Adastra BCS65S Bedienungsanleitung

Adastra Lautsprecher BCS65S

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Adastra BCS65S (6 Seiten) in der Kategorie Lautsprecher. Dieser Bedienungsanleitung war für 65 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/6

BCS-series

Bluetooth® Ceiling Speaker Set

Item ref: 953.164, 3.165UK 95

User Manual

Version 1.3

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

953.164UK, 165UK User Manual 953.

Introduction

Thank you for choosing the Adastra BCS-seri Bluetooth ceiling speaker set for your ceiling es

speaker installation. This unit is designed to provide a discreet and expandable solution for

background music or other sound application Please read this manual to gain the best .

results from your product and avoid damage through misuse.

SAFETY SYMBOL AND MESSAGE CONVENTIONS

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

AVIS

RISQUE DE CHOC ELECTRIQUE NE PAS

OUVRIR

This symbol indicates that dangerous voltage constituting a risk of electric shock is

present within this unit

This symbol indicates that there are important operating and maintenance instructions in

the literature accompanying this unit.

Warning

To prevent the risk of fire or electric shock, do not expose any components to rain or moisture.

If liquids enter the housing, disconnect the mains immediately, allow unit to dry out and have checked

by qualified personnel before use. Avoid impact, extreme pressure or heavy vibration.

No user serviceable parts inside.

Do not open the case except for removing the front grille for installation.

Refer all servicing to qualified service personnel.

Safety

• The power supply provided in the package is adequate to power the active speaker with its

satellite connected. If further sets are to be used, each set must be powered from its own power

supply. If connecting directly to a ring main, this must be done by a qualified electrical installer.

Placement

• The active and passive unit contained in this set are suitable for mounting into a false ceiling or

partition wall, provided that there is adequate depth to accommodate the rear housing and that

the material is strong enough to safely support the weight of each unit.

Cleaning

• Use a soft cloth with a neutral detergent to clean the panel as required.

• Do not use solvents for cleaning the unit.

953.164UK, 165UK User Manual 953.

Installation

The BCS-system is supplied as a set of two speakers one active and one passive. –

Decide where the active speaker is to be situated and bear in mind that it may be the target

for a Bluetooth sending device and will need to be connected to the mains using the power

supply included.

Carefully mark out and cut a hole (check cut-out diameter in spec.) for each speaker,

ensuring that there is enough headroom to accommodate the rear housing of each speaker.

The BCS-series set is supplied with a fig.8 speaker cable. Feed the bare wire ends of this

cable through the hole for the active speaker and feed the crimped end through the hole for

the passive speaker.

Connect the crimp connectors onto the + and tabs of the passive speaker (there is one –

large and one small to avoid incorrect connection) and make a note of the colour coding on

the speaker cable for + and terminals, which will need to be matched on the active unit. –

Install the passive speaker as follows:

1. With the grille removed, position the passive speaker into its hole in the ceiling or

wall, ensuring that the wire is not trapped and clear of the dog-ear clamps. is

2. Use a cross head screwdriver to turn the 4 dog-ear clamps outward in turn, then

continue turning the screwdriver to draw the dog-ear clamps toward the ceiling or

wall supporting surface, taking care not to over-tighten the clamps.

3. Once secured, replace the magnetic grille by simply lifting it up to the speaker.

For the active speaker, all connections must be in place before positioning the speaker into

the ceiling or wall.

Produktspezifikationen

Marke:	Adastra
Kategorie:	Lautsprecher
Modell:	BCS65S
Bluetooth:	Ja
Gewicht:	1910 g
Produktfarbe:	Black, White
Übertragungstechnik:	Kabellos
Impedanz:	4 Ohm
RMS-Leistung:	20 W
AC Eingangsspannung:	100 - 240 V
Verpackungsart:	Box
Gehäusematerial:	Acrylnitril-Butadien-Styrol (ABS)
Audio Kanäle:	- Kanäle
Magnettyp:	Neodym
Anzahl des Antriebs:	2
Lautsprecher RMS-Leistung:	25 W
Frequenzbereich:	70 - 20000 Hz
Hochtöner:	Ja
Hochtönerdurchmesser (Imperial):	0.5 "
Lautsprecherplatzierung:	Deckenmontage möglich
Hochtönerdurchmesser:	12 mm
Empfindlichkeit:	89 dB
Line-in:	Ja
Lautsprechertyp:	2-Wege