Whirlpool W3F D634 Bedienungsanleitung


Lesen Sie kostenlos die šŸ“– deutsche Bedienungsanleitung fĆ¼r Whirlpool W3F D634 (43 Seiten) in der Kategorie SpĆ¼lmaschine. Dieser Bedienungsanleitung war fĆ¼r 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/43
EN
1
DAILY REFERENCE
GUIDE
Before using the appliance carefully read Safety Instructions.
APPLIANCE
PRODUCT DESCRIPTION
CONTROL PANEL
1. On-Oī˜Ÿ/Reset button with indicator light
2. Program selection button with indicator light
3. Multizone button with indicator light / Key lock
4. Eco program indicator light
5. Key lock indicator light
6. Display
7. Program number and remaining time indicator
8. Tablet (Tab) indicator light
9. Closed water tap indicator light
10. Rinse Aid reī˜žll indicator light
11. Salt reī˜žll indicator light
12. Power Clean button with indicator light / Tablet (Tab)Ā®
13. Delay button with indicator light
14. Start/Pause button with indicator light / Drain out
THANK YOU FOR BUYING Aī˜ŸWHIRLPOOL PRODUCT.
In order to receive aī˜more complete assistance, please
register your appliance on: www.whirlpool.eu/register
0000 000 00000
Service:
1
2
3
4
5
6
11
13
7
12
10
8
9
1. Upper rack
2. Foldable ī˜œaps
3. Upper rack height adjuster
4. Upper spray arm
5. Lower rack
6. Power CleanĀ® support
7. Cutlery basket
8. Lower spray arm
9. Filter Assembly
10. Salt reservoir
11. Detergent and Rinse Aid dispensers
12. Rating plate
13. Control panel
3
1
2
8
13
1454 6 7 9 1210 11
PLEASE SCAN THE QR CODE
ON YOUR APPLIANCE IN ORDER
TO HAVE MORE DETAILED
INFORMATION
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the retaining
elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machineā€™s functional components.
ā€¢ It is mandatory that THE SALT RESERVOIR BE NEVER EMPTY.
ā€¢ It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher
(see PRODUCT DESCRIPTION) and must be ī˜žlled when the SALT REFILL
indicator light in the control panel is lit .
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. Only the ī˜žrst time you do this: ī˜žll the salt
reservoir with water.
3. Position the funnel (see ī˜Ÿgure) and ī˜žll the salt
reservoir right up to its edge (approximately
1 kg); it is not unusual for aī˜little water to leak
out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, it is mandatory to complete the pro-
cedure before the beginning of the washing cycle to avoid corrosion.
SETTING THE WATER HARDNESS
To allow the water softener to work in aī˜perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier. The factory sets the default value for the water hardness.
ā€¢ Switch on the appliance by pressing the button.ON/OFF
ā€¢ Switch oī˜Ÿ the appliance by pressing the button.ON/OFF
ā€¢ Hold down button START/Pause for 5 seconds, until you hear aī˜beep.
ā€¢ Switch on the appliance by pressing the button.ON/OFF
ā€¢ The current selection level number and the salt indicator light both
ī˜œash.
ā€¢ Press button to select the desired hardness level (Psee WATER
HARDNESS TABLE).
ā€¢ Switch oī˜Ÿ the appliance by pressing the button.ON/OFF
Setting is complete!
As soon as this procedure is complete, run aī˜program without loading.
Only use salt that has been speciī˜žcally designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indi-
cator light switches oī˜Ÿ.
If the salt container is not ī˜žlled, the water softener and the heating
element may be damaged as aī˜Ÿresult of limescale accumulation.
Using of Salt is recommended with any type of dishwasher detergent.
Water Hardness Table
Level Ā°dH
German degrees
Ā°fH
French degrees
Ā°Clark
English degrees
1 Soft 0 - 6 0 - 10 0 - 7
2 Medium 7 - 11 11 - 20 8 - 14
3 Average 12 - 16 21 - 29 15 - 20
4 Hard 17 - 34 30 - 60 21 - 42
5 Very hard 35 - 50 61 - 90 43 - 62
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser ī˜should be A
ī˜žlled when the indicator light in the control panRINSE AID REFILL -
el is lit.
1. Open the dispenser by pressing and pulling up the tab on the lid.B
2. Pour in the rinse aid (max.110 ml), making sure it does not overī˜œow
from the dispenser. If this happens, clean the spill immediately with
aī˜dry cloth.
3. Press the lid down until you hear aī˜click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satisī˜žed with the drying results, you can ad-
just the quantity of rinse aid used.
ā€¢ Switch the dishwasher on using the button.ON/OFF
ā€¢ Switch it oī˜Ÿ using the button.ON/OFF
ā€¢ Press button START/Pause three times - aī˜beep will be heard.
