Smeg TLS106 Bedienungsanleitung

Smeg Waschmaschine TLS106

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Smeg TLS106 (17 Seiten) in der Kategorie Waschmaschine. Dieser Bedienungsanleitung war für 32 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/17

C D

Programme Chart; if you pass on the washing

machine to another person, also give him/her

Instructions for Use and Programme Chart.

g y

and spin machine washable laundry in quantities which

are usual for private households.

• Observe the instructions given in these Instructions

for Use and the Programme Chart when using the

washing machine.

BEFORE USING THE WASHING MACHINE

1. Remove the packaging and check

a. Cut and remove the shrink-wrap.

b. Remove the top protection and the protective

corners.

c. Remove the bottom protection by tilting

and turning the washing machine on one

rear bottom corner. Make sure that the

black plastic part of the bottom protection

(if available on the model) remains in the

packing and not in the machine bottom.

This is important, as otherwise the plastic part could

damage the washing machine during operation.

d. Open the lid by pressing it slightly down while

raising the handle. Remove the polystyrene

cushion (depending on model).

e. Remove the blue protective film from the panel

(depending on model).

• After unpacking, make sure that the washing machine

is undamaged. If in doubt, do not use the washing

machine. Contact After-Sales Service or your local

retailer.

• Keep the packaging materials (plastic bags,

polystyrene parts, etc.) out of reach of children;

they are potentially dangerous.

• If the appliance was exposed to the cold prior to

delivery, keep it at room temperature for a few

hours before operating.

2. Remove the transport bracket

• The washing machine is fitted with transport

screws and a transport bracket to prevent

damage during transport. Before using the

washing machine you must remove the

transport bracket (see “Installation”/“Removal

of transport bracket”).

3. Install the washing machine

• Place the washing machine on a flat and stable

floor surface.

• Adjust the feet to ensure that the machine is

stable and level (see “Installation”/“Adjust the

feet”).

• In case of wooden or so-called “floating floors”

(for instance certain parquet or laminate floors),

place the appliance on a 40 x 60 cm sheet of

plywood at least 3 cm in thickness which is

secured to the floor.

• Make sure that the ventilation openings in the

base of your washing machine (if available on

your model) are not obstructed by a carpet or

other material.

4. Water supply

• Connect the water supply inlet hose in

accordance with the regulations of your local

water company (see “Installation”/“Connect the

water inlet hose”).

• Water supply: Cold water only

• Tap: 3/4” threaded hose connection

• Pressure: 100-1000 kPa (1-10 bar).

• Only use new hoses for connecting the washing

machine to the water supply. Used hoses must

not be used anymore and should be discarded.

5. Drain hose

• Connect the drain hose to the siphon or hook it

over the edge of a sink with the “U” bend (see

“Installation”/“Connect the water drain hose”).

• If the washing machine is connected to a built-in

drainage system, ensure the latter is equipped

with a vent to avoid simultaneous loading and

draining of water (siphoning effect).

6. Electrical connection

• Electrical connections must be carried out by a

qualified technician in compliance with the

manufacturer’s instructions and the current

standard safety regulations.

• The technical data (voltage, power and fuses) are

given on the rating plate on the rear of the washing

machine.

• The washing machine must be connected exclusively

by means of a socket with an earth connection in

accordance with current regulations. The washing

machine must be earthed by law. The manufacturer

declines all liability for injury to persons or animals or

damage to property deriving directly or indirectly

from failure to observe the directions.

• Do not use extension leads or multi sockets.

• Before any maintenance on the washing machine

disconnect it from the mains supply.

• Access to the mains plug or to disconnection from

the mains supply via a double-pole switch must be

ensured at all times following the installation.

• Do not operate the washing machine if it has been

damaged during transport. Inform the After-Sales

Service.

• Mains cable replacement is only to be carried out

by After-Sales Service.

• The washing machine must be connected to an

effective earthing installation, in compliance with the

regulations in force. In particular, washing machines

installed in premises containing a shower or a bath

must be protected by a differential residual current

device of at least 30 mA. Earthing the washing

machine is obligatory under the law. The

manufacturer declines all liability for injury to persons

or animals or damage to property deriving either

directly or indirectly from failure to observe the

directions in these Instructions for Use.

• The washing machine may only be used in the

household for the prescribed uses.

Dimensions:

Width: 400 mm

Height: 900 mm

Depth: 600 mm

GB 1

Produktspezifikationen

Marke:	Smeg
Kategorie:	Waschmaschine
Modell:	TLS106
Display-Typ:	LED
Breite:	400 mm
Tiefe:	600 mm
Produktfarbe:	Weiß
Steuerung:	Tasten
Höhe:	900 mm
Eingebautes Display:	Ja
Geräteplatzierung:	Freistehend
Waschprogramme:	Hygiene/anti-allergy, Black
Maximale Schleuderdrehzahl:	1000 RPM
Energieeffizienzklasse (alt):	A
Jährlicher Energieverbrauch Waschen:	188 kWh
Ladetyp:	Toplader
Energieverbrauch Reinigung:	- kWh
Nennkapazität:	6 kg
Türfarbe:	Weiß
Wasserverbrauch pro Zyklus:	- l
Jährlicher Wasserverbrauch Waschen:	8926 l
Waschwirkungsklasse:	A
Schleuder-Klasse:	C
Anzahl Waschprogramme:	18