Trek Incite 6i Bedienungsanleitung
Trek
Fahrradcomputer
Incite 6i
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Trek Incite 6i (10 Seiten) in der Kategorie Fahrradcomputer. Dieser Bedienungsanleitung war für 25 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/10
CONTENTS
Safety and general guidelines
...............................
i
Functions
.............................................................
1
Installation
.......................................................
2-3
Setting the computer
.......................................
4-7
6i, 8i
..............................................................
.
4-5
9i, 11i
.............................................................
6-7
Changing functions and other normal use
..........
8
Replacing the battery
..........................................
8
Troubleshooting and Warranty
...........................
9
SAFETY AND GENERAL GUIDELINES
While riding your bicycle, do not stare at the computer for long
periods of time (Figure 1). If you do not watch the road, you
could hit an obstacle, which may cause you to lose control and
fall.
Make sure the computer wire cannot contact the tire or wheel
spokes. The wire could be damaged causing the computer to
malfunction. Also, the wire could get caught, causing you to
lose control and fall.
TREK INCITE
Bicycle Computer Owner’s Manual
This manual explains the installation and use of several Trek bicycle computer models:
• Incite 6i
Incite 8i
• Incite 9i
Incite 11i
Please read this manual carefully and save it for future reference.
If you do not understand the information in this manual, or you have a question about your Incite
computer that this manual does not cover, consult your Trek dealer. If you have a question or problem
that your Trek dealer can’t handle, contact us at:
Trek Bicycle Corporation
Attn: Customer Service
801 W. Madison Street
Waterloo, Wisconsin 53594
http://www. trekbikes.com (920) 478-4670
© Copyright Trek Bicycle Corporation
2004 All rights reserved
Figure 1- Watch the road
when riding.
Figure 2- Keep the wire
out of the spokes
1
FUNCTIONS
Not all Trek Incite computer models have all these functions.
Table 1- Function abbreviations, names and explanations
Function
Explanation
Speed
Current speed of the bicycle displayed in miles per hour (MPH) or kilometers per hour (KPH). Highest readings:
• 6i, 8i: 107.3mph or 172.7kph
• 9i, 11i: 80.5mph or 129.6kph
CLK
Clock
Time of day displayed in hours and minutes, in 12-hour or 24-hour format
TME
Time
Amount of time elapsed since last reset. Displayed in hours, minutes, and seconds. Highest readings
• 6i, 8i: 9:59:59
• 9i, 11i: 23:59:59
MAX
Maximum speed
Highest speed since last Reset displayed to tenths. Highest readings:
• 6i, 8i: 107.3mph or 172.7kph
• 9i, 11i: 80.5mph or 129.6kph
TRP
Trip distance
Amount of distance elapsed since last Reset displayed in miles or kilometers, and tenths. Highest reading
• 999.9
ODO
Odometer
Amount of distance elapsed since installation or programming displayed in miles or kilometers. Highest reading:
• 99,999
AVG
Average speed
Average speed since last Reset displayed to tenths. Highest readings
• 6i, 8i: 99.9mph or 172.7kph
• 9i, 11i: 80.5mph or 129.6kph
CAD
Cadence
Number of revolutions per minute of the crankset displayed in whole number. Maximum 240.
Temperature
Current temperature displayed in Fahrenheit or Celsius in whole numbers, updated every 30 seconds. Range
• -2 to 140°F +/-2°
• -19 to 60°C +/-1°
Pacer
ndication whether current speed is above or below average speed displayed by arrow pointing up (above) or down
(below).
Wheel select
Second wheel size calculation, indicated by circle or circle within a partial second circle.
Functions
2
INSTALLATION
Tools needed:
• Electrical tape
• Slot-type screwdriver
• Phillips-type screwdriver
• Scissors
This section explains the steps to install your computer onto your bicycle:
• Placing the computer on the handlebar
• Placing the magnet and sensor(s) on the bike
Placing the computer on the handlebar
The Trek Incite computer can be mounted on the handlebar or on the stem (Figure
3).
To install the computer on the handlebar
1. Determine your bicycle’s handlebar diameter: 22.2mm, 25.4/26.0mm, or 31.8mm.
2. Select the corresponding bar clamp
For a 22.2mm bar, use the rubber shim (provided) inside the smaller clamp
3. Insert the handlebar clamp into the back of the computer base (Figure 4) and
slide it towards the front of the base.
4. Insert the rubber friction pad into the computer base, aligned across the
computer base.
5. With the wire pointing toward the front of the bike, wrap the bar clamp around
the handlebar.
6. Insert the screw through the washer and into the computer base.
7. Tighten the screw until the computer base cannot rotate on the handlebar.
8. Slide the computer into the computer base until the front of the computer and
computer base line up.
9. Check that the computer base cannot be rotated around the handlebar, and that
the computer cannot slide backwards on the computer base (Figure 5).
To install the computer on the stem
1. Insert the rubber friction pad into the computer base, aligned along the
computer base.
2. Insert two nylon ties through the computer base (Figure 6).
3. Place the base on the stem and tighten the nylon tie.
4. Slide the computer into the computer base until the front of the computer and
computer base line up.
5. Check that the computer base cannot be rotated around the stem and the
computer cannot slide backwards on the computer base.
