APC SRTG192XLBP4 Bedienungsanleitung
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für APC SRTG192XLBP4 (28 Seiten) in der Kategorie UPS. Dieser Bedienungsanleitung war für 5 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/28
Important Safety Instructions
Read the instructions carefully and look at the equipment to become familiarse
with the device before trying to
install, operate, service or maintain it. The
following special messages may appear throughout this document or on
the
equipment to warn of potential hazards or to call attention to information that
clarifies or simplies a procedure.
The addition of this symbol to either Danger or Warning safety label indicates a “ ” “ ”
that an electrical hazard exists which will
result in personal injury if the instructions
are not followed.
This is the safety alert symbol. It is used to alert you to potential
personal injury
hazards. Obey all safety messages that follow
this symbol to avoid possible injury or
death.
DANGER
DANGER will result inindicates a hazardous situation which, if not avoided, death or serious injury.
WARNING
WARNING
indicates
a
hazardous
situation
which,
if
not
avoid ,ed
coul r ultd es
in
death
or
serious
injury.
CAUTION
CAUTION
i icatesnd
a
hazard sou
sit tionua
which,
if
not
avoi ,ded
c l r ultou d es
in
mi rno
or
moderate
injury.
NOTICE
NOTICE
is
used
to
address
practices
not
related
to
ph alysic
injury.
Product Handling Guidelines
Installation Guide Smart-UPS
™
RT
External Battery Module SRTG192XLBP4
2 Smart-UPS External Battery Module SRTG192XLBP4 RT
Safety and General Information
•
Adhere to all national and local electrical codes.
•
Changes and modications to this unit not expressly approved by APC by Schneider Electric could void the
warranty.
•
This unit is intended only for indoor use in a controlled environment.
•
Do not operate this unit in direct sunlight, in contact with uids, or where there is excessive dust or humidity.
•
Be sure the air vents on the unit are not blocked. Allow adequate space for proper ventilation.
•
Before installing or replacing the batteries, remove jewelry such as wristwatches and rings. High, short circuit
current through conductive materials could cause severe burns.
•
The battery typically lasts for two to five years. Environmental factors impact battery life.
•
Elevated ambient temperatures, poor quality mains power, and frequent short duration discharges will shorten
battery life.
•
The equipment is heavy. Always practice safe lifting techniques adequate for the weight of the equipment.
•
The batteries are heavy. Remove the batteries before installing UPS and external battery modules in a rack.the
•
Always install XLBPs at the in the bottom rack-mount congurations. The UPS must installed above be
XLBPs.
•
Do not dispose of batteries by burning them. The batteries may explode.
•
Do not open or mutilate batteries. Released electrolyte is harmful to the skin and eyes, and may be toxic.
•
Always recycle used batteries.
•
Recycle the package materials or save them for reuse.
•
Additional safety information can be found in the Safety Guide supplied with this unit.
•
A battery can present a risk of electric shock and burns by high short-circuit current.
•
Failed batteries can reach temperatures that exceed the burn thresholds for touchable surfaces.
Battery safety
CAUTION
R
R
R
RRIS
IS
IS
ISISK
K
K
KK
O
O
O
OOF
F
F
FF
FA
FA
FA
FAFAL
L
L
LLL
L
L
LLIN
IN
IN
INING
G
G
GG
O
O
O
OOB
B
B
BBJ
J
J
JJE
E
E
EEC
C
C
CCT
T
T
TTS
S
S
SS
•
Each battery module weighs 16.5 (36.4 lb). kg
•
Always practice safe lifting techniques adequate for the weight of the equipment.
•
Remove the battery modules before installing the XLBP.
•
Use the battery module handle to carefully slide the battery modules in or out of the XLBP.
•
Do not use the battery module handle to lift or carry the battery module.
Failure to f
Failure to f
Failure to f
Failure to fFailure to follow these instr
ollow these instr
ollow these instr
ollow these instrollow these instructions ca
uctions ca
uctions ca
uctions cauctions can result in equi
n result in equi
n result in equi
n result in equin result in equipment dam
pment dam
pment dam
pment dampment dama
a
a
aage and minor or m
ge and minor or m
ge and minor or m
ge and minor or mge and minor or moderate injury.
oderate injury.
oderate injury.
oderate injury.oderate injury.
CAUTION
R
R
R
RRIS
IS
IS
ISISK
K
K
KK
O
O
O
OOF
F
F
FF H
H
H
H HYD
YD
YD
YDYDR
R
R
RRO
O
O
OOG
G
G
GGEN
EN
EN
ENEN
S
S
S
SSU
U
U
UULP
LP
LP
LPLPH
H
H
HHID
ID
ID
IDIDE
E
E
EE G
G
G
G GA
A
A
AAS
S
S
S S A
A
A
AAN
N
N
NND
D
D
DD E
E
E
E EX
X
X
XXC
C
C
CCE
E
E
EES
S
S
SSS
S
S
SSIV
IV
IV
IVIVE
E
E
E E S
S
S
SSM
M
M
MMO
O
O
OOK
K
K
KKE
E
E
EE
•
Replace the battery at least every 5 years at the end of its service life, whichever is earlier. or
•
Replace the battery immediately when the UPS indicates battery replacement is necessary.
•
Replace batteries with the same number and type of batteries as originally installed in the equipment.
•
Replace the battery immediately when the UPS indicates a battery over-temperature condition, or when there is evidence of
electrolyte leakage. Power off the UPS, unplug it from the AC input, and disconnect the batteries. Do not operate the UPS until the
batteries have been replaced.
•
*Replace all battery modules (including the modules in External Battery Packs) which are older than one year, when installing
additional battery packs or replacing the battery module(s).
Failure to f
Failure to f
Failure to f
Failure to fFailure to follow these instr
ollow these instr
ollow these instr
ollow these instrollow these instructions ca
uctions ca
uctions ca
uctions cauctions can result in
n result in
n result in
n result inn result in minor or
minor or
minor or
minor or minor or moderate injury
moderate injury
moderate injury
moderate injurymoderate injury and equipme
and equipme
and equipme
and equipme and equipment damage.
nt damage.
nt damage.
nt damage.nt damage.
* Contact APC by Schneider Electric Worldwide Customer Support to determine the age of the installed battery modules.
Smart-UPS
External Battery Module SRTG192XLBP4 3 RT
Package Contents
Inspect the contents upon receipt. Notify the carrier and dealer if there is damage.
Included with all models
Front bezel
M5 Floating nut to secure
the battery pack to the rack
（
x4
）
M4x6 at head screws to
secure the rack-mount
brackets to the UPS.
（
x4
）
M5x12 Phillips at head
screw to secure the XLBP
to the rack
（
x4
）
Battery connector holder
（
x1
）
Ground cable 0.74 m
（
x1
）
Battery wire 0.64 m
Connect UPS and battery
pack
(x1)
Stabilizer bracket
connectors
（ ）x6
S
tabilizer bracket
（
x2 pairs
）
Rack-mount brackets
（
x1pair
）
Installation manual
（
x1
）
Packing list
（
x1
）
Change the connector holder the battery cable to connect one battery pack to another battery packof
❶ Remove the screw and
connector
holder.
❷ Change the connector holder.
❸ Secure the
connector holder
with screws 2
Produktspezifikationen
| Marke: | APC |
| Kategorie: | UPS |
| Modell: | SRTG192XLBP4 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit APC SRTG192XLBP4 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung UPS APC
13 Oktober 2024
13 Oktober 2024
13 Oktober 2024
13 Oktober 2024
13 Oktober 2024
13 Oktober 2024
13 Oktober 2024
13 Oktober 2024
5 Oktober 2024
3 Oktober 2024
Bedienungsanleitung UPS
- UPS Approx
- UPS Gembird
- UPS HP
- UPS Voltcraft
- UPS AEG
- UPS Siemens
- UPS IKEA
- UPS Dell
- UPS LC-Power
- UPS Tripp Lite
- UPS GYS
- UPS Adj
- UPS Block
- UPS Digitus
- UPS CyberPower
- UPS Eaton
- UPS EnerGenie
- UPS Emerson
- UPS Furman
- UPS Riello
- UPS Puls Dimension
- UPS Avocent
- UPS Atlantis Land
- UPS Vanson
- UPS Phoenix Contact
- UPS Minuteman
- UPS V7
- UPS Equip
- UPS Salicru
- UPS SurgeX
- UPS Bxterra
- UPS Altronix
- UPS FSP
- UPS Ditek
- UPS PowerWalker
- UPS FSP/Fortron
- UPS East
- UPS Liebert
- UPS Murr Elektronik
- UPS Online USV
Neueste Bedienungsanleitung für -Kategorien-
11 Oktober 2024
9 Oktober 2024
9 Oktober 2024
4 Oktober 2024
3 Oktober 2024
3 Oktober 2024
3 Oktober 2024
3 Oktober 2024
3 Oktober 2024
2 Oktober 2024