Amina AIW150I-S200 Bedienungsanleitung

Amina Lautsprecher AIW150I-S200

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Amina AIW150I-S200 (32 Seiten) in der Kategorie Lautsprecher. Dieser Bedienungsanleitung war für 18 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/32
Installation Guide
V2.15 Jul 2015
Invisible Loudspeakers
AIW150i/350i/450i/550i/150i-S200/350i-S200
Products may vary from items pictured
Ensure that all installation mounting surfaces
are able to support the weight of the product.
After installation, avoid pushing on the wall
or ceiling surface immediately in front of the
speaker. Excessive excursion, whilst unlikely to
damage the speaker, will undoubtedly crack
the plaster around its perimeter.
Do not attempt to modify or repair the product.
Contact your distributor or manufacturer if a
fault should occur.
The rear of the product should not be subject
to chemical cleaning and should not be painted
in any way.
When plastering over, ensure only 2mm of
material covers the product. More than this will
degrade the performance of the product and
could lead to product failure.
To ensure optimal performance, please read
this guide carefully and keep in a safe place
for future reference.
Install this product in a cool, dry, clean place
- away from direct sunlight and heat sources,
strong vibrational forces, chemical fumes,
dust and moisture (steam).
Do not expose this product to sudden
temperature changes or locate it in an
environment with high humidity. This is to
prevent condensation forming inside which
may cause damage to the product.
Do not clean this product with chemical
solvents as this may damage the finish. Use a
clean, dry or damp cloth.
Caution: Read before installing this product
>
>
>
>
>
>
>
>
>
ENVIRONMENTAL:
Before installing, ensure that the building is environmentally sealed, de-humidified and at a stable
temperature of at least 16 degrees centigrade (61 degrees Fahrenheit)
Never force dry the environment after installing speakers. Force drying should only be used to
ensure the entire environment and structural work is fully dry before installation of invisible
loudspeakers.
This product should not be used with single thick coat plaster solutions or with other finishing
methods that take days (rather than hours) to dry out.
Only use low shrinkage plaster types to skim coat these loudspeakers. Consult your plaster
supplier for advice.
Excessive moisture can damage the product. For expert advice contact your dealer or Amina
Technologies Ltd.
Please be aware that when this product is directly fitted into a solid wall structure (e.g. when
using the solid wall backbox) vibrational energy is inevitably transferred into the solid wall
structure. This energy can travel for some considerable distance up, down and along the structure.
It is therefore recommended the product be fitted within acoustically insulated stud walls or
ceiling sections where possible. The use of the product directly embedded in solid walls is not
recommended in multi occupancy buildings.
Equally, using the product in simple (stud or rafter with plasterboard or floor board directly
attached on both sides) stud walls & wooden rafter ceiling/floor structures will also transfer
substantial sound energy to the other side of the wall or floor above. It is therefore recommended
that the product be fitted in acoustically isolated stud walls or ceiling sections where possible.
01 Message from the Managing Director
02 Included in the carton / Packaging
03 How to use this manual
04 Installation overview diagram
Section
Preparing the wall / ceiling and
fixing the product
05 Cavity Installation steps 1 + 2
06 Cavity Installation steps 3+4
07 Cavity Installation steps 5 + 6
08 Cavity Installation with backbox steps 1 + 2
09 Cavity Installation with backbox steps 3
10 Solid Wall Installation with backbox steps 1 + 2
11 Solid Wall Installation with backbox steps 3+4
12 Solid Wall Installation with backbox step 5
Section
Alignment and plastering preparation
13 Retrofit (patch plastered)
14 Retrofit (feathered skim)
15 Retrofit (full wet skim)
16 Drywall (patch plastered)
17 Drywall (feathered skim)
Section
Testing
18 Testing the speakers
Section
Finishing
19 Plastering and decorating steps 1 + 2
20 Plastering and decorating steps 3 + 4
21 Setup tips
22 Setup tips
23 Further details
24 Troubleshooting
25 Specifications / Evolution Series & APU
26 Spacesaver information
27 Accessories
28 Warranty & copyright information
29 Contact information
Contents
A
B
C
D

Produktspezifikationen

Marke: Amina
Kategorie: Lautsprecher
Modell: AIW150I-S200

Brauchst du Hilfe?

Wenn Sie Hilfe mit Amina AIW150I-S200 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Lautsprecher Amina

Amina

Amina AIW150I-S200 Bedienungsanleitung

11 Juli 2024
Amina

Amina Evolution AIW750iN loudspeaker Bedienungsanleitung

11 Juli 2024

Bedienungsanleitung Lautsprecher

Neueste Bedienungsanleitung für -Kategorien-

Sonance

Sonance Visual Performance VP65 SST Bedienungsanleitung

16 Oktober 2024
Bowers And Wilkins

Bowers And Wilkins CWM664 Bedienungsanleitung

16 Oktober 2024
Focal

Focal Chorus 826 V Bedienungsanleitung

16 Oktober 2024
KEF

KEF Ci200ER Bedienungsanleitung

16 Oktober 2024
Steren

Steren SPK-1100BL Bedienungsanleitung

16 Oktober 2024
Aiwa

Aiwa SP-A100 Bedienungsanleitung

16 Oktober 2024
Trust

Trust GXT 628 Bedienungsanleitung

15 Oktober 2024
Pyle

Pyle PBMSPG6 Bedienungsanleitung

15 Oktober 2024
Marshall

Marshall Tufton Bedienungsanleitung

15 Oktober 2024
Sunstech

Sunstech SPUBT780 Bedienungsanleitung

15 Oktober 2024