Pyle INV449A Bedienungsanleitung

Pyle Empfänger INV449A

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Pyle INV449A (18 Seiten) in der Kategorie Empfänger. Dieser Bedienungsanleitung war für 44 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/18
Invincible Series Amplifier
www.PyleUSA.com
2
INTRODUCTION
PYLE ampliers provides high-performance sound reinforcement for your
mobile audio equipment. Its versatility enables compatibility with optional
Equalizers, Frequency Dividing Crossover Networks, and other audio processors
in customized system. The Multi-Mode bridging capabilities allow exibility in
hosting several dierent speaker congurations.
To achieve optimum performance, it is highly recommended that you read this
Owners Manual before beginning installation.
WARNING!
High powered audio systems in a vehicle are capable of generating "Live Concert”
high levels of sound pressure. Continued exposure to excessively high volume
sound levels may cause hearing loss or damage.
Also, operation of a motor vehicle while listening to audio equipment at high
volume levels may impair your ability to hear external sounds such as; horns,
warning signals, or emergency vehicles, thus contributing to a potential trac
hazard. In the interest of safety, PYLE recommends listening at lower volume
levels while driving.
TABLE OF CONTENTS
PLANNING YOUR SYSTEM
WIRING CONNECTION
PANEL LAYOUT
CONTROL FUNCTIONS
SPEAKER CONNECTION
TROUBLESHOOTING GUIDE
SPECIFICATION
3
3
5
8
10
16
17
www.PyleUSA.com 3
PLANNING YOUR SYSTEM
Before beginning the installation, consider the following
1. Do you plan to add additional mobile electronics equipment in the future?
If you plan to expand your system by adding other components sometime in
the future, ensure adequate space is left, and cooling requirements are met.
2. Should you use high or low level inputs?
Your Amplier has been designed to accept Low-Level (Pre-Amp outputs from
your radio) signal source. If your radio/source is equipped with Pre-Amp
outputs, it is possible to utilize them to drive the Amplier and connecting
(Amplier) to the 2 rear speakers. Then, use the built-in power of your radio to
drive the 2 front speakers.
3. Are your components matched?
The RMS power rating of your speaker’s must be equal or greater than the RMS
power rating of your amplier. You speaker(s) also must be 2- 8 Ohms
impedance for stable amplier operation. Impedance information is normally
printed on the speaker basket or magnet.
4. Where will the amplier be installed?
Consider both the length of your leads and routing when determining the
mounting location. It is best to run power and RCA wiring on opposite sides of
the vehicle to prevent induced noise. Pre-Amp input Jacks require a length
(depending on location) of high qualityshielded male to male RCA patch cord.
WIRING CONNECTION
CAUTION:
AS A PRECAUTION, DISCONNECT THE POWER WIRE FROM THE BATTERY
WHILE MAKING THE POWER AND GROUND CONNECTIONS TO THE AMPLFIER.
4/8 GAUGE (Thicker if planning for additional Ampliers) wire is recommended
for both the power and ground wires. 12 Gauge, For the remote turn-on wire, 16
Gauge. Both types are available at most Mobile Audio Dealers or Installation Shop.

Produktspezifikationen

Marke: Pyle
Kategorie: Empfänger
Modell: INV449A

Brauchst du Hilfe?

Wenn Sie Hilfe mit Pyle INV449A benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Empfänger Pyle

Pyle

Pyle PTAU23 Bedienungsanleitung

6 April 2024
Pyle

Pyle PDA8BU Bedienungsanleitung

2 April 2024
Pyle

Pyle PHA40 Bedienungsanleitung

1 April 2024
Pyle

Pyle PT6060CHAE Bedienungsanleitung

16 März 2024
Pyle

Pyle PFA320BT Bedienungsanleitung

22 Februar 2024
Pyle

Pyle Cycle PLMCA20 Bedienungsanleitung

10 Februar 2024
Pyle

Pyle PCAU46A Bedienungsanleitung

1 Februar 2024
Pyle

Pyle PVTA80 Bedienungsanleitung

27 Januar 2024
Pyle

Pyle PLMRA400 Bedienungsanleitung

24 Januar 2024
Pyle

Pyle PVAMP30 Bedienungsanleitung

1 Januar 2024

Bedienungsanleitung Empfänger

Neueste Bedienungsanleitung für -Kategorien-

Dimavery

Dimavery BA-30 Bedienungsanleitung

18 April 2024
TOA

TOA Trantec S5.3 Bedienungsanleitung

17 April 2024
Pioneer

Pioneer DMH-WT3800NEX Bedienungsanleitung

17 April 2024
NAD

NAD C 3050 LE Bedienungsanleitung

16 April 2024
Devialet

Devialet Expert 220 Pro Bedienungsanleitung

16 April 2024
Cambridge

Cambridge Azur 851A Bedienungsanleitung

16 April 2024
AudioControl

AudioControl LC-6.1200 Bedienungsanleitung

16 April 2024
RCF

RCF FVM 9844 Bedienungsanleitung

16 April 2024
Zehnder

Zehnder ZX 67 Bedienungsanleitung

15 April 2024
Marantz

Marantz PM6007 Bedienungsanleitung

15 April 2024