AstralPool Silkflow waterfall Bedienungsanleitung
AstralPool
Schwimmbad
Silkflow waterfall
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für AstralPool Silkflow waterfall (17 Seiten) in der Kategorie Schwimmbad. Dieser Bedienungsanleitung war für 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/17
Astral Pool Silkflow Waterfall
Cascada Silkflow de Astral Pool
Chute d’eau Silkflow Astral Pool
Cascata a getto liscio
Astral Pool Silkflow Wasserfall
INSTALLATION & OPERATING INSTRUCTIONS
INSTALACIÓN E INSTRUCCIONES DE FUNCIONAMIENTO
INSTALLATION ET MODE D’EMPLOI
ISTRUZIONI DI INSTALLAZIONE ED USO
INSTALLATIONS- & BETRIEBSANLEITUNG
Rev 180-0509 EUR
Waterfalls Rev 180-0509 EUR
Page 2
INTRODUCTION
Congratulations on your purchase of an Astral Pool Waterfall. Proper installation will ensure many years
of trouble free use and enjoyment.
INSTALLATION
A dedicated plumbing line is recommended for all waterfalls. It is recommended that 50mm PVC pipe be
used for all installations and must be used where the required ow rate exceeds 200 ltr/min or the total
pipe length exceeds 20 metres. The waterfall must be installed before the deck and coping is laid.
It is essential that a filter is plumbed in line with the water fall pump to prevent debris from
entering the waterfall and blocking the water exit of the waterfall.
NOTE: If the Waterfall is not level when installed the water flow will be un-even!
Ensure that the Grout Guard is in place at all times during Installation.
1. It is recommended that 50mm pipe is used for all installations.
2. Make a notch, cutout or penetration in the mounting wall face 20mm longer than the
length of the waterfall.
3. When installing waterfalls in sprayed concrete or brick walls, do not tie the waterfall to
the Reinforcing Steel or spray in the concrete as the waterfall body can be distorted as
the concrete dries and cause internal damage due to excessive stressing and
movement. It is recommended to provide a penetration using polystyrene or wood,
allowing for connection of the pipe work at rear. The Waterfall can then be installed at a
later date once the wall has set.
WATERFALLS ARE NOT DESIGNED TO TAKE HEAVY WHEIGHTS AND IF THEY
ARE NOT SUPPORTED PROPERLY CAN SERIOUSLY AFFECT THE OVERALL
PERFORMANCE.
4. Knock out the penetration and place the waterfall in the notch, cutout or penetration
made on the mounting surface leaving a 10mm gap at each end.
NOTE: Extended lip models must be sufficiently supported.
5. Level the waterfall, using packers where necessary.
6. Ensure the waterfall lip edge will be flush with the finished wall surface.
7. Fill in the area below and in the back with mortar.
8. To ensure the waterfall stays in a level position while the mortar is setting place a piece
of wood over the waterfall. Then use bricks or heavy objects placed on top of the wood
to allow even weight distribution.
9. Once the mortar is set remove the wood and heavy objects to complete the installation.
GROUT GUARD
The Grout guard is to protect the waterfall outlet from dirt, dust, mortar and debris while it is been
installed.
Waterfalls Rev 180-0509 EUR
Page 3
PUMP SELECTION.
Below is a guide as to the pump size required to operate your waterfall efficiently and effectively.
PUMP SIZE (Approximate) for WATERFALLS
Silkflow Waterfall
Length
Required Water Flow - ltr/min/m Typical Pump Size – Hp
300mm 50 0.50
600mm 100 0.50
900mm 150 0.75
1200mm 200 0.75
Flow Control
A two way valve must be installed on the outlet of the waterfall pump in an accessible area to control
the amount of water that exits the waterfall. It will also reduce the risk of damage on start up. Have the
valve half open on start up and reduce or increase depending on the desired waterfall effect you wish to
achieve.
Waterfalls naturally become narrower as they fall. Below is a recommended guide for the height your
waterfall should be installed above the water surface.
A – Waterfall
Length
B – Waterfall Width
at Pool Surface at
Recommended
ltr/min/m
C – Recommended
Waterfall Height
D – Water Distance
at Recommended
ltr/min/m
300mm 200mm 300mm 300mm
600mm 500mm 600mm 300mm
900mm 800mm 900mm 300mm
1200mm 1100mm 900mm 300mm
1800mm 1700mm 900mm 300mm
2400mm 2300mm 900mm 300mm
Produktspezifikationen
| Marke: | AstralPool |
| Kategorie: | Schwimmbad |
| Modell: | Silkflow waterfall |
Brauchst du Hilfe?
Wenn Sie Hilfe mit AstralPool Silkflow waterfall benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Schwimmbad AstralPool
16 August 2024
16 August 2024
15 August 2024
15 August 2024
14 August 2024
14 August 2024
10 August 2024
10 August 2024
8 Juli 2024
29 Januar 2024
Bedienungsanleitung Schwimmbad
- Schwimmbad Hayward
- Schwimmbad Gre
- Schwimmbad Bestway
- Schwimmbad Intex
- Schwimmbad Jilong
- Schwimmbad Orilux
- Schwimmbad POLARIS
- Schwimmbad Uniprodo
- Schwimmbad Maytronics
- Schwimmbad Avenli
Neueste Bedienungsanleitung für -Kategorien-
16 Oktober 2024
16 Oktober 2024
16 Oktober 2024
5 Oktober 2024
3 Oktober 2024
22 September 2024
19 September 2024
5 September 2024
5 September 2024
5 September 2024