ā€¢ Switch it on using the button.ON/OFF
ā€¢ The current selection level number and rinse aid indicator light ī˜œash.
ā€¢ Press button to select the level of rinse aid quantity to be supplied.P
ā€¢ Switch it oī˜Ÿ using the buttonON/OFF
Setting is complete!
If the rinse aid level is set to 1 (ECO), no rinse aid will be supplied.
The LOW RINSE AID indicator light will not be lit if you run out of rinse aid.
Aī˜maximum of 5 levels can be set according to the dishwasher model.
The factory setting is speciī˜žc to the model, please follow instruction
above to check this for your machine.
ā€¢ If you see bluish streaks on the dishes, set aī˜low number (2-3).
ā€¢ If there are drops of water or limescale marks on the dishes, set aī˜mid-
range number (4-5).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device C.
Introduce the detergent into the dry dispenser D only. Place the
amount of detergent for pre-washing directly inside the tub.
1. When measuring out the detergent
refer to the mentioned earlier infor-
mation to add the proper quantity.
Inside the dispenser there are indiD-
cations to help the detergent dosing.
2. Remove detergent residues from
the edges of the dispenser and
close the cover until it clicks.
3. -Close the lid of the detergent dis
penser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If all-in-one detergents are used, we recommend using the TABLET
button, because it adjusts the program so that the best washing and
drying results are always achieved.
Usage of detergent not designed for dishwashers may cause mal-
function or damage to the appliance.
A
B
C
D
3
EN
PROGRAMS TABLE
PROGRAMS DESCRIPTION
ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020.
Note for Test Laboratories:
For information on comparative EN testing conditions, please send an email to the following address: dw_test_support@whirlpool.com
Pre-treatment of the dishes is not needed before any of the programs.
*) Not all options can be used simultaneously.
**) Values given for programs other than the program Eco are indicative only. The actual time may vary depending on many factors such as temperature
and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and
sensor calibration. The sensor calibration can increase program duration up to 20 min.
Program
Drying
phase
NaturalDry
Available
options *)
Duration
of wash
program
(h:min)**)
Water con-
sumption
(litres/cycle)
Energy con-
sumption
(kWh/cycle)
1. Eco 50Ā° 3:10 9.5 0.85
2. 6th SenseĀ®50-60Ā° 1:25 - 3:00 7.0 - 14.0 0.90 - 1.40
3. Intensive 65Ā° 2:50 14.0 1.50
4. Fast Wash&Dry 50Ā° 1:25 11.5 1.10
5. Crystals 45Ā° 1:40 11.5 1.20
6. Rapid 30ā€™ 50Ā° - - 0:30 9.0 0.50
7. Silent 50Ā° 3:30 15.0 1.15
8. Pre-Wash - - - 0:12 4.5 0.01
Instructions on wash cycle selection.
1 ECO
Eco programme is suitable to clean normally soiled tableware, that for
this use, it is the most eī˜›cient programme in terms of its combined
energy and water consumption, and that it is used to assess compliance
with the EU Ecodesign legislation.
2 6th SENSEĀ®
For normally soiled dishes with dried food residues. Senses the level of
soiling on the dishes and adjusts the program accordingly. When the
sensor is detecting the soil level an animation appears in the display
and the cycle duration is updated.
3 INTENSIVE
Program recommended for heavily soiled crockery, especially suitable
for pans and saucepans (not to be used for delicate items).
4 FAST WASH&DRY
Normally soiled crockery. Everyday cycle, that ensures optimal cleaning
performance in shorter time.
5 CRYSTALS
Program for delicate items, which are more sensitive to high tempera-
tures, for example glasses and cups.
6 RAPID 30ā€™
Program to be used for half load of lightly-soiled dishes with no dried
food residues. Does not have drying phase.
7 SILENT
Suitable for night-time operation of the appliance. Ensures optimal
cleaning and drying performance with the lowest noise emission.
8 PRE-WASH
Use to refresh crockery planned to be washed later. No detergent to be
used with this program.
Notes:
Please note that cycle is dedicated for lightly soiled dishes.Rapid 30ā€™


Produktspezifikationen

Marke: Whirlpool
Kategorie: SpĆ¼lmaschine
Modell: W3F D634

Brauchst du Hilfe?

Wenn Sie Hilfe mit Whirlpool W3F D634 benƶtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung SpĆ¼lmaschine Whirlpool

Bedienungsanleitung SpĆ¼lmaschine

Neueste Bedienungsanleitung fĆ¼r -Kategorien-