Andrews Polar Wind Portable Bedienungsanleitung

Andrews Klimaanlage Polar Wind Portable

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Andrews Polar Wind Portable (4 Seiten) in der Kategorie Klimaanlage. Dieser Bedienungsanleitung war für 15 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/4
Click www.andrews-sykes.com
or Call Us Free 0800 211 611
Polar Wind
Portable Air Conditioning
Operating Instructions
& Safety Guide
Maintenance
Disconnect from the electrical supply before any cleaning or
maintenance.
DO not use chemical solvents to clean the surface of the unit. Use
a clean damp cloth.
Check the filter every week. (fig. 4).
Remove the air filter, the element may be vacuumed clean or
washed in a neutral warm water and detergent mix (40°C).
Rinse and dry the filter before replacing.
Do not dry in direct sunlight.
Laying Up
1.) Clean filter
2.) Clean surfaces
3.) Drain water from the unit
Please note water will drain from the low level water drain (Fig 5) when
the stopper is removed. Run in fan mode until the pipe is dry.
DO NOT DO THIS ON ANY INDOOR FLOOR SURFACES!
4.) When the unit is clean and drained, store in a clean, dry area. Stow cable.
The unit may be covered.
Getting started and operation
Never operate the unit in very hot or cold conditions - it works properly at
temperatures between 17 and 30º C.
Always allow the unit to stand/settle for 15 minutes before switching on when
either setting up or restarting.
Put the mobile air conditioner in a flat location where the air outlets cannot be
covered up. Place the unit no less than 50cm away from a wall or other obstacle
Fit the square end of the exhaust duct to the exhaust terminal of the unit. Fig 1.
Put the other end (discharge) to the nearest window. The length of the air
exhaust between 600mm - 1800mm. Use the min length when working.
When mounting, try to keep the air exhaust horizontal , sloping up or down.
Never operate if the hose is kinked or sagging (fig. 2 & 3).
If mounting through wall, the height of the hole should be 40cm - 130cm.
General Safety
Keep children and animals away from air conditioning units.
Never leave them alone in a room where the units in use.
This equipment should only be used by a competent person who
has read and understood these instructions.
Never operate this equipment if you are ill, feeling tired or under the
influence of alcohol or drugs.
Keep the Air Conditioning vents clear of all obstructions.
Never put anything on top of the unit or block the air outlets.
Make sure equipment is switched off and unplugged after use
Never leave switched on or unattended.
Do not use the unit where sunlight is shining directly onto it.
Check condition of equipment before use. If unit is showing signs of
damage contact your supplier immediately.
Electrical Safety
This unit requires a 230 volt electrical supply. It plugs into a standard BS1363
domestic socket.
Always inspect plugs and leads for damage before plugging into the supply -
DO NOT USE IF ANY DAMAGE IS FOUND
Ensure cables are run as not to cause a hazard.
If an extension lead is used, ensure it is of the correct standard , and fully
uncoiled when being used.
Do not lay electrical cables in wet / damp areas.
Do not move equipment whilst operating.
Do not pull equipment by its cable.
It is recommended that electrical equipment is used via a suitable RCD.
Operating Instructions - Polar Wind
Click www.andrews-sykes.com 0800 211 611or Call Us Free
Dehumidifying and Cooling Operations
1. The operating range for dehumidifying is 10°C-30ºC (50°F-86°F) and the
operating range for cooling operating is 17°C-30°C (63°F-86°F).
2. If the cooling or dehumidifying operations have been switched off and need
switching on again in a short time, allow approximately three minutes for the
cooling or dehumidifying operations to resume.
3. Make sure the water pump drain hose is correctly connected to the unit.
Cooling Operation
1. Operating temperature range: 17ºC-30°C (63°F-86°F)
2. Press the button several times until the indicator light comes on.
3. Press the buttons to select your desired room temperature.
4. Press the button to choose the fan speed.
Dehumidifying Operation
1. Operating temperature range: 13°C-32°C (55°F-90°F)
2. Press the button several times until the indicator light comes on.
3. The fan will run at a fixed speed at this setting.
4. Keep windows and doors dosed for the best dehumidifying effect.
5. Do not put the duct to window.
Fan Operation
1. Press the button several times until the indicator light comes on.
2. Press the button to choose the fan speed.
3. Do not put’the duct to window.
Timer Operation
1. Press the button when the air conditioner is off. Select the time you
need the unit to start to operate.
2. The Operation paned window will display “On”.
3. The starting time is adjustable from 00.00 to 24.
Setting the off timer:
1. Press the button when the air conditioner is on. Select the time you
need the unit to turn off. The Operation Panel Window will display “Off”.
2. The turning off time is adjustable from 0.00 to 24
Water Pump Drainage
Connect the water pump drain hose to the unit before operate. When the water
level of the internal water tank reaches a predetermined level, the water pump will
be activated and drain the condensed water outside through the connected drain
hose. (Under this condition, attach the rubber bung to the back hole to prevent
continuous drainage.) Fig. 4
Continuous Drainage
When you plan to leave this unit unused for a long time, remove the rubber bung
from the back hole and attach a section of the continuous drain hose connector.
All the water In the water tank will drain outside through the drain hose. (Under
this condition, the water pump is not activated). Fig. 5.
DIGITAL DISPLAY
FAN SPEED
Indication lights.
COOL/DRY/FAN indicator
Press this button will choose
high, middle or low speed of air
delivery.
TEMP SETTING buttons
This button sets the present time
and timer.
TIMER ON/OFF buttons
Program the timer on/off function
FAN SPEED button
Indication light.
WATER FULL
Indication light.
ON/OFF button
Pressing this button will turn the
machine on or off.
MODE button
Pressing this button will turn the
machine on or off.
POWER
Indication light.
INFRA RED RECEIVER
Fig.4
Filter
Drain Water pump drain
Fig.5
Fig.1
Fig.3
Fig.2
Operating Controls

