Pyle PLRM40F Bedienungsanleitung

Pyle Subwoofer PLRM40F

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Pyle PLRM40F (14 Seiten) in der Kategorie Subwoofer. Dieser Bedienungsanleitung war für 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/14
AM/FM/MP3/USB/AUX Stereo Receiver, Single DIN,
30 Preset Memory Stations, LCD Display
with Remote Control (Black)
PLRM40F
MP3 Stereo Receiver Power Amplifier
www.PyleUSA.com
2
INSTALLATION
Preparation
The preparation kit is necessary to mount the radio on the dashboard, this kit is
available at electronics stores and car audio specialists, check the installation kit
before using it to make sure it is the right one for your vehicle.
INSTALL THE DEVICE
1. Lift the left or right top corner of the plastic outer trim ring
then pull it out to remove it.
2. Insert the two bracket keys into the left and right side of
the chassis to separate the chassis from the housing.
3. Install the mounting knob on the boa . Check the rd
opening size of the sliding panel to be mounted. If the
measurement is not large enough, carefully cut it until it
slips easily on the opening. Do not force the handle in the
opening so as not to bend it. Locate the series of dubbing
tabs above, below and all sides to be mounted. Completely
insert it to the opening of the board, bend the tabs as
4. Slide the stereo into the opening in the dash, ensuring that
the wires behind are tucked and not pinched.
5. Follow the wiring dia am carefully. gr
Verify you’ve connected them correctly.
! Connect the unit to a 12 Volt power source CAUTION
with adequate ground.
6. Now that your wires are all completed, attach the front
panel and turn the unit (the vehicle must be switched on). If the unit does not ON
work, check the calibration again until the problem is solved. With the new car
stereo secured into the bracket, all you need to do is plug the wiring harness back
into the stereo and put the assembly back into place.
7. Slide the stereo into the opening in the dash, ensuring that the wires behind are
tucked and not pinched. Sometimes this may take a few times when the vehicle
has a tight dash opening. Tuck the wires back into an opening behind the unit.
8. Install the plastic outer trim ring
9. Snap all the pieces of trim back into place over the stereo. Double check that all
screws and trim pieces are securely in place.Try out the new stereo. Turn the car
power on again and play around with the stereo and its settings to be sure
everything is in working order.
www.PyleUSA.com 3
PUSH-TO-TALK
• Allows you to a ess cc SIRI GOOGLE or voice via Wireless BT.
• Your phone must support or voice. Once connected to BT, your SIRI GOOGLE
phone will ask for access to your contact list.
• Now you are ready to use PUSH-TO-TALK PUSH-TO-TALK. Press the icon.
You are ready to talk. Call "(CONTACT NAME)" The system will call without
having to use your phone.
WIRING CONNECTIONS
CONTROL PANEL BUTTONS
16320 5 6 7 8
11
4
1 13 14
9
17
10 18
15
19 2112
15A
Front RCA Output(Left) Front RCA Output(Right)
Rear A Output(Left)RC
Rear A Output(Right)RC
SWC
SUBWOOFER
Antenna Jack
SUBWOOFER
ANT:RADIO ANTENNA JACK
F-L:Front RCA Output(Left)
F-R:Front RCA Output(Right)
R-L:Rear RCA Output(Left)
R-R:Rear RCA Output(Right)
Power/speaker Connector
FUSE 15A
PRECAUTION
+12V DC
NEGATIVE
EARTH


Produktspezifikationen

Marke: Pyle
Kategorie: Subwoofer
Modell: PLRM40F

Brauchst du Hilfe?

Wenn Sie Hilfe mit Pyle PLRM40F benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Subwoofer Pyle

Bedienungsanleitung Subwoofer

Neueste Bedienungsanleitung für -Kategorien-