Pioneer HTP-2600 Bedienungsanleitung

Pioneer Heimkino-Set HTP-2600

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Pioneer HTP-2600 (3 Seiten) in der Kategorie Heimkino-Set. Dieser Bedienungsanleitung war für 11 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/3

RECEIVER

–+

+–+–

–

–+

BASS

OFF SOUND TONE

MPX

AUTO

ROOM

SETUP TEST

TONE

SYSTEM

SETUP CH LEVEL

TUNING STATION

FM/AM TAPE/VCR TV CLASS

DIGITAL

INPUT SELECT OR

STB DVD/DVR

TUNER

EDIT

SLEEP STATUS DIMMER

STANDBY/ON MUTE

SURROUND

ENTER

VOLUME

STEREO

TREBLE

Check that you have all the

accessories.

Speaker cord (x1)

FM wire antenna

You should also have:

• Speakers (x5)

• Subwoofer

• Operating instructions

• Warranty card

AM loop

antenna

Non-skid pads

(1x20, 1x4)

Batteries (x2)

Remote control

Brackets (x4)

Screws (x4)

Front and surround speakers Center speaker Subwoofer

Put the batteries in the remote

control and stick the non-skid pads

to the base of the speakers.

Open the battery compartment on

the rear of the remote control.

Insert the supplied batteries

following the markings inside the

battery compartment to align

them correctly.

Replace the battery compartment

cover.

Stick the self-adhesive non-skid

pads to the underside of each

speaker, and to the underside of

the subwoofer. Use four pads per

speaker (see below).

DIGITAL

OUT

–

DIG ITAL IN PUT

(C OAXIAL)

DVD/D VR

OUT

R L

T V IN

AUDIO

OUT

VIDEO

OUT

Connect the receiver to your DVD

player/ recorder.

Use a coaxial digital cord (not supplied) to connect the digital

output of your DVD player/ recorder to the DIGITAL INPUT

(COAXIAL) DVD/DVR jack.

Use a red/white stereo audio cord (not supplied) to connect the

AUDIO TV IN jack on the receiver to the audio output on your

TV.* This will allow you to listen to your TV through this

speaker system.

* Note that you must also connect the DVD player/ recorder's

video output to your TV's video input to watch a DVD video

(video cable is not supplied).

DVD player/ recorder

Receiver

ANT EN NA

UNBAL

75Ω

LOOP



AM loop

antenna

FM wire antenna

3/8 in.

(10mm)

Connect antennas

Connect the FM wire antenna and fully extend along a

window frame or another suitable place that gives good

reception.

To connect the AM loop antenna, twist the exposed wire

strands together and insert into the terminal, then snap

the connector shut as shown below.

Receiver

VIDEO 1



ST ANDBY/O N



STANDBY/ON



STANDBY/ON



STANDBY/ON

VIDEO SELECT

Plug the receiver, DVD player/

recorder and TV into a convenient

AC outlet.

Press STANDBY/ON to switch on the receiver.

Switch on your DVD player/ recorder and TV, and set the TV to

the correct video input.

DVD player/ recorder

Receiver

–

VOLUME AUTO SURROUND STEREO

FM/AM TAPE/VCR TV

DIGITAL

INPUT SELECTOR

STB DVD/DVR

After switching on, make any

necessary settings required by the

DVD player/ recorder, then you're

ready to start enjoying your home

theater system.

Refer to the receiver's operating instructions for a detailed

explanation of this system's surround sound features.

For the best surround sound, set up your

speakers like this. The front left and right

speakers should be about 6–9 feet apart.

Connect each speaker to the receiver using the

supplied speaker wires.

To connect, insert the colored wire into the matching colored ( ) tab +

and the other wire into the black ( ) tab as shown below. Connect the –

center speaker the same way (matching the wire the color-coded label).

Note that the color-coded tabs are as follows:

• Red : Front right speaker •Purple : Subwoofer

• Front left speaker White : •Grey : Surround right speaker

• • Center speaker Green : Surround left speakerBlue :

Listening position

SPEAKERS

–

R L R L

CENT ER

SUB

WOOFER

FRONT

SURROUND

Front leftFront right

Surround leftSurround right

Center

Subwoofer

Receiver

HTP-2500/2600 Quick Start Guide

For detailed instructions, see the Operating Instructions supplied and / or contact one of our knowledgeable Pioneer Customer Service Representatives at 1 - (800) 421-1404.

Setting Up Your HTP-2500/2600 Home Theater System At-a-Glance

For detailed instructions, see the Operating Instructions supplied and / or contact one of our knowledgeable Pioneer Customer Service Representatives at 1 - (800) 421-1404.

AUDIO

DIGITAL INPUT

(COAXIAL)

DVD/DVR

TV IN

SPEAKERS

–

R L R L

CENTER

SUB

WOOFER

FRONT