Whirlpool AKT 820/BA Bedienungsanleitung

Whirlpool Ofen AKT 820/BA

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Whirlpool AKT 820/BA (7 Seiten) in der Kategorie Ofen. Dieser Bedienungsanleitung war für 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/7
81
INSTRUCTION FOR USE
BEFORE USING THE GLASS CERAMIC
HOB
INSTALLATION
ELECTRICAL CONNECTIONS
ENERGY SAVING TIPS
SAFEGUARDING THE ENVIRONMENT
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
HOB ACCESSORIES
CARE AND MAINTENANCE OF THE
GLASS-CERAMIC HOB
TROUBLESHOOTING GUIDE
AFTER SALES SERVICE
31902044GB.fm Page 81 Friday, April 11, 2008 5:31 PM
82
BEFORE USING THE GLASS CERAMIC HOB
To make the most of your new appliance,
please read the user instructions carefully and
keep them handy for future consultation.
INSTALLATION
Cooktop
The cooktop must be set into a worktop between 20
mm and 50 mm deep
There must be nothing between the cooktop and the
oven (cross rails, brackets, etc.).
The distance between the lower face of the glass
ceramic hob and the cupboard or separating panel
must be at least 20 mm.
If the cooktop is to be installed next to a column unit,
leave a distance of at least 100 mm from the edge of the
cooktop to the side of the column unit.
Make an opening in the worktop, respecting the dimensions
indicated in the enclosed product description sheet.
Apply the supplied gasket to the cooktop (unless it has already
been fitted), after having cleaned its surface.
Important
In order to prevent the electronic circuits from overheating, and
therefore from being damaged, we recommend the following:
Do not install the cooktop near a dishwasher or
washing machine, so that the electronic circuits do not
come into contact with steam or moisture, which could
damage them.
If an oven (from our range of ovens) is installed beneath the
cooktop, make sure that it is equipped with a cooling system.
If the temperature of the electronic circuits exceeds the
maximum permitted temperature, the cooktop will switch off
automatically; in this case, wait for a few minutes until the
internal temperature of the electronic circuits reaches a tolerable
level, at which point it will be possible to switch the hob on again.
Switch the hob off after use.
Rear wall
Front
31902044GB.fm Page 82 Friday, April 11, 2008 5:31 PM
83
INSTALLATION
Assembly
A) If the worktop is made of wood, use the appropriate
brackets, spring clips and screws provided.
Position the 4 clips (A) around the cooktop frame, in the
slots provided, see Fig. 1
Measure the centre of the vertical sides of the cut out a
shown in Fig. 2.
Position the centre of the brackets (C) on the centre of the
side previously identified.
The upper edge of the brackets must be flush with the
worktop surface.
Secure using the 4 screws (B)provided that should screwed
into the pre-prepared holes.
Insert the cook hob into the pre-prepared hole ensuring that
the clips (A) lodge into the bracket slots provided
(C Fig. 4 e 5).
B) If the worktop is made of marble, ceramic, stone,
plastic materials, etc., order the installation kit, code 4812
310 19277 from an authorized after-sales service.
B
Fig. 2
Fig. 1 A
Fig. 3
C
Fig. 4
Fig. 5
A
31902044GB.fm Page 83 Friday, April 11, 2008 5:31 PM


Produktspezifikationen

Marke: Whirlpool
Kategorie: Ofen
Modell: AKT 820/BA

Brauchst du Hilfe?

Wenn Sie Hilfe mit Whirlpool AKT 820/BA benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Ofen Whirlpool

Bedienungsanleitung Ofen

Neueste Bedienungsanleitung für -Kategorien-