TCL 40FD2700 Bedienungsanleitung

TCL Fernseher 40FD2700

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für TCL 40FD2700 (27 Seiten) in der Kategorie Fernseher. Dieser Bedienungsanleitung war für 25 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/27

Refer to the identication/rating label located on the back panel of your product for its proper operating voltage.

FCC regulations state that unauthorized changes or modications to this equipment may void the user’s authority to

operate it.

Cable TV Installer: This reminder is provided to call your attention to Article 820-40 of the National Electrical Code

(Section 54 of the Canadian Electrical Code, Part 1) which provides guidelines for proper grounding and, in particular,

species that the cable ground should be connected to the grounding system of the building as close to the point of

cable entry as practical.

Important: This television is a table model and is designed to sit on a rm, at surface. Don’t place the TV on soft

carpeting or similar surface because the ventilation slots on the bottom of the unit will be blocked, resulting in reduced

lifetime from overheating. To assure adequate ventilation for this product, maintain a spacing of 4 inches from the top

and side of the TV receiver and 2 inches from the rear of the TV receiver and other surfaces.

Also, make sure the stand or base you use is of adequate size and strength to prevent the TV from being accidentally

tipped over, pushed off, or pulled off. This could cause personal injury and/or damage to the TV. Refer to the

Important Safety Instructions on the next page.

The Power button (followed by the power symbol) on this TV and your remote control puts the TV into a very low-

power standby mode but will not completely turn the power off. In order to completely shut the power off, you will

need to disconnect the power cord from the outlet. The mains plug/appliance coupler is used as disconnect device,

the disconnect device shall remain readily operable. Therefore, you should ensure that the TV is installed in a manner

that allows you to disconnect the power cord when desired.

Caution: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside.

Refer servicing to qualied service personnel.

This symbol indicates “dangerous voltage”

inside the product that presents a risk of

electric shock or personal injury.

This symbol indicates important

instructions accompanying the product.

This symbol indicates that this product

incorporates double insulation between hazardous

main voltage and user accessible parts. When

servicing, use only identical replacement parts.

Important Information

WARNING The batteries shall not be exposed to excessive heat such as sunshine, re or the like.

WARNING

To reduce the risk of re or electric shock, do not

expose this product to rain or moisture. This product

should not be exposed to dripping or splashing. No

objects lled with liquids, such as vases, should be

placed on the component.

WARNING

The TV is unstable if it is not properly attached to the

base or mounted to the wall. Please follow the base

or wall mounting instructions provided in the User’s

Guide to ensure your safety.

Important Safety Instructions

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8. gisters, stoves, or other apparatus (including Do not install near any heat sources such as radiators, heat re

ampliers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades

with one wider than the other. A grounding type plug has two blades and a third grounding prong. The

wide blade or the third prong are provided for your safety. If the provided plug does not t into your outlet,

consult an electrician for replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles,

and the point where t exit from the apparatus.hey

11. Only use attachments/accessories specied by the manufacturer.

12. Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer,

or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination

to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or when unused for long periods of time.

14. Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been

damaged in any way, such as power-supply cord or plug damaged, liquid has been spilled or objects have is

fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally,

or has been dropped.

15. If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is

grounded so as to provide some protection against voltage surges and built-up static charges. Section 810

of the National Electrical Code, ANSI/NFPA No. 70-2011 (Section 54 of Canadian Electrical Code, Part 1)

provides information with respect to proper grounding of the mast and supporting structure, grounding of

the lead-in wire to an antenna-discharge unit, size of grounding conductors, location of antenna-discharge

unit, connection to grounding electrodes, and requirements for the grounding electrode. See following

example:

A N T E N N A L E A D I N W I R E

GR O U N D CL A M P

GR O U N D I N G CON D U C OR ST

(N E C S E C T I ON 8 1 0 - 2 1 )

GR O U N D CL A M PS

P OWE R S E R VI C E GR O U N D I N G

E L E CTR O D E S YS T E M

( RN E C A R T 2 5 0 , PA T H )

