Shure PGA56-LC Bedienungsanleitung

Shure Mikrofon PGA56-LC

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Shure PGA56-LC (4 Seiten) in der Kategorie Mikrofon. Dieser Bedienungsanleitung war für 24 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
© 2015 Shure Incorporated
27A24478 (Rev. 3)
WIRED MICROPHONE
PGA 56
USER GUIDE
PG ALTA SERIES
TM
2
PGA56
Applications And Placement
The following table lists the most common applications
and placement techniques. Keep in mind that microphone
technique is largely a matter of personal taste; there is no one
"correct" microphone position.
Application Suggested Microphone
Placement
Tone Quality
Tom-Toms One mic on each tom,
or between each pair of
toms, 2.5 to 7.5 cm (1 to
3 in.) above drum heads.
Aim each microphone
at top drum heads. On
double head toms, you
can also remove bottom
head and place a mic
inside pointing up toward
top drum head.
Medium
attack; full,
balanced
sound.
Snare Drum 2.5 to 7.5 cm (1 to 3 in.)
above rim of top head of
drum. Aim mic at drum
head.
Most
“snap” from
drumstick.
NOTE: Before each use, make sure the grille is tightly
secured on the microphone, as vibration and accidental hits
with drumsticks may loosen it, resulting in signal loss.
Avoiding Pickup of Unwanted
Sound Sources
Place the microphone so that unwanted sound sources,
such as monitors and loudspeakers, are directly behind
it. To minimize feedback and ensure optimum rejection of
unwanted sound, always test microphone placement before a
performance.
MONITOR
P.A. LOUDSPEAKER
Recommended Loudspeaker Locations for Cardioid
Microphones
PG Alta Microphones
Congratulations on the purchase of a new Shure PG Alta series
microphone. The PG Alta series delivers professional quality
audio at an affordable price, with solutions for capturing nearly
any source, including voice, acoustic instruments, drums,
and amplified electric instruments. Suitable for live and studio
applications, PG Alta microphones are built to last, and meet
the same rigorous quality testing standards that make all Shure
products trustworthy and reliable.
General Rules for Use
Do not cover any part of the microphone grille with your hand,
as this will adversely affect microphone performance.
Aim the microphone toward the desired sound source (such
as the talker, singer, or instrument) and away from unwanted
sources.
Place the microphone as close as practical to the desired
sound source.
Work close to the microphone for extra bass response.
Use only one microphone to pick up a single sound source.
For better gain before feedback, use fewer microphones.
Keep the distance between microphones at least three times
the distance from each microphone to its source (“three to one
rule”).
Place microphones as far as possible from reflective surfaces.
Add a windscreen when using the microphone outdoors.
Avoid excessive handling to minimize pickup of mechanical
noise and vibration.
Proximity Effect
Directional microphones progressively boost bass frequencies as
the microphone is placed in closer proximity to the source. This
phenomenon, known as proximity effect, can be used to create a
warmer, more powerful sound.
3
Using the Quick-Release Lever
This microphone features a quick-release lever to easily
adjust position.
1. Pull the lever open
2. Move the microphone into the desired position
3. Press the lever back towards the microphone to tighten
1
2
3
Note: To adjust the
tension on the lever,
pull it open and use a
flat head screwdriver
to tighten or loosen
the bolt on the
opposite side.
Specifications
Type
Dynamic (moving coil)
Frequency Response
50 to 15,000 Hz
Polar Pattern
Cardioid
Output Impedance
200Ω
Sensitivity
at 1 kHz, open circuit voltage
-57 dBV/Pa¹ (1.45 mV)
Polarity
Positive pressure on diaphragm produces positive voltage on pin 2
with respect to pin 3
Weight
287 g (10.12oz.)
Connector
Three-pin professional audio (XLR), male
Environmental Conditions
Operating Temperature -20° to 165°F (-29° to 74°C)
Relative Humidity 0 to 95%
1 Pa=94 dB SPL
20
15
10
5
0
-30
-25
-20
-15
-10
-5
dB
Hz
20 100 1k 10k 20k
0,6 m (2 ft.) from sound source
Typical Frequency Response
1000 Hz
Typical Polar Pattern
Certifications
This product meets the Essential Requirements of all relevant
European directives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from:
www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: EMEAsupport@shure.de
Optional Accessories and
Replacement Parts
Microphone Drum Mount A50D
7.6 m (25 ft.) Cable (XLR-XLR) C25J
Grille RPMP56G
PGA56 Replacement Grille RPM152
93 mm (3.66 in.)
44.5 mm diameter
(1.75 in.)
Overall Dimensions


Produktspezifikationen

Marke: Shure
Kategorie: Mikrofon
Modell: PGA56-LC

Brauchst du Hilfe?

Wenn Sie Hilfe mit Shure PGA56-LC benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Mikrofon Shure

Bedienungsanleitung Mikrofon

Neueste Bedienungsanleitung für -Kategorien-