Produktspezifikationen

Marke: Andrews
Kategorie: Klimaanlage
Modell: Polar Wind Portable

Brauchst du Hilfe?

Wenn Sie Hilfe mit Andrews Polar Wind Portable benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Klimaanlage Andrews

Andrews

Andrews PAC 14 Bedienungsanleitung

7 Juli 2024
Andrews

Andrews PAC15 Bedienungsanleitung

7 Juli 2024
Andrews

Andrews ET 25 Bedienungsanleitung

4 Juli 2024
Andrews

Andrews ET 21 Bedienungsanleitung

3 Juli 2024
Andrews

Andrews Zephyr ET Bedienungsanleitung

3 Juli 2024
Andrews

Andrews Polar Wind Plus Bedienungsanleitung

3 Juli 2024
Andrews

Andrews PAC60 Bedienungsanleitung

3 Juli 2024
Andrews

Andrews ET15 Bedienungsanleitung

2 Juli 2024
Andrews

Andrews Little Cooler Bedienungsanleitung

2 Juli 2024
Andrews

Andrews Cyclone DX Bedienungsanleitung

2 Juli 2024

Bedienungsanleitung Klimaanlage

Neueste Bedienungsanleitung für -Kategorien-

MundoClima

MundoClima MUCSR-H3 Bedienungsanleitung

16 Oktober 2024
Duux

Duux DXMA10 North Bedienungsanleitung

16 Oktober 2024
Duux

Duux DXAC04 Bedienungsanleitung

16 Oktober 2024
LG

LG HS-H076QPA0 Bedienungsanleitung

16 Oktober 2024
Klarstein

Klarstein Vita Pure 2G Bedienungsanleitung

16 Oktober 2024
Einhell

Einhell BMK 2400E Bedienungsanleitung

15 Oktober 2024
Qlima

Qlima P 126 Bedienungsanleitung

15 Oktober 2024
Amana

Amana PTC093K35AXXX Bedienungsanleitung

15 Oktober 2024
Amana

Amana AMAP121AB-2 Bedienungsanleitung

15 Oktober 2024
Amana

Amana PTC173J35AXXX Bedienungsanleitung

15 Oktober 2024