E L E CTR I C S E R V I CE

E Q U I P M E N T

A N T E N N A D I S CH A R G E

U N I T (N E C S E C T I ON 8 1 0 - 20)

ANTENNA LEAD IN WIRE

GROUND CLAMP

ANTENNA DISCHARGE UNIT

(NEC SECTION 810-20)

GROUND CLAMPS

GROUNDING CONDUCTORS

(NEC SECTION 810-21)

ELECTRIC SERVICE

EQUIPMENT POWER SERVICE GROUNDING

ELECTRODE SYSTEM (NEC ART

250, PARTH)

Produktspezifikationen

Marke:	TCL
Kategorie:	Fernseher
Modell:	40FD2700
Bildschirmdiagonale:	40 Zoll
Bildschirmtechnologie:	LED
Anzahl der Farben des Displays:	16,78 Millionen Farben
Eingebaute Lautsprecher:	Ja
Unterstützte Audioformate:	MP3
WLAN:	Nein
Mitgelieferte Kabel:	AC
Produktfarbe:	Schwarz
Akku-/Batterietyp:	AAA
Tunertyp:	Analog & Digital
RMS-Leistung:	10 W
Equalizer:	Ja
Sleep-Timer:	Ja
Kopfhörerausgänge:	1
Anzahl USB 2.0 Anschlüsse:	1
On-Screen-Display (OSD):	Ja
Menüsprachen:	ENG, ESP, FRE
Verpackungsbreite:	1117.6 mm
Verpackungstiefe:	127 mm
Verpackungshöhe:	635 mm
Paketgewicht:	9525.44 g
Fernbedienung enthalten:	Ja
Eingebauter Ethernet-Anschluss:	Nein
Schnellstartübersicht:	Ja
Stromverbrauch (Standardbetrieb):	65 W
Betriebsanleitung:	Ja
HD-Typ:	Full HD
Bildschirmform:	Flach
Natives Seitenverhältnis:	16:9
Helligkeit:	- cd/m²
Reaktionszeit:	- ms
Digitales Signalformatsystem:	ATSC
Anzahl HDMI-Anschlüsse:	2
Anzahl der Lautsprecher:	2
Stromverbrauch (Standby):	0.5 W
Desktop-Ständer:	Ja
Anzahl unterstützter Akkus/Batterien:	2
Kontrastverhältnis (dynamisch):	5000000:1
Automatische Kanalsuchlauf:	Ja
Analoges Signalformatsystem:	NTSC
Audioeingang (L, R):	1
Composite Video-Eingang:	1
PC-Eingang (D-Sub):	Ja
Gewicht (ohne Ständer):	6803.8855 g
Breite (ohne Standfuß):	911.86 mm
Tiefe (ohne Standfuß):	76.2 mm
Höhe (ohne Standfuß):	508 mm
VESA-Halterung:	Ja
Unterstützte Video-Modi:	480p, 720p, 1080i, 1080p
3D:	Nein
Smart-TV:	Nein
Internet-TV:	Nein
Audio Return Channel (ARC):	Ja
DVI Anschluss:	Nein
Anzahl RF Anschlüsse:	1
Unterstützte Bildformate:	JPG
Panel-Montage-Schnittstelle:	100 x 150 mm
Gerätebreite (inkl. Fuß):	911.86 mm
Gerätetiefe (inkl. Fuß):	177.8 mm
Gerätehöhe (inkl. Fuß):	558.8 mm
Gewicht (mit Ständer):	7148.6158 g
Ein-/Ausschalter:	Ja
Eingebaute Audio-Decoder:	Dolby Digital
High Dynamic Range Video (HDR) Unterstützung:	Nein
Akkus/Batterien enthalten:	Ja
Anzahl VGA (D-Sub) Anschlüsse:	1
HDMI-Version:	1.3
Anzahl OSD-Sprachen:	3
Uhrfunktion:	Ja
Kontrolle durch Eltern:	Ja
Display-Bildwiederholrate unterstützt:	120 Hz
Display-Auflösung:	1920 x 1080 Pixel