splitter which can result in overheating. Be sure

the extension cord is no longer than 1 Om and its section is no less than 2.5mm2 to allow enough current flow to the motor. Avoid use of free and

inadequately insulated connections. Connections must be made with protected material suitable for outdoor use.

AVOID ELECTRICAL SHOCK. Check that the electric circuit is adequately protected and that it corresponds with the power, voltage and frequency

of the motor. Check that there is a ground connection, and a regulation differential switch upstream. Ground the log splitter Prevent body contact .

with grounded surfaces: pipes, radiators, ranges, and refrigerator enclosures. Never open the pushbutton box on the motor. Should this be

necessary, contact a qualified electrician. Mark sure your fingers do not touch the plug's metal prongs when plugging or unplugging the log splitter.

KEEP VISITORS AND CHILDREN AWAY. The log splitter must always be operated by one person only. Other people should keep a safe distance

from the work area, especially when the log splitter is operating. Never ask other people to help you with freeing a jammed log.

INSPECT YOUR LOG. Make sure there are no nails or foreign objects in the logs to be split. The ends of the logs must be cut square. Branches

must be cut of flush with the trunk.

DON’T OVERREACH. Floor must not be slippery. Keep proper footing and balance at all times. Never stand on log splitter. Serious injury could

occur if the tool is tipped or if the cutting tools is unintentionally contacted. Do not store anything above or near the log splitter where anyone might

stand on the tool to reach them.

AVOID INJURY FROM UNEXPECTED ACCIDENT. Always pay full attention to the movement of the log pusher. Do not attempt to load the log on

until the log pusher has stopped. Keep hands out of the way of all moving parts.

PROTECT YOUR HANDS. Keep your hands away from splits and cracks which open in the log. They may close suddenly and crush or amputate

your hands. Do not remove jammed logs with your hands.

DON'T FORCE THE TOOL. It will do a better and safer job at its design rate. Never try to split logs larger than those indicated in the specifications

table. This could be dangerous and may damage the machine. Don’t use log splitter for a purpose for which it was not intended.

NEVER LEAVE TOOL RUNNING UNATTENDED. Don't leave tool until it has come to a complete stop.

DISCONNECT POWER. Unplug when not in use, before making adjustments, changing parts, cleaning, or working on the log splitter; Consult

technical manual before servicing.