Swann Pro-661 Bedienungsanleitung

Swann Überwachungskamera Pro-661

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Swann Pro-661 (4 Seiten) in der Kategorie Überwachungskamera. Dieser Bedienungsanleitung war für 30 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/4
8
FCC Verifi cation
This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
WARNING: Modifi cations not approved by the party responsible for compliance could void user’s authority to
operate the equipment.
PRO-661 Dome
English
222
Congratulations on your purchase of this PRO-661 from Swann! You’ve chosen
well: we think this is one of the fi nest CCTV video cameras available. The PRO-661
is great for monitoring a wide open space whilst maintaining a high level of detail,
even in low-light situations.
Placement Guide
The PRO-661 has a 3.6mm built-in which allows it to see almost wide-angle lens
80 degrees horizontally. What does this mean for you when placing it?
• You will be able to see a really
wide area. If it’s mounted high up
in a square corner, you’ll probably be
able to see along both walls. You’ll
be able to monitor a large area with
only one camera.
• Things may look further away than
they really are. Anything further
than a few meters (ten feet or so)
from the camera may appear to be
too small for the level of detail you
require.
• Vertical and horizontal lines might appear curved when they near the edge of
the camera’s view. This is normal, and it’s the side effect of cramming so much
viewing area onto one screen.
The PRO-661 is great for monitoring rooms or areas as wide as, or wider than, they
are long. For really wide areas, you may need a second camera.
Typically, it is best mounted in a corner looking across and down into the room,
so that it can look over intervening obstacles. The higher the ceiling the camera is
mounted on, the more it will be able to see and the harder it’ll be for an intruder
to access the camera or interfere with it.
Tips:
• Try to aim the camera at an area which is evenly lit, as objects or people in shadows
near brightly lit objects are very hard to see.
• It’s better to have the camera in the shade looking into the light than vice-versa.
• Avoid having bright light sources in your image. This includes the obvious (such as the
sun or an artifi cial light source) but also things such as refl ections. Cars are notorious
for refl ected light sources, as are buildings with a lot of windows, mirrors and so forth.
80° 10m
33ft
16.8m
55ft
7
Technical Specifi cations
Video
Image Sensor 1/3” CCD
Video Quality TV Lines 600
Effective Pixels NTSC: 768 x 494
PAL: 752 x 582
Min. Illumination 0.1 Lux
White Balance Automatic / Custom / Manual
Electronic Shutter NTSC: 1/60 ~ 1/100 000
PAL: 1/50 ~ 1/100 000
Gain Control Automatic / Manual
Backlight Comp. Yes (Adjustable)
Wide Dynamic Range Yes (Adjustable)
Lens 3.6mm
Viewing Angle Avg: 75° (H: 80°, V: 70°)
Night Vision
Range None
IR Cut Filter No
Number of IR LEDs 0
Infrared Wavelength NA
IR LED Life (Average) NA
General
Operating Power DC 12V @ 300mA
Operating Temp. -20°C ~ 45°C (-4°F ~ 113°F)
Casing Aluminium
Dimensions 110mm x 110mm x 70mm
(4.33” x 4.33” x 2.75”)
Weight 368g / 0.8lbs (approx)
666
Problem: At night, all I see is white.
Solution: The camera is most likely looking through a window. At night, the light
from inside the room can ‘bounce back’ off a refl ective surface (such as glass,
water, spider webs, some ceramics and so on) and effectively blind the camera. If
you want to see outside, mount the camera outside - we made it weather resistant
for a reason!
Problem: I see only a blank screen where my image should be.
Solution: Check the wiring to the camera, and ensure the camera is being
supplied power from the included power adapter. Try using a different video lead,
or connecting the camera to a different television or monitor. Be sure there are no
devices interrupting your signal, such as a DVR or VCR that isn’t outputting the
signal correctly.
Problem: I can’t see anything at night.
Solution: The PRO-661 dome has great low-light vision (it’ll see better in the near
dark than you do) but it’s just that - light vision. It does need some light to see! low
Security light sets (essentially spotlights triggered by a passive infrared sensor [PIR])
are a good solution if you need targeted light - they’re available from most good
hardware stores.
Some additional, technical remarks: Low Light Vision
• At 0.01lx, you’ll get an image (enough to see something moving, for example)
but it will be very diffi cult or impossible to see any useful details.
• At 0.1lx the quality will be signifi cantly improved (enough to see an outline of
WHAT is moving).
• However, you’ll probably want to increase the amount of light signifi cantly (to
1lx or more) before you’ll be able to tell is moving about!who
Under aritfi cial lights, the average room is illuminated to somewhere in the vicinity
of 40 ~ 60lx. If you’ve got bright lights and white walls, it may push over 100,
whereas dim lights (or energy saving lamps) and dark walls might put the value
below 20lx. The PRO-661 should work in these conditions, but there’s really no
substitute for actually shining a light on what you want to see.
3
Installing the Camera
The camera mounts onto the underside of a fl at, vertical or horizontal surface using
screws. The surface must have suffi cient strength to hold the camera. Materials
such as hardwood, brick or masonry are good options, and we’ve included all the
gear you’ll need to mount it there (except the tools - sorry, you’ll still need your
own drill). You can mount the camera onto a metal surface, but you’ll need to
supply your own mounting hardware.
To mount the camera:
• Using the small hex key
(supplied), undo the two locking
screws on the sides of the PRO-
661 dome.
• Remove the top of the dome.
• Attach the base plate of the
dome to the wall/ceiling in the
position you’d like using the
supplied screws. If mounting
to brickwork, concrete or
other masonry surface, use the
included wall plugs.
• Aim the camera in the direction you’d like. It can help to move a monitor
or television out to the camera’s location to ensure you get it aimed and
positioned properly.
• Once the camera is aimed, re-attach the dome cover. Ensure that the black,
protective plastic isn’t obscuring the camera’s vision.
Tips: Positioning your Cables
• When running your cable, try to avoid bending it at sharp angles.
• Don’t put your cable near live electrical wiring. AC electricity generates radio
“noise” which can interfere with the signal from your camera.
Tips: Weatherproofi ng
• The PRO-661 is built to be weather resistant. It’ll stand up to getting wet
occasionally, but it’s not intended to be underwater all the time. When
mounting the camera, ensure that it’s not in a location where water is likely to
pool or build up over time.
• Long term exposure to direct sunlight will adversely affect the camera. Over
time, the infrared and ultraviolet radiation will eventually begin to degrade the
integrity of the plastic cover, reducing transparency and making it brittle (and,
therefore, more vulerable to vandalism or accidental damage). Basically, put it
in the shade!
The three screw holes, as seen from above.

