Avanti HRS10321B Bedienungsanleitung
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Avanti HRS10321B (4 Seiten) in der Kategorie Gewölbe. Dieser Bedienungsanleitung war für 6 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/4
MODEL HRS10321B
SECURITY SAFE
INSTALLATION AND USAGE INSTRUCTIONS
Your Avanti Room Security Safe is supplied with the following:
1 – Security Safe Unit
2 – Emergency Access Keys
1 – Installation / Usage Guide
1 – Felt Liner
Installation Screw Kit
4 – Rubber Feet
INSTALLING YOUR SECURITY SAFE
When installing your safe, be sure the location is sturdy enough to support the unit and is both
secure and easy to access.
Safe can be installed onto either a concrete or wooden surface.
When installing use a 25/64” (10mm) drill bit and screws.
To prevent removal of your security safe, it is recommended to use Allen type screws (not included)
to affix the unit to the installation location.
INITIAL SETUP AND CONFIGURATION.
After you have installed the unit in its final location, proceed to set up digital access controls.
1) Using the emergency Access Key, open the safe.
2) Open the battery compartment cover.
3) Following the image shown in the battery compartment install 4 AA sized batteries.
4) Close the battery compartment cover.
5) Using the keypad, enter the initial setup password “1234” or the administrator password
“888888”.
NOTE:
Battery Life / Level: Always replace all of the batteries at the same time. If at any time the battery
level is too low to operate the security safe, use the emergency access key.
Safety / Security Feature: If the passcode is entered incorrectly more than 3 times the keypad will
go into lock mode. After approximately (1 5) fifteen minutes the keypad will return to normal
working function.
Interior Light: When the safe is unlocked using the keypad, the interior light will turn on and will
turn off automatically after approximately 30 seconds.
Automatic Door Opening: When the safe is unlocked using the keypad the door will automatically
open slightly outward to allow easy / quick access to contents stored in the safe.
RESETTING THE ADMINISTRATOR PASSWORD
To reset the access code read and follow the steps below.
1) With the door open, press the “ ” s,Clear key twice, the Yellow Light flashe enter old master code
(default “ ”8-8-8-8-8-8 )
2) one acoustic signals ( will come (It“beep”) ’s mean old master code is right, if old master code is
wrong, three beep beep beep acoustic signals (“ ” “ ” “ ”) will come), enter a new master code of 6 digits ,
one aco ustic signals (“beep”) will come.
3) Re long - inter the new master code, the Green Light flashes and one acoustic signals (“beep~ )”,
indicates new master code changed successfully.
GUEST / USER CODE SETUP
To reset the access code read and follow the steps below.
1) With the door CLOSED, enter a new 3 – 6 digit code and press the “LOCK” key to confirm the new
pass code.
2) You will hear and see the security lock engage.
3) Enter the new pass code to open the security safe.
4) Close the door and enter the new code set up in step # 1 and press the “LOCK” key.
5) If the Guest / User enters the wrong pass code three (3) times in a row the keypad will go into
security-lock mode and will remain locked for approximately (1 (15) fifteen minutes. After the 5)
f ifteen minutes has elapsed the keypad will return to normal operation.
Avanti Products
Miami, FL 33172
In the event of service is sues, please call the
Customer Hotline at 1-800 220 5570– -
Additional Instructions:
Manual Operation (Open using the key).
• User will need to remove the key hole cover by peeling away the key hole cover label.
• Insert the emergency access key into the lock and turn clockwise to open the safe.
• While the door is open, change the batteries on the control panel
Battery Override ( 9 Volt Square battery required)
In the even the batteries are low or need to be changed, you can open the unit either manually by using the
access key or via external battery supply.
Using a 9 Volt square battery, touch the batter terminals to the two round metal pads on the front of the control
to give temporary power to the controls.
While the battery is in place, enter the preset passcode and the door will open giving you access to the safe
and the battery compartment.
Avanti Products
Miami, FL 33172
In the event of service issues, please call the
Customer Hotline at 1-800 220 5570– -
Produktspezifikationen
| Marke: | Avanti |
| Kategorie: | Gewölbe |
| Modell: | HRS10321B |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Avanti HRS10321B benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Gewölbe Avanti
9 August 2024
6 August 2024
Bedienungsanleitung Gewölbe
- Gewölbe Hama
- Gewölbe Philips
- Gewölbe Guzzanti
- Gewölbe Thule
- Gewölbe Conrad
- Gewölbe FERM
- Gewölbe Topcraft
- Gewölbe Dometic
- Gewölbe Abus
- Gewölbe Olympia
- Gewölbe Yale
- Gewölbe Perel
- Gewölbe Workzone
- Gewölbe Westfalia
- Gewölbe Burg Wächter
- Gewölbe Honeywell
- Gewölbe Filex
- Gewölbe First Alert
- Gewölbe Master Lock
- Gewölbe Phoenix
- Gewölbe Rottner
- Gewölbe Salvus
- Gewölbe SentrySafe
- Gewölbe Juwel
- Gewölbe Toolland
- Gewölbe Kidde
- Gewölbe Royal Sovereign
- Gewölbe SereneLife
- Gewölbe Sygonix
- Gewölbe Fluke
- Gewölbe VARO
- Gewölbe Duralock
- Gewölbe EasySafe
- Gewölbe Fichero
- Gewölbe FireKing
- Gewölbe Jewel
- Gewölbe Kreator-Varo
- Gewölbe M-Locks
- Gewölbe Nauta
- Gewölbe Oxloc
- Gewölbe Protector
- Gewölbe ROMA
- Gewölbe Sentry
- Gewölbe Sistec
- Gewölbe SMC
- Gewölbe Steren
- Gewölbe Technomax
- Gewölbe Olymp
- Gewölbe Challenge
- Gewölbe Suncast
- Gewölbe Kreator
- Gewölbe Barska
- Gewölbe NOFIRE
- Gewölbe Homak Security
- Gewölbe CAWI
- Gewölbe Rottner Tresor
- Gewölbe Winholt
- Gewölbe Stamony
Neueste Bedienungsanleitung für -Kategorien-
16 Oktober 2024
15 Oktober 2024
15 Oktober 2024
15 Oktober 2024
5 Oktober 2024
5 Oktober 2024
2 Oktober 2024
2 Oktober 2024
2 Oktober 2024
2 Oktober 2024