Smeg PNL64ES Bedienungsanleitung

Smeg Herde PNL64ES

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Smeg PNL64ES (14 Seiten) in der Kategorie Herde. Dieser Bedienungsanleitung war für 20 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/14

Contents

THESE INSTRUCTIONS ARE VALID ONLY FOR END USER COUNTRIES WHOSE IDENTIFICATION SYMBOLS

APPEAR ON THE COVER OF THIS MANUAL.

THIS BUILT-IN HOB IS CLASS 3.

qualified technicia

Further information about the products can be found at www.smeg.com

Instructions for safe and proper use

1. Instructions for safe and proper use

THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS

ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKING

HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING

THE COOKING HOB. ALSO KEEP THE SERIES OF NOZZLES SUPPLIED. INSTALLATION MUST BE

CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN FORCE.

THIS APPLIANCE IS INTENDED FOR DOMESTIC USES AND CONFORMS TO CURRENT

REGULATIONS IN FORCE. THE APPLIANCE HAS BEEN BUILT TO CARRY OUT THE FOLLOWING

FUNCTIONS: COOKING AND HEATING-UP OF FOOD. ALL OTHER USES ARE CONSIDERED

IMPROPER.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE.

DO NOT LEAVE THE PACKING IN THE HOME ENVIRONMENT. SEPARATE THE VARIOUS WASTE

MATERIALS AND TAKE THEM TO THE NEAREST SPECIAL GARBAGE COLLECTION CENTRE.

IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE GROUNDED ACCORDING TO THE

METHODS REQUIRED BY SAFETY RULES.

THE PLUG TO BE CONNECTED TO THE POWER CABLE AND THE SOCKET MUST BE THE SAME

TYPE AND MUST CONFORM TO CURRENT REGULATIONS.

THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE HAS BEEN BUILT IN.

NEVER UNPLUG BY PULLING ON THE CABLE.

IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE COOKING

HOB, FOLLOWING THE INSTRUCTIONS BELOW. SHOULD THE APPLIANCE NOT FUNCTION,

DISCONNECT IT FROM THE SUPPLY AND CALL THE NEAREST TECHNICAL ASSISTANCE CENTRE.

NEVER ATTEMPT TO REPAIR THE APPLIANCE.

ALWAYS CHECK THAT THE CONTROL KNOBS ARE IN THE “ZERO” (OFF) POSITION WHEN YOU

FINISH USING THE HOB.

DO NOT PUT PANS WITHOUT PERFECTLY SMOOTH AND FLAT BOTTOMS ON THE COOKING HOB

GRIDS.

DO NOT USE RECIPIENTS OR GRIDDLE PLATES THAT EXTEND BEYOND THE EXTERNAL

PERIMETER OF THE HOB.

THE I.D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER AND BRAND NAME IS

POSITIONED VISIBLY UNDER THE CASING, ATTACHED TO THIS MANUAL AND APPLIED TO THE

QUALITY CERTIFICATE.

THE PLATE ON THE CASING MUST NOT BE REMOVED.

THE HOB IS TO BE USED BY ADULTS ONLY. DO NOT LET UNSUPERVISED CHILDREN PLAY WITH

THE HOB.

THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE

ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE).

THIS GUIDELINE IS THE FRAME OF A EUROPEAN-WIDE VALIDITY OF RETURN AND RECYCLING ON

WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT.

Instructions for the installer

2. Positioning of hob

2.1 Attachment to support structure

Create an opening with the dimensions shown in the figure in the top surface of the

counter, keeping a minimum distance of 50 mm from the rear border. This unit may be

set against walls that are higher than the hob as long as distance (see figure) is

maintained to prevent damage to the walls due to overheating. Make sure there is a

minimum of 750 mm between the hot plate flames and any shelf that may be installed

directly above them. In case of installation on a hollow compartment with doors, a

separating panel has to be placed under the hob. Keep a minimum distance of 10 mm

between the bottom of the unit and the panel surface. The panel has to be easily

removable to allow access in the event of technical service.

Whenever a cooker hood is to be installed above the hob, refer to the instruction

manual to ensure it is installed at the correct distance.

A (mm) B (mm) C (mm) D (mm) E (mm) X (mm) Y (mm) L (mm)

MOD.60 min 220 min 460 min 750 20÷40 min 50 596 555÷560 478÷482

MOD.70 min 280 min 460 min 750 20÷40 min 50 718 555÷560 478÷482

MOD.100 min 280 min 460 min 750 20÷40 min 50 1005 839÷844 480÷484

Produktspezifikationen

Marke:	Smeg
Kategorie:	Herde
Modell:	PNL64ES
Breite:	596 mm
Tiefe:	510 mm
Produktfarbe:	Edelstahl
Steuerung:	Drehregler
Höhe:	38 mm
Eingebautes Display:	Nein
Geräteplatzierung:	Integriert
Einfach zu säubern:	Ja
Kochfeldtyp:	Gaskochfeld
Anzahl Herdplatten/Kochzonen:	4 Zone(n)
Anzahl der Gasbrenner:	4 Zone(n)
Anzahl der elektrischen Herdplatten:	0 Zone(n)
Typ Kochzone 1:	Groß
Kochzone 1 Form:	Rund
Position Kochzone 1:	Hinten links
Stromquelle Kochzone 1:	Gas
Leistung Kochzone 1:	2300 W
Typ Kochzone 2:	Regelmäßig
Kochzone 2 Form:	Rund
Position Kochzone 2:	Links vorne
Brenner/Kochzone 2 Stromquelle:	Gas
Leistung Kochzone 2:	1650 W
Typ Kochzone 3:	Groß
Kochzone 3 Form:	Rund
Position Kochzone 3:	Hinten rechts
Stromquelle Kochzone 2:	Gas
Leistung Kochzone 3:	3000 W
Typ Kochzone 4:	Köcheln
Kochzone 4 Form:	Rund
Position Kochzone 4:	Vorne rechts
Stromquelle Kochzone 3:	Gas
Leistung Kochzone 4:	1000 W
Einbauraum Breite:	560 mm
Einbauraum Tiefe:	478 mm
Steuerungsposition:	Vorne oben
Art der Oberfläche:	Edelstahl
Einbauraum Tiefe (max):	482 mm
Einbauraum Tiefe (min):	478 mm
Standard Herdplatte/Kochzone:	1650 W
Große Herdplatte/Kochzone:	2300 W
Elektrische Zündung:	Ja
Schmorplatte/ Kochzone:	1000 W
Extra große Hochgeschwindigkeitsherdplatte:	3000 W