Air King QR24 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Air King QR24 (1 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 12 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/1
SAVE THESE INSTRUCTIONS
6728086 Rev. B 12-15
INSTRUCTION SUPPLEMENTAL
Air King Model R24
NOTE: Make sure to read all instructions included with this unit before starting installation.
Preparing the Fan
1. Locate the knock-out on the front side
of the fan and remove using a straight-
blade screw driver (Figure 1).
2. Install the included bushing into the
knock-out hole.
3. Open the top access panel of the fan.
On the wire compartment there is a 3
pin molex jumper attached to the 3 pin
connector towards the bottom of the
wire compartment. Remove this jumper.
It will not be used .(Figure 2)
Wiring
CAUTION: MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE STARTING INSTALLATION.
CAUTION: ALL ELECTRICAL CONNECTIONS MUST BE
MADE IN ACCORDANCE WITH LOCAL CODES, ORDINANCES, OR
NATIONAL ELECTRICAL CODE. IF YOU ARE UNFAMILIAR WITH METHODS OF INSTALLING
ELECTRICAL WIRING, SECURE THE SERVICES OF A QUALIFIED ELECTRICIAN.
1. Install an appropriate strain relief cable clamp to the relay box. Run the 24V wiring
through the strain relief into the relay box. Connect one of the 24V wires to one of the
yellow wires inside the relay box and the other 24V wire to the other yellow wire inside
the relay box. Use approved methods for all connections .(Figure 3)
Knock-out
Figure 1
Jumper
Figure 2
Figure 3
Fan
Relay Box
Yellow
24V Wiring Yellow
Strain Relief
Molex Cable
2. Slide the 3 pin molex connector through the bushing that was installed earlier. Connect
the 3 pin molex cable to the connector where the jumper wire that was removed earlier
was located .(Figure 3)
Completing the Installation
1. Re-install the access panel of the fan. Carefully tuck all the wires into the relay box and
install onto the fan using the two supplied screws .(Figure 3)
2. Restore power and test the unit.
Figure 4
Relay Box
Screw
West Chester, PA / Brampton ON
www.airkinglimited.com


Produktspezifikationen

Marke: Air King
Kategorie: Nicht kategorisiert
Modell: QR24

Brauchst du Hilfe?

Wenn Sie Hilfe mit Air King QR24 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Air King

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-