Powerhouse PH6500Ri Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Powerhouse PH6500Ri (54 Seiten) in der Kategorie Generator. Dieser Bedienungsanleitung war für 16 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/54
PH6500Ri Digital Inverter Generator
POWERHOU
POWERHOU
POWERHOU
POWERHOUPOWERHOUSE
SE
SE
SESE®
®
®
®®
OWNER’S MANUAL
PLEASE READ THIS MANUAL
CAREFULLY BEFORE USING
2 PH6500Ri OM
QUICK START
Use outdoors only. Generators produce carbon monoxide poisonous, colorless, a
odorless gas that can cause death or serious injury.
Always operate on a level surface.
Keep away from rain, snow or other wet conditions.
Keep away from smoking materials, sparks, and other sources of combustion when
refueling.
Pre-Operation
1. Use the embedded handles to move the generator on at terrain. Use the folding handles to move the
generator on rough or uneven terrain. Refer to the section for more information. Using the Handles
2. Add oil by removing the maintenance door and inspecting the dipstick. Fill the oil reservoir with 37.2 oz fl
(1.1 L) of oil, or to the full mark on the dipstick. Use appropriate grade, high-detergent, premium quality,
4-stroke engine oil (synthetic or conventional). Use SAE 15W-40 viscosity oil unless operating at ambient
temperatures below 32° F (0° C). For temperatures below 32° F, use SAE 0W-40 viscosity oil. Synthetic
oil is also recommended for temperatures below 32° F. Refer to the Operating at extreme temperatures
section for more information.
3. Remove the maintenance door and connect the quick connect cable to the battery wiring harness. Refer
to the section for more information. Connecting the battery
4. Replace the maintenance door.
5. Connect an external battery charger (such as the 2-P Plug-In Trickle Charger, part number ) to TC 19674
the DC recept acle in the “Battery Charger” section of the control panel.
The TC2-P Battery Charger also includes an alligator clip cable that plugs into the
T-style male DC connector of the charger, allowing you to connect the clips to the
terminals for batteries powering other equipment or POWERHOUSE generators, . F ®
for ease of use, it is suggested that you connect the T-style male plug to the DC
receptacle on the control panel rather than attempting to charge the generator battery ,
directly.
Connected
3 PH6500Ri OM
6. Charge the battery for 3 hours or until it is fully charged. After the battery is fully charged, disconnect the
battery charger.
If you are using the 2-P Plug-In Trickle Charger, the status indicator will go from red TC
to green when the battery is fully charged.
7. Carefully a regular unleaded automotive gasoline up to the shoulder of the fuel strainer. To avoid dd
spilling fuel, use care to not ll too quickly or over ll. Avoid getting dirt, dust, or water in the fuel tank. Do
not use a blend that contains more than 10% ethanol. Do not use gasoline containing methanol. An
octane rating of 87 or higher is recommended.
Do not add 2-Stroke oil to your fuel. Doing so will void your warranty.
It is recommended that you use a fuel stabilizer, such as STA-BIL®, to help prevent
fuel oxidation (breakdown) and the formation of gum and varnish, and to inhibit
corrosion in the fuel system and carburetor.
Operation
1. Ensure that no loads have been connected to the AC receptacles.
2. Open the fuel valve.
3. Start the engine in one of the following ways.
A. Electric Start:
Insert the ignition key, and turn it all the way to the START position. Hold key at this position
until the engine is running or for a maximum of 10 seconds. Release and repeat if necessary.
B. Remote Start:
Turn the remote switch to the position. ON
Push the start button on the remote twice and hold until the engine has started for or a
maximum of 10 seconds. Release and repeat if necessary.
Always place the remote switch on the control panel osition when not in use to in the “OFF” p
prevent running down the battery.
4. The digital display will illuminate and display data when the generator is ready for use. Before connecting
any loads, ground the generator with a length of heavy cable, connecting s grounding the generator
terminal to an external ground source.
5. Use the voltage selector switch to select either operation or operation. For the 120V-only 120V/240V
location of the voltage selector switch, refer to the section. PH6500Ri Control Panel
Do not use the switch while a load is connected. Switching the voltage while a load is
connected may burn out the voltage selector switch.
6. Make sure that all appliances to be connected ve been switched o are in good working orderha and .
Conrm that the electrical rating does not exceed that of the generator.
7. Connect your appliances to the appropriate receptacle on the generator’s panel.
8. To minimize fuel consumption and noise, . This setting push the economy switch to the “ON” position
regulates the engine speed so that it matches the needs of the connected loads. Do not use the s
economy setting if you are connecting items with electric motors that have a high amperage draw during
startup or with appliances that cycle on and o rapidly.


Produktspezifikationen

Marke: Powerhouse
Kategorie: Generator
Modell: PH6500Ri

Brauchst du Hilfe?

Wenn Sie Hilfe mit Powerhouse PH6500Ri benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Generator Powerhouse

Bedienungsanleitung Generator

Neueste Bedienungsanleitung für -Kategorien-