Siemens HB13AB221B Bedienungsanleitung

Siemens Ofen HB13AB221B

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Siemens HB13AB221B (3 Seiten) in der Kategorie Ofen. Dieser Bedienungsanleitung war für 7 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/3

*9000365773* 9000365773 951215

951215 Ú Installation instructions





PLQ















PLQ

PLQ





PLQ









PLQ

PD[



PLQ

PLQ

9

/ 1

Ú Installation instructions

Important notes

This appliance is intended for use up to a maximum height of

2000 metres above sea level.

If the appliance is being installed under a hob, refer to the

assembly instructions for the hob.

Do not use the door handle to carry or install the appliance.

Before installation, check the appliance for transportation

damage.

Before starting up the appliance, remove any packaging

material and adhesive film from the cooking compartment and

the door.

The appliance must be disconnected from the power supply

during all installation work.

Preparing the kitchen units

Safe use of this appliance can only be guaranteed if it has been

installed professionally in accordance with these installation

instructions. The installer is liable for damages incurred as a

result of incorrect installation.

Units into which ovens are to be fitted must be heat-resistant up

to 90 °C and adjacent cabinets up to 70 °C.

Do not install the appliance behind a decorative panel. There is

a risk of overheating.

Carry out all cut-out work on the furniture unit and worktop

before fitting the appliances. Remove shavings. Otherwise, the

correct operation of electrical components may be adversely

affected.

Caution during installation. Parts that are accessible during

installation may have sharp edges. Wear protective gloves to

prevent injury from cuts.

Secure freestanding units to the wall using standard,

commercially available brackets .A

Permanently fix furniture units to the worktop.

Appliance under worktop - Fig. 1

To ventilate the appliance, there must be a gap of 20 mm

between the intermediate floor and the wall.

The gap between the worktop and the appliance must not be

closed using additional battens.

Corner installation - Fig. 2

For corner installation, check minimum clearances. Ensure that

there is sufficient clearance B for the front panel and its handles.

Check that the appliance door can be opened properly.

Appliance in a tall unit - Fig. 3

To ventilate the appliance, there must be a gap of 20 mm

between all intermediate floors and the wall.

Only fit the appliance up to a height which allows accessories to

be easily removed.

Connecting the appliance to the power supply -

Fig. 4

Only a licensed professional may connect the appliance.

The fuse protection must correspond to the power rating

specified on the appliance's rating plate and to local regulations.

The appliance corresponds to safety class I and may only be

operated in conjunction with a safety earth terminal.

Power cord: Type H05 V V-F or a higher rating. The yellowgreen

wire for the safety earth terminal must be 10 mm longer on the

appliance side than the other wires.

In the installation, there must be an all-pin isolating switch with at

least 3 mm contact gap, or the appliance must be connected

using a plug with an earthing contact. This must remain

accessible after installation.

Contact protection must be ensured by the method of

installation.

Identify the phase and neutral (zero) conductors in the power

socket. The appliance could be damaged if incorrectly

connected.

Only connect the hob according to the connection diagram. The

connection diagram is on the back of the appliance. See the

rating plate for the voltage.

To connect the appliance, place it in front of the kitchen unit.

The service cable must be long enough.

Fixing the appliance in place - Fig. 5

1. Fully insert the appliance. Do not kink or trap the power cable,

or route it over sharp edges.

2. Centre the appliance.

There must be an air gap of 5 mm between the appliance and

adjacent cabinets.

3. Using a spirit level, adjust the appliance so that it is perfectly

level.

4. Screw the appliance firmly in place.

Removal

1. Disconnect the appliance from the power supply.

2. Undo the securing screws.

3. Lift the appliance slightly and pull it out completely.

PLQ



PLQ

Produktspezifikationen

Marke:	Siemens
Kategorie:	Ofen
Modell:	HB13AB221B

Brauchst du Hilfe?

Wenn Sie Hilfe mit Siemens HB13AB221B benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten

Ihren Namen*

Deine E-Mail*

Schreiben Sie hier Ihre Frage

Bedienungsanleitung Ofen Siemens

Siemens HE379HCS6 Bedienungsanleitung

14 Oktober 2024

Siemens HQ574AER3 Bedienungsanleitung

9 Oktober 2024

Siemens EP616CB21E Bedienungsanleitung

8 Oktober 2024

Siemens CN878G4B6B Bedienungsanleitung

7 Oktober 2024

Siemens HB42AR551E Bedienungsanleitung

5 Oktober 2024

Siemens HM656GBS1Y Bedienungsanleitung

5 Oktober 2024

Siemens HB24D552B Bedienungsanleitung

4 Oktober 2024

Siemens HB74BC551E Bedienungsanleitung

30 September 2024

Siemens CM724G1B3 Bedienungsanleitung

26 September 2024

Siemens EC845XB90E Bedienungsanleitung

24 September 2024

Bedienungsanleitung Ofen

Neueste Bedienungsanleitung für -Kategorien-

Indesit VL 22 S Bedienungsanleitung

16 Oktober 2024

Gaggenau BMP225130 Bedienungsanleitung

16 Oktober 2024

Wolf M Series Bedienungsanleitung

16 Oktober 2024

Princess 112741 Bedienungsanleitung

16 Oktober 2024

Freggia HR750VGTCH Bedienungsanleitung

16 Oktober 2024

Freggia HR750VGTAN Bedienungsanleitung

16 Oktober 2024

Freggia HR640VGTCO Bedienungsanleitung

16 Oktober 2024

Freggia HR640VGTCH Bedienungsanleitung

16 Oktober 2024

Freggia HR640VGTAN Bedienungsanleitung

16 Oktober 2024

Freggia HR640VGCH Bedienungsanleitung

16 Oktober 2024