Zanussi ZWT 270 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Zanussi ZWT 270 (8 Seiten) in der Kategorie Waschmaschine. Dieser Bedienungsanleitung war für 13 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/8
1
1. WARNINGS
Keep this user’s manual with your washing machine. If you sell your washing machine or give it away, make sure that it is
accompanied by its user’s manual. The new user can then be informed of how the washing machine operates and read
relevant warnings. These warnings have been written for your safety and for the safety of others. Please read these com-
ments carefully before installing and using your washing machine. Thank you for your attention.
• When you receive your washing machine, unpack it or have it
unpacked immediately. Check its general appearance. Make
any reserves in writing on the delivery form and keep a copy.
• Your washing machine was designed for use by adults. Make
sure that children do not touch it or use it as a toy.
• Do not modify or attempt to modify the characteristics of this
washing machine. This could be dangerous for you.
• Your washing machine is intended for normal domestic use.
Do not use it for commercial or industrial purposes or for any
purpose other than that for which it was designed : to wash, to
rinse and to spin.
• Unplug the power suplly plug and close the water supply tap
every time after using your washing machine.
• Only wash articles that can resist machine washing. Refer to
the instructions on the label for each article.
• Do not wash underwear with bones, or any material without
hems, or torn materials in your washing machine.
• Remember to remove all coins, safety pins, boraches, screws,
etc., before each wash. They can cause serious damage if
they are left in your washing.
• Do not put articles in your washing machine if you have used a
solvent, alcohol, trichloroethylene, etc., to remove stains from
them. If you must use these stain removers, wait until the pro-
duct has evaporated before putting the articles in the drum.
• Collect all small articles such as socks, belts, etc., in a small
cloth bag or pillow case.
• Use the quantity of detergent indicated in the «proportioning of
detergents» section.
• Always unplug the washing machine before cleaning it and
doing any maintenance.
• This washing machine is heavy. Take care when moving it.
• You must remove the packing on the washing machine before
use. Failure to remove all transport protection devices can
cause damage to the washing machine or nearby furniture.
The washing machine must be unplugged while packing is
being removed.
• Do not allow any one other than a qualified plumber to make
the hydraulic connections necessary to install your washing
machine.
• The washing machine must be plugged in to a power outlet
with a conform earth.
• Call a qualified electrician if the electrical installation in your
residence is such that you have to modify it before you can
connect your washing machine.
• Please read the instructions in the "electrical connections"
chapter carefully before connecting your washing machine.
• After installing your washing machine, make sure that it is not
standing on its electrical power supply cable.
• When your machine is installed on a carpeted floor, make sure
that the carpet does not close off the ventilation openings near
the bottom of the machine.
• The power supply cable may be only replaced by the After
Sales Service.
• Your manufacturer cannot be held responsible for any damage
resulting from a nonconform installation.
• The symbol on the product or on its packaging indicates
that this product may not be treated as household waste. Ins-
tead it shall be handed over to the applicable collection point
for the recycling of electrical and electronic equipment. By
ensuring this product is disposed of correctly, you will help pre-
vent potential negative consequences for the environment and
human health, which could otherwise be caused by inappro-
priate waste handling of this product. For more detailed infor-
mation about recycling of this product, please contact your
local city office, your household waste disposal service or the
shop where you purchased the product.
INSTRUCTIONS BOOK
WASHING
MACHINE
ZWR 290
ZWT 270
DIMENSIONS Height
Width
Depth
850 mm
400 mm
600 mm
VOLTAGE / FREQUENCY
TOTAL POWER
230 V / 50 Hz
2300 W
WATER PRESSURE
Connection to the water network
Minimum
Maximum
0,05 MPa (0,5 bar)
0,8 MPa (8 bars)
Type 20x27
This washing machine complies with CEE directive 89-336 about the limitation of radioelectric disturbances
and directive CEE 73-23 for electrical safety.
146 7953 00 - 09/05
2
2. INSTALLATION
2.1. Unpacking
Packing used to protect internal parts of the washing
machine during transport must be removed before the
washing machine is put into service for the first time.
Remove all packing from the
washing machine. Tilt the washing
machine sideways and then remove
the packing under the motor, and
straighten the washing machine.
Tilt the washing machine back-
wards, rotate it by a quarter of a turn
on one of its corner to remove the
transport base.
Open the washing machine lid and
remove the immobilization packing
and plastic films.
Close the lid.
Use a 10 mm spanner to remove the
two screws and spacers at the back.
You can now see the openings that
must be closed with the caches in the
pack attached to the washing machi-
ne; do not forget to fold down the
central capsule.
Make sure that you have removed all
these parts from your washing ma-
chine and keep them so that you can
use them again if you need them for
future transport.
If you want to keep your washing ma-
