Whirlpool AWM 483/3 Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Whirlpool AWM 483/3 (20 Seiten) in der Kategorie Waschmaschinen. Dieser Bedienungsanleitung war fĂĽr 2 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/20
22
INSTALLATION INSTRUCTIONS
MOBILITY WHEELS
(for UK only)
Depending on model, your washing machine is
provided with mobility wheels.
You will find these wheels in the accessory kit supplied
with the machine, or you can order them from our
After-Sales Service.
MOUNTING INSTRUCTIONS
1. Tilt the machine forward.
2. Loosen the two rear feet.
3. Insert the wheels as close as possible to the
screw (1).
4. Tighten the screw completely (2).
5. Put the machine in an upright position.
6. Adjust the front feet making sure that the machine
is completely level with the floor.
Note: Levelling is extremely important to avoid any
risk of instability and vibrations.
MOVING THE MACHINE
1. Open the door of the machine.
2. Lift the machine by 1 or 2 cm (3).
3. Push or pull the machine according to your need.
1
2
3
21
1) ELECTRICAL CONNECTIONS
“Warning - this appliance must be earthed”
This appliance is normally supplied with a mains
lead having a plug fitted in the factory which has
been checked for correct earth continuity.
If the fitted plug is not suitable for your socket
outlet, or if the machine’s mains lead is not fitted
with a plug, you should fit a suitable new, good
quality plug by following the instructions in (2)
below.
Any unsuitable plug should be cut off and
disposed of in order to avoid a possible shock
hazard should it be inserted into a socket.
2) CONNECTION TO A REWIRABLE PLUG - to be
carried out only by a qualified electrician
The wires in the mains lead are coloured in
accordance with the following code:
BLUE - “ ” “ ”NEUTRAL ( N )
BROWN - “ ” “ ”LIVE ( L )
GREEN AND YELLOW - “ ” “ ”EARTH ( E )
To fit a new plug, proceed as follows:
2.1 Polarized Plugs (e.g. 3 pin, 13 amp plug
conforming to BS 1363A)
c. The GREEN AND YELLOW wire must be
connected to the terminal in the plug which is
marked with the letter “E” or by the Earth
symbol or coloured yellow or green and
yellow.
d. The BLUE wire must be connected to the
terminal which is marked with the letter “N” or
coloured black.
e. The BROWN wire must be connected to the
terminal which is marked with the letter “L” or
coloured red.
2.2 Non-polarized plugs (e.g. 2 pin with side
earth contact)
The wire which is coloured GREEN AND
YELLOW must be connected to the earth
contact. The other two wires should be
connected to the two pins, irrespective of colour.
3) FUSE REPLACEMENT
If the mains lead of this appliance is fitted with a
BS 1363A 13 amp fused plug, replace the fuse
only with an A.S.T.A. approved type conforming
to BS 1362 and proceed as follows:
1. Remove the fuse cover (A) and the fuse (B).
2. Fit the replacement 13 A fuse into the fuse
cover.
3. Refit both into the plug.
For all other types of plug, the supply socket
should be protected by a 16 A fuse or circuit
breaker at the distribution board.
INSTALLATION INSTRUCTIONS
20
DRAIN HOSE
•Drain hose connection to water outlet.
1. Unhook the drain hose from the left clip, (see
arrow A Fig. 1.)
Do not loosen the drain hose connection,
see arrow B in Fig. 1, otherwise there is
the risk of leakage (danger of scalding
with hot water).
2. Fix the “ ”U bend supplied (inside the drum) to
the free end of the drain hose.
3. Fit the drain hose either to the siphon or hook
it over the edge of a sink or bath tub with the
“ ”U bend (Fig. 2).
Small hand basins are not suitable.
4. Minimum drain height: 70 cm
Maximum drain height: 125 cm
5. If you need to add an extension, use a flexible
hose of the same type and secure the union
with screw-on hose clips.
Maximum overall drain hose length: 2.50 m.
Important:
Make sure there are no kinks in the drain hose run
and take precautions against it falling while the
appliance is running.
CONNECTION TO THE MAINS
•Observe local utility company regulations.
•The appliance must be connected to the
mains exclusively by means of a socket with
an earth connection in accordance with
established regulations. The system must be
earthed. The manufacturer declines all
responsibility for injury to persons or pets and
damage to property caused by disregarding
the above instructions.
•The data concerning voltage, consumption
and necessary fuse are supplied on the
inside of the appliance door.
•The mains connection cable may only be
replaced by a qualified electrician.
• The appliance conforms to European
safety regulations, EC directive
EC directive 93/68/EWG and EN 60555.
•Do not use extension leads or multisockets.
INSTALLATION INSTRUCTIONS
Fig. 1
Fig. 2


Produktspezifikationen

Marke: Whirlpool
Kategorie: Waschmaschinen
Modell: AWM 483/3

Brauchst du Hilfe?

Wenn Sie Hilfe mit Whirlpool AWM 483/3 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Waschmaschinen Whirlpool

Bedienungsanleitung Waschmaschinen

Neueste Bedienungsanleitung fĂĽr -Kategorien-