Adastra WA-215 Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Adastra WA-215 (10 Seiten) in der Kategorie Lautsprecher. Dieser Bedienungsanleitung war fĂĽr 17 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/10
WA-215
Wall Mounted Amplifier with
USB/microSD/FM/BT Player
Item ref: .132UK, 953.137 953 UK
User Manual
Version 2.1
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
953.132 , 953.137UK User ManualUK
Introduction
Thank you for choosing the Adastra - -wall amplifier for your discreet audio WA 215 in
installation. This unit is designed to power wall or ceiling mounted speakers and receive audio
via Bluetooth. Please read this manual to gain the best results from your product and avoid
damage through misuse.
SAFETY SYMBOL AND MESSAGE CONVENTIONS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS
RISQUE DE CHOC ELECTRIQUE NE PAS
OUVRIR
This symbol indicates that dangerous voltage constituting a risk of electric shock is
present within this unit
This symbol indicates that there are important operating and maintenance instructions in
the literature accompanying this unit.
Warning
To prevent the risk of fire or electric shock, do not expose any components to rain or
moisture. If liquids enter the housing, stop using immediately, allow unit to dry out and have
checked by qualified personnel before further use. Avoid impact, extreme pressure or heavy
vibration to the case.
No user serviceable parts inside Do not open the case refer all servicing to qualified – –
service personnel.
Safety
• This product is powered directly from the mains supply and should only be fitted by a
qualified electrical installer.
Placement
• The WA- 5 can be installed into a partition wall using the supplied pattress box. 21
• The WA-215 can be surface mounted if necessary, using the supplied back box.
• Ensure adequate ventilation and keep away from combustible material or moisture.
• Ensure that the WA- is within range of the sending device if using Bluetooth. 215
• Do not set the panel fully into the wall and ensure adequate access to the bottom edge.
Cleaning
• Use a soft cloth with a neutral detergent to clean the housing as required.
• Do not use solvents for cleaning the unit.
953.132 , 953.137UK User ManualUK
Loudspeaker Installation
The WA-215 wall amplifier is available separately or as a WA- -SET. 215
If supplied as a WA- -SET, there are 2 ceiling speakers supplied. 215
The speakers may be installed into a plasterboard or tiled ceiling with at least 80mm to
accommodate the mounting depth of each speaker.
The speakers should be wired to the WA-215 amplifier using standard twin speaker cable.
10m of suitable cable is supplied with the WA- -SET and should be cut as required. 215
Carefully mark out and cut a hole 170mm
diameter for each speaker.
Feed the speaker wires from each hole to the
WA-215 (passing through the back box)
Connect the + and - wires from the WA-215
speaker outputs to the 8Ω and COM screw
terminals and offer the speaker to the hole in
the ceiling with the spring clamps either side of
the magnet pressed fully up to fit through the
hole. The spring clamps will fold back down to
hold the speaker in place. (see opposite)
If the WA-215 is supplied without speakers, ensure that the load to be connected to each
speaker output has no lower than 8 impedance and has a power handling of 15W max. Ω
Do not connect further speakers as this can cause damage to the WA- amplifier circuitry. 215
Back box installation
The WA-215 is supplied with a single gang 60mm deep back box and mounting plate for flush
mounting or surface mounting to a wall. Install the back box to the chosen location and knock
out any of the pre-punched discs in the sides for cable access as required.
Screw the mounting plate into the front of the back box and feed power, speaker, trigger and
signal wires through the back box to the WA-215 and connect to the relative terminals.
(see “Connections” on the next page)
Alternatively, the mounting plate can be fitted into a standard 86 x 86mm pattress box top
accommodate the WA-215, so long as there is a minimum 47mm mounting depth


Produktspezifikationen

Marke: Adastra
Kategorie: Lautsprecher
Modell: WA-215

Brauchst du Hilfe?

Wenn Sie Hilfe mit Adastra WA-215 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Lautsprecher Adastra

Bedienungsanleitung Lautsprecher

Neueste Bedienungsanleitung fĂĽr -Kategorien-