Aigis CAM468CH Bedienungsanleitung

Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Aigis CAM468CH (8 Seiten) in der Kategorie Bewakingscamera. Dieser Bedienungsanleitung war fĂĽr 8 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/8
3
Set screw for
back-focus ring
Back-focus ring
1/4-20 Tapped hole
for Mounting Screw
Figure 4
Figure 1
Components & Specifications
Product ID Camera Type Resolution / Imager Input Voltage Max Power
CAM 468CH Color Hi-Res 540TVL, 1/3” CCD 12VDC / 24VAC ± 10%, 60Hz < 3W
CAM 468DN Day/Night 540TVL, 1/3” CCD 12VDC / 24VAC ± 10%, 60Hz < 3.5W
CAM 586WD Wide Dynamic 540TVL, 1/3” DPS 12VDC / 24VAC ± 10%, 60Hz < 4W
Accessories
• C/CS mount adapter
• 1/16” Allen wrench
• 4-pin auto-iris connector jack
(see diagram at right)
General Camera Setup Procedure
1. Remove the unit from its packaging. Remove the
cover cap from the front of the camera.
2. The camera is equipped with a standard CS-mount.
Optional C-Mount adapter included.
3. Screw the lens firmly onto the lens mount.
4. Attach the 4-pin plug connector from the lens into the
4-pin jack in the body of the camera.
a. An unwired 4-pin is included in the hardware kit. Use this connector if the lens wires terminate as
flying leads. Refer to the chart below Figure 1 and the lens installation manual for wiring information.
5. Mount the camera in the desired location using either of the 1/4-20 tapped holes on the top and bottom of the
camera (see Figure 4).
6. Once mounted and oriented as desired, power the unit as follows:
a. If powering the camera with 12VDC, connect the +12v wire (typically red) into the leftmost contact
and -12v wire (typically black) into the middle contact (see Figure 2).
b. If powering the camera with 24VAC, the two power wires are interchangeable. Connect one to the
leftmost contact and one to the center contact (see Figure 3).
7. Once the unit is powered, a red LED will begin glowing below the power connector.
8. The BNC jack on the rear of the camera provides the video output feed. Connect a test monitor (or any
monitor that accepts BNC video input) to this jack to adjust the zoom and focus settings.
Pin Video Iris
Lens
DC Iris
Lens
1 Power Damp -
2 Null Damp +
3 Video Drive +
4 Ground Drive -
Figure
2
Wired for 12 VDC
Red = +12vdc (hot)
Black = -12vdc (ground)
Figure
3
Wired for 24 VAC
Wires are interchangeable
when powering the unit with
24VAC.
Red
wire
Black
wire
Depress the central
button to insert the power

Produktspezifikationen

Marke: Aigis
Kategorie: Bewakingscamera
Modell: CAM468CH

Brauchst du Hilfe?

Wenn Sie Hilfe mit Aigis CAM468CH benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Bewakingscamera Aigis

Bedienungsanleitung Bewakingscamera

Neueste Bedienungsanleitung fĂĽr -Kategorien-