Wagner Airless HEA Control Series 250M Bedienungsanleitung
Wagner
Farbenspritzpistole
Airless HEA Control Series 250M
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Wagner Airless HEA Control Series 250M (1 Seiten) in der Kategorie Farbenspritzpistole. Dieser Bedienungsanleitung war für 18 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/1
DOING A SPRAY TEST BEFORE
STARTING YOUR PROJECT
Before taking on your project simply take a piece of cardboard and do a
couple of spray tests. This will help you to achieve the right settings on the
paint sprayer:
× After installing the correct spray tip in the holder, try different
spray directions (e.g. vertical or horizontal) as shown by the arrow
on the tip.
× Adjust the pressure on the unit. While thicker materials (e.g. wall
paint) require more pressure, thinner ones (e.g. wood stains) need
less pressure.
× If your pattern is tailing, your spray tip might be incorrect, your spray
gun filter might be clogged or the paint is not diluted enough (for
further instructions see manual).
SPRAYING TIPS FOR EVEN
COVERAGE
× Spray at a constant speed and at an even distance from the surface.
The best distance is 20 to 30 cm between the spray tip and the
surface. For ceilings and hard to reach places WAGNER oers a wide
variety of accessories like extensions, longer hoses, etc.
× Make sure you are spraying at right angles to the surface. It is
important to move your entire arm back and forth rather than just
exing your wrist, otherwise one end of the pattern will be thicker
than the other and will cause overspray.
× The spray gun should be triggered by turning it on and o with each
stroke. Do not trigger the gun during the middle of a stroke. This will
result in an uneven spray and patchy coverage.
× Overlap each stroke by about 30 % for a smooth coating.
OTHER HELPFUL TIPS
× If you accidentally sprayed too much paint on one area, dab the paint
with a cloth or kitchen roll and spray another thin coat over it.
× During a break of several hours, it is not necessary to clean the entire
unit. The gun can be simply placed in a bucket with water to prevent
the paint in the tip from drying out. You should also cover up the paint
container to prevent the paint from drying out.
For more information, please read the relevant product manual
or visit our FAQs:
go.wagner-group.com/faqs-airless
MASKING AND COVERING
× If possible, empty the room completely. Alternatively, place all the
furniture in the middle of the room and cover it with a dust sheet.
× Cover the oor with a dust sheet, painter eece or cardboard.
× Use masking tape with an integrated drop sheet to cover up large
surfaces such as windows and doors.
× In addition test that the dust sheet does not utter when you get
close to it by just using the paint sprayer to blow air.
At WAGNER we have got you covered and have put together dierent
masking kits with all you need for a wide range of painting applications.
SET-UP
× Make sure to set up the Wagner unit properly (see manual).
CHOOSING THE CORRECT SPRAY
TIP AND FILTER
× For very thick materials, e.g. wall paints, we suggest using a 515, 517
or 619 tip with white lter.
× For thin materials, such as lacquers and stains, we recommend a 311
tip with red lter.
PREPARING COATING MATERIAL
Before putting the suction hose into the material, you need to prepare it:
× Most of the units can spray material straight from the container
without diluting. However, with some more viscous materials,
diluting by 5-10 % can give a better result (e.g. for a 10 L bucket 10 %
dilution means 1 L of water).
× If working with paint, make sure that it is approximately at room
temperature. Warm materials have more viscosity and are easier to
work with. However, do not go below or above the min./max.
temperature advised by the paint supplier.
× If there are any small particles in the paint such as dry paint from the
bucket, it is helpful to lter the paint to get rid of them.
× Dilute the paint with warm water (not hot!) or solvent for solvent-
based paints in accordance with manufacturer‘s instructions.
× Stir the material thoroughly with a stirring stick for at least 2 minutes.
In the case you are working with a bigger volume, e. g. 10 L bucket, it
is better to use a drill and a mixer therefor. Stir well, and always make
sure that there are no lumps in the paint, especially at the bottom
of the bucket. Some of the heavier materials in the paint can sink to
the bottem when the bucket has been standing for a longer time on
the shelve. When not mixed well, the lumps in the paint can clog the
paint sprayer.
In case of any questions, please do not hesitate to contact us directly:
J. Wagner GmbH | Otto-Lilienthal-Strasse 18 | D-88677 Markdorf | Telefon: +49 (0) 7544 / 505 - 0 | Mail: info@wagner-group.com | wagner-group.com
HEA SPRAYING
TIPS & TRICKS
Produktspezifikationen
| Marke: | Wagner |
| Kategorie: | Farbenspritzpistole |
| Modell: | Airless HEA Control Series 250M |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Wagner Airless HEA Control Series 250M benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Farbenspritzpistole Wagner
10 April 2024
15 März 2024
12 Februar 2024
28 Januar 2024
25 Januar 2024
1 Januar 2024
27 Dezember 2023
7 November 2023
21 September 2023
21 September 2023
Bedienungsanleitung Farbenspritzpistole
- Farbenspritzpistole Parkside
- Farbenspritzpistole Black And Decker
- Farbenspritzpistole Cocraft
- Farbenspritzpistole DeWalt
- Farbenspritzpistole Einhell
- Farbenspritzpistole Tacklife
- Farbenspritzpistole Power Craft
- Farbenspritzpistole Westfalia
- Farbenspritzpistole Aerotec
- Farbenspritzpistole Earlex
- Farbenspritzpistole Powerplus
- Farbenspritzpistole Ozito
- Farbenspritzpistole Sun Joe
- Farbenspritzpistole Wagner SprayTech
- Farbenspritzpistole Meister Craft
- Farbenspritzpistole Truper
- Farbenspritzpistole Chapin
- Farbenspritzpistole XU1
- Farbenspritzpistole Birchmeier
Neueste Bedienungsanleitung für -Kategorien-
4 Dezember 2024
4 Dezember 2024
26 Juni 2024
26 Juni 2024
13 Juni 2024
2 Juni 2024
10 Mai 2024
26 April 2024
26 April 2024
22 April 2024