chine aligned with the adjacent furni-
ture, you can cut the pipe support
strip at the back of your washing ma-
chine. Leave the two side closers in
place.
2.2. Position
Put the washing machine on a flat hard floor in a well venti-
lated room.
Make sure that your washing machine does not touch the
wall or any other furniture in the room.
2.3. Moving your washing machine
If you want to move your washing
machine, lift it onto its rollers by pul-
ling the lever at the bottom of the
washing machine all the way to the
left. When you have put your
washing machine into the required
location, put the lever back into its
initial position.
2.4. Leveling
Precise leveling will prevent vibrations, noise and move-
ments of the washing machine during operation.
Make the washing machine level by
adjusting the leveling screw that is
too short. Unscrew the stand and
locking collar assembly (lift the
washing machine if necessary).
When the washing machine is sta-
ble, maintain the stand on the
ground and turn the locking collar as
far as posible.
2.5. Water inlet
Please install the water inlet hose onto the back of your
washing machine:
- Insert the seal in the hole at the bot-
tom of the back panel (fig. 1).
- Screw on the bottom fitting of the
water inlet hose as shown in fig. 2
and fig. 3.
- Connect the feed hose connector
onto the water inlet tap, taking care to
position the gasket correctly.
- Turn on the water inlet tap.
The water inlet hose cannot be exten-
ded. If it is too short, please contact
the After Sales Department.
2.6. Drainage
- Assemble the hose holder onto the
drain hose.
- Place the assembly in a drainage
pipe (or in a sink) at a height between
70 and 100 cm. Make sure that it will
not fall out.
You must provide an air intake at the
end of the drainage hose, to avoid
any water being siphoned.
Important: the drainage hose must not be extended, on any
account. If it is too short, contact a qualified engineer.
2.7. Electrical connection
You can only connect this washing machine to 230 V single
phase power supply.
Check rating of the fuse line: 10 A at 230V.
The washing machine must not be connected through an
extension cable or a power bar.
Check that the earthing connection is conform with the regu-
lations in force.
3
3. USING
3.1. The control panel
1 - On/Off pushbutton 4 - Program selector
2 - Spinning speed reduction pushbutton 5 - Temperature selector
3 - Half load pushbutton
Represented model : ZWR 290
3.2. How to do a wash ?
Before the first wash in your washing machine, we recom-
mend that you should do a preliminary wash at 90°C with de-
tergent but without any washing to clean the tub.
3.2.1. Loading the washing
• Lift the machine cover.
• Open the drum by pressing on the locking button A; the two
flaps automatically separate.
• Insert the washing, close the drum and the cover of your
washing machine.
Warning : before you close the co-
ver of your washing machine,
make sure that the drum door is
properly closed:
•the two flaps latched together,
•the locking button A extended.
3.2.2. Proportioning of detergents
Your washing machine was designed to reduce water and
detergent consumption, therefore reduce the doses recom-
mended by detergent manufacturers.
Pour the powder detergent dose into the wash compartment
and into the prewash compartment if you chose the
«prewash» option. Pour in the softener into the compart-
ment and Javel water into the compartment if you wish.
If you are using a different type of detergent, refer to the «de-
tergents and additives» section in the washing guide.
3.2.3. Choice of the temperature
Choose the wash temperature applicable for the selected
programme (using the information given in the programmes
table) and comply with the temperature shown on the care la-
bel for each article to be washed (see the washing guide).
3.2.4. Choice of the pushbuttons
3.2.4.1. Spinning speed reduction pushbutton
900/550
The pushbutton 900/550 allows to realize a spinning to 550
rpm (pressed pushbutton) or to 900 rpm (released pushbut-
ton) on the cotton programmes.
If you wish end the synthetics, delicates and wool program-
mes by a short spinning, the spinning speed will be either
600 rpm (released pushbutton) either 550 rpm (pressed pus-
hbutton).
3.2.4.2. «Half load» pushbutton
This pushbutton allows to wash small quantity of linen not
much soiled (max. 2,5 kg) on cotton programmes only by re-
ducing the water quantity during rinsings.
3.2.5. Choice of the programme
Select the programme depending on the nature and the de-
gree of soil of the laundry. Turn the programme selector cloc-
kwise to select the chosen programme.
3.2.6. Starting the programme
After you choose the washing programme, press the «On/
Off» pushbutton to start the cycle.
3.2.7. End of the programme
When the selected programme is over, the appliance stops
automatically and the timer knob stays on a stop-position.
The programmes end :
• by a spinning (for the cotton programmes).
• by a short spinning (for the synthetics, delicate and wool
programmes).
At the end of the cycle, release the on/off pushbutton to
switch the appliance off. Release any other pushbuttons that
are pressed in. Pull out the electricity plug and close the wa-
ter supply tap.
Note: we recommend that you should leave the lid and the
drum open after use to air the washing drum.
1245
3
A


Produktspezifikationen

Marke: Zanussi
Kategorie: Waschmaschine
Modell: ZWT 270

Brauchst du Hilfe?

Wenn Sie Hilfe mit Zanussi ZWT 270 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Waschmaschine Zanussi

Bedienungsanleitung Waschmaschine

Neueste Bedienungsanleitung für -Kategorien-