Philips MatchLine 32FD9954 Bedienungsanleitung

Philips Monitor MatchLine 32FD9954

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Philips MatchLine 32FD9954 (17 Seiten) in der Kategorie Monitor. Dieser Bedienungsanleitung war für 4 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/17

CORRECTLY INCORRECTLY

Note: the enclosed template can be used for general positioning only

(fig. 1).

Mounting to sheetrock wall

Note: Bracket can only be used with standard 16" spaced wood wall

studs.

Bracket must be positioned so that the bracket is fastened firmly to

studs at each end.

All required hardware is included.

Note: Because the Receiver Unit’s power cord is 6’, when determining the

Display Unit mounting location, the distance to the nearest AC power

outlet must be considered.

&Determine desired location to mount Display Unit.

Within this area, locate the two 16.54" spaced wall studs that must

be used as the Wall Bracket mounting location. