Speco Technologies O2MD1 Bedienungsanleitung

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Speco Technologies O2MD1 (27 Seiten) in der Kategorie Bewakingscamera. Dieser Bedienungsanleitung war für 7 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/27
O2MD1
O
O2
2M
MD
D1
1
O
Ow
wn
ne
er
r
s
s
M
Ma
an
nu
ua
al
l
Rev.1.1 (Nov. 2013)
2
Caution
Any changes or modications in construction of this device which are not explicitly approved by the
party responsible for compliance could void the users authority to operate the equipment.
Note
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generate, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into and outlet on a circuit dierent from that to which the receiver is
connected
Consult the dealer or an experienced radio/TV technician for help.
Directions
Be careful not to cause any physical damage by dropping or throwing the camera.
Especially keep the device out of reach from children.
Do not disassemble the camera. No after service is assumed when disassembled.
Use only power adapters compatible with the unit.
Be careful to prevent moisture or water penetration into the unit. Particular attention is needed when
installing the unit. The screw holes for the installation screws and pipe should be maintained water tight
during the whole life time of the product.
All the electrical connection wires running into the unit should be prepared so that water from the outside
cannot ow into the unit through the surface of the wires. Penetration of the moisture through the wire for
extended period can cause malfunction of the unit or deteriorated image.
O
O2
2M
MD
D1
1
O
Ow
wn
ne
er
r
s
s
M
Ma
an
nu
ua
al
l
Rev.1.1 (Nov. 2013)
3
Revision History
Revision
Details
1.0
First manual revision creation.
1.1
Text revisions

Produktspezifikationen

Marke: Speco Technologies
Kategorie: Bewakingscamera
Modell: O2MD1

Brauchst du Hilfe?

Wenn Sie Hilfe mit Speco Technologies O2MD1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Bewakingscamera Speco Technologies

Bedienungsanleitung Bewakingscamera

Neueste Bedienungsanleitung für -Kategorien-