Produktspezifikationen

Marke: Swann
Kategorie: Überwachungskamera
Modell: Pro-661

Brauchst du Hilfe?

Wenn Sie Hilfe mit Swann Pro-661 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Überwachungskamera Swann

Swann

Swann SWNHD-866MSD Bedienungsanleitung

3 Oktober 2024
Swann

Swann SW312-HMD-CA Bedienungsanleitung

16 September 2024
Swann

Swann PRO-A851 Bedienungsanleitung

15 September 2024
Swann

Swann PRO-760 Bedienungsanleitung

10 September 2024
Swann

Swann Pro-535 Bedienungsanleitung

31 August 2024
Swann

Swann Pro DVR8-4000 Bedienungsanleitung

27 August 2024
Swann

Swann PRO-743 Bedienungsanleitung

27 August 2024
Swann

Swann SWDVK-846806SL Bedienungsanleitung

24 August 2024
Swann

Swann Enforcer SWPRO-4KMQB Bedienungsanleitung

18 August 2024
Swann

Swann SWIFI-PTCAM232GB Bedienungsanleitung

12 August 2024

Bedienungsanleitung Überwachungskamera

Neueste Bedienungsanleitung für -Kategorien-

Trebs

Trebs CCD-401C Bedienungsanleitung

15 Oktober 2024
D-Link

D-Link DCS-7510 Bedienungsanleitung

15 Oktober 2024
Foscam

Foscam FI9900EP Bedienungsanleitung

14 Oktober 2024
Alecto

Alecto DVC-215IP Bedienungsanleitung

14 Oktober 2024
Hikvision

Hikvision DS-2CD2326G2-IU Bedienungsanleitung

13 Oktober 2024
Hikvision

Hikvision DS-2TD2166-15/V1 Bedienungsanleitung

13 Oktober 2024
Hikvision

Hikvision DS-2DE7A245IX-AE/S1 Bedienungsanleitung

13 Oktober 2024
Hikvision

Hikvision DS-2CD7A26G0-IZ(H)SY Bedienungsanleitung

11 Oktober 2024
Hikvision

Hikvision DS-2CE79DF8T-AZE Bedienungsanleitung

11 Oktober 2024
Hikvision

Hikvision DS-2XM6726G0-I(D)(S)(M)(/ND) Bedienungsanleitung

11 Oktober 2024