6. Tighten the nylon ties and trim the excess length.
Placing the magnet and sensor(s) on the bike
The wheel magnet must be aligned so that it passes across the sensor. As the
magnet passes the sensor, it must be no further from the sensor than 1 to 3mm (1/
32 to 1/8 inch).
The wheel magnet has a ‘T’ shaped slot with two configurations: round spokes and
flat or bladed spokes (Figure 7).
Computers with the cadence function have two sensors. The shorter computer
wire is for the cadence sensor which mounts near the crankset. The sensor must be
aligned so that the magnet passes within 1-3mm of the sensor, and in line with
the small line on the sensor (Figure 8).
To install the magnet
1. Remove the screw from the magnet.
2. Slide the slot in the back of the magnet over the spoke.
For a flat or bladed spoke, start the spoke near the end where the spoke is round, and align th
top of the ʻTʼ with the spoke as you slide the magnet up the blade
3. Thread the screw into the magnet until it is snug against the spoke.
Installation
Figure 6- Nylon tie
threaded through com-
puter base
Figure 7- Magnet placed
on round and oval
spokes
Figure 3- Computer on
handlebar and stem
Figure 4- Clamp and
friction pad in computer
base
Figure 5- Make sure the
computer cannot be
bounced off.
Produktspezifikationen
| Marke: | Trek |
| Kategorie: | Fahrradcomputer |
| Modell: | Incite 6i |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Trek Incite 6i benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Fahrradcomputer Trek
12 Oktober 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
Bedienungsanleitung Fahrradcomputer
- Fahrradcomputer Crivit
- Fahrradcomputer Bosch
- Fahrradcomputer Conrad
- Fahrradcomputer Cresta
- Fahrradcomputer Hema
- Fahrradcomputer Polar
- Fahrradcomputer Asaklitt
- Fahrradcomputer Filmer
- Fahrradcomputer Pyle
- Fahrradcomputer Pioneer
- Fahrradcomputer Ventura
- Fahrradcomputer Garmin
- Fahrradcomputer Mio
- Fahrradcomputer Suunto
- Fahrradcomputer Sigma
- Fahrradcomputer Rawlink
- Fahrradcomputer Decathlon
- Fahrradcomputer Maxxus
- Fahrradcomputer Bell
- Fahrradcomputer BTwin
- Fahrradcomputer Cordo
- Fahrradcomputer XLC
- Fahrradcomputer Ascot
- Fahrradcomputer Bryton
- Fahrradcomputer CicloSport
- Fahrradcomputer Trelock
- Fahrradcomputer Prophete
- Fahrradcomputer Cube
- Fahrradcomputer Gazelle
- Fahrradcomputer Kayoba
- Fahrradcomputer PRO
- Fahrradcomputer Vogue
- Fahrradcomputer Kogan
- Fahrradcomputer Batavus
- Fahrradcomputer Falk
- Fahrradcomputer Navman
- Fahrradcomputer BBB
- Fahrradcomputer Wahoo
- Fahrradcomputer Stamm
- Fahrradcomputer VDO
- Fahrradcomputer Timex
- Fahrradcomputer Assize
- Fahrradcomputer Bikemate
- Fahrradcomputer Blackburn
- Fahrradcomputer Bontrager
- Fahrradcomputer Cannondale
- Fahrradcomputer Cateye
- Fahrradcomputer Contec
- Fahrradcomputer Echowell
- Fahrradcomputer IGPSPORT
- Fahrradcomputer Kellys
- Fahrradcomputer Lezyne
- Fahrradcomputer Mavic
- Fahrradcomputer O-Synce
- Fahrradcomputer Union
- Fahrradcomputer Vetta
- Fahrradcomputer Magene
- Fahrradcomputer Wahoo Fitness
- Fahrradcomputer Oregon Scientific
- Fahrradcomputer Shimano
- Fahrradcomputer Falk Outdoor
- Fahrradcomputer Filzer
- Fahrradcomputer Halfords
- Fahrradcomputer Key Disp
- Fahrradcomputer Knog
- Fahrradcomputer Matrabike
- Fahrradcomputer MCP
- Fahrradcomputer Osynce
- Fahrradcomputer Powertap
- Fahrradcomputer QT Cycle Tech
- Fahrradcomputer Sigma Sport
- Fahrradcomputer Silent Force
- Fahrradcomputer Speedmaster
- Fahrradcomputer Stages Cycling
- Fahrradcomputer Stella
- Fahrradcomputer Steren
- Fahrradcomputer VDO Dayton
- Fahrradcomputer Walfort
- Fahrradcomputer Sunding
- Fahrradcomputer Ciclo
- Fahrradcomputer Alatech
- Fahrradcomputer Boardman
- Fahrradcomputer E3
- Fahrradcomputer Kathmandu
- Fahrradcomputer Ascent
- Fahrradcomputer One
- Fahrradcomputer SmartHalo
- Fahrradcomputer BBB Cycling
- Fahrradcomputer Dresco
- Fahrradcomputer Bafang
- Fahrradcomputer Axiom
- Fahrradcomputer Stels
- Fahrradcomputer Avenir
Neueste Bedienungsanleitung für -Kategorien-
14 Oktober 2024
14 Oktober 2024
13 Oktober 2024
13 Oktober 2024
12 Oktober 2024
12 Oktober 2024
12 Oktober 2024
10 Oktober 2024
9 Oktober 2024
9 Oktober 2024