Yamaha Stagepas 600BT Bedienungsanleitung

Yamaha Hi-Fi-Anlage Stagepas 600BT

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Yamaha Stagepas 600BT (32 Seiten) in der Kategorie Hi-Fi-Anlage. Dieser Bedienungsanleitung war für 33 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/32
Owner’s Manual
Mode d’emploi
Manual de instrucciones
ES
FR
EN
EnglishFrançaisEspañol
2STAGEPAS 600BT/STAGEPAS 400BT Owner’s Manual
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions con-
tained in this manual, meets FCC requirements. Modifications not
expressly approved by Yamaha may void your authority, granted by
the FCC, to use the product.
2. IMPORTANT: When connecting this product to accessories and/
or another product use only high quality shielded cables. Cable/s
supplied with this product MUST be used. Follow all installation
instructions. Failure to follow instructions could void your FCC
authorization to use this product in the USA.
3. NOTE: This product has been tested and found to comply with the
requirements listed in FCC Regulations, Part 15 for Class “B” digital
devices. Compliance with these requirements provides a reason-
able level of assurance that your use of this product in a residential
environment will not result in harmful interference with other elec-
tronic devices. This equipment generates/uses radio frequencies
and, if not installed and used according to the instructions found in
the users manual, may cause interference harmful to the operation
of other electronic devices. Compliance with FCC regulations does
* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. (class B)
not guarantee that interference will not occur in all installations. If
this product is found to be the source of interference, which can be
determined by turning the unit “OFF” andON”, please try to elimi-
nate the problem by using one of the following measures:
Relocate either this product or the device that is being affected by
the interference.
Utilize power outlets that are on different branch (circuit breaker or
fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the
antenna. If the antenna lead-in is 300 ohm ribbon lead, change the
lead-in to co-axial type cable.
If these corrective measures do not produce satisfactory results,
please contact the local retailer authorized to distribute this type of
product. If you can not locate the appropriate retailer, please con-
tact Yamaha Corporation of America, Electronic Service Division,
6600 Orangethorpe Ave, Buena Park, CA90620
The above statements apply ONLY to those products distributed by
Yamaha Corporation of America or its subsidiaries.
FCC INFORMATION (U.S.A.)
* This applies only to products distributed by
YAMAHA CORPORATION OF AMERICA.
(FCC DoC)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
이 기기는 가정용(B급) 전자파적합기기로서 주로
가정에서 사용하는 것을 목적으로 하며, 모든
지역에서 사용할 수 있습니다.
(class b korea)
FCC CAUTION
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
COMPLIANCE INFORMATION STATEMENT
(DECLARATION OF CONFORMITY PROCEDURE)
Responsible Party : Yamaha Corporation of America
Address : 6600 Orangethorpe Ave., Buena Park, Calif. 90620
Telephone : 714-522-9011
Type of Equipment : PORTABLE PA SYSTEM
Model Name : STAGEPAS 600BT, STAGEPAS 400BT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received including interference
that may cause undesired operation.
See user manual instructions if interference to radio reception is sus-
pected.
(fcc_sengen)
English
STAGEPAS 600BT/STAGEPAS 400BT Owner’s Manual 3
PRECAUTIONS
PLEASE READ CAREFULLY
BEFORE PROCEEDING
Please keep this manual in a safe place for
future reference.
WARNING
Always follow the basic precautions listed below to
avoid the possibility of serious injury or even death
from electrical shock, short-circuiting, damages, fire
or other hazards. These precautions include, but are
not limited to, the following:
Power supply/power cord
Do not place the power cord near heat sources such as
heaters or radiators, and do not excessively bend or
otherwise damage the cord, place heavy objects on it, or
place it in a position where anyone could walk on, trip
over, or roll anything over it.
Only use the voltage specified as correct for the mixer.
The required voltage is printed on the name plate of the
mixer.
Use only the supplied power cord.
If you intend to use the device in an area other than in the
one you purchased, the included power cord may not be
compatible. Please check with your Yamaha dealer.
Check the electric plug periodically and remove any dirt
or dust which may have accumulated on it.
When setting up the device, make sure that the AC outlet
you are using is easily accessible. If some trouble or
malfunction occurs, immediately turn off the power switch
and disconnect the plug from the outlet. Even when the
power switch is turned off, as long as the power cord is
not unplugged from the wall AC outlet, the device will not
be disconnected from the power source.
Remove the electric plug from the outlet when the device
is not to be used for extended periods of time, or during
electrical storms.
Be sure to connect to an appropriate outlet with a
protective grounding connection.
Do not open
This device contains no user-serviceable parts. Do not
open the device or attempt to disassemble the internal
parts or modify them in any way. If it should appear to be
malfunctioning, discontinue use immediately and have it
inspected by qualified Yamaha service personnel.
Water warning
Do not expose the device to rain, use it near water or in
damp or wet conditions, or place on it any containers
(such as vases, bottles or glasses) containing liquids
which might spill into any openings. If any liquid such as
water seeps into the device, turn off the power
immediately and unplug the power cord from the AC
outlet. Then have the device inspected by qualified
Yamaha service personnel.
Never insert or remove an electric plug with wet hands.
Hearing loss
Avoid setting all equalizer controls and level controls to
their maximum. Depending on the condition of the
connected devices, doing so may result in feedback that
can cause hearing loss and damage the speakers.
Before connecting the device to other devices, turn off the
power for all devices. Also, before turning the power of all
devices on or off, make sure that all volume levels are set
to the minimum. Failing to do so may result in hearing loss,
electric shock, or device damage.
When turning on the AC power in your audio system,
always turn on the device LAST, to avoid hearing loss and
speaker damage. When turning the power off, the device
should be turned off FIRST for the same reason.
Fire warning
Do not place any burning items or open flames near the
device, since they may cause a fire.
Wireless unit
Do not use this device near medical devices or inside
medical facilities. Radio waves from this device may affect
electro-medical devices.
Do not use this device within 15 cm (6 in) of persons with
a heart pacemaker implant or a defibrillator implant. Radio
waves from this device may affect electro-medical
devices, such as a heart pacemaker implant or
defibrillator implant.
If you notice any abnormality
If any of the following problems occur, immediately turn off
the power switch and disconnect the electric plug from
the outlet.
- The power cord or plug becomes frayed or damaged.
- Unusual smells or smoke are emitted.
- Some object has been dropped into the device.
- There is a sudden loss of sound during use of the
device.
- Cracks or other visible damage appear on the device.
Then have the device inspected or repaired by qualified
Yamaha service personnel.
If this device should be dropped or damaged,
immediately turn off the power switch, disconnect the
electric plug from the outlet, and have the device
inspected by qualified Yamaha service personnel.


Produktspezifikationen

Marke: Yamaha
Kategorie: Hi-Fi-Anlage
Modell: Stagepas 600BT
Bluetooth: Ja
Bluetooth-Version: 4.1
Gewicht: 25600 g
Mitgelieferte Kabel: AC
Produktfarbe: Schwarz
Übertragungstechnik: Verkabelt & Kabellos
Energiequelle: AC
RMS-Leistung: 640 W
Equalizer: Ja
AC Eingangsspannung: 100 - 240 V
AC Eingangsfrequenz: 50 - 60 Hz
Typ: Freistehende Lautsprecheranlage
Kabellänge: 2 m
Anzahl der Lautsprecher: 2
Stromverbrauch (Standby): 35 W
LED-Anzeigen: Ja
Frequenzbereich: 55 - 20000 Hz
Griff(e): Ja
Anzahl der Mischkanäle: 10 Kanäle
Stromeingang: Ja
Griffanzahl: 1
Lautsprechertyp: 2-Wege
Karaoke: Nein
Mischbereich: Ja
Lautsprechergewicht: 10900 g
Bluethooth-Reichweite: 10 m
Lautsprecherabmessungen (BxTxH): 335 x 319 x 545 mm

Brauchst du Hilfe?

Wenn Sie Hilfe mit Yamaha Stagepas 600BT benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Hi-Fi-Anlage Yamaha

Bedienungsanleitung Hi-Fi-Anlage

Neueste Bedienungsanleitung für -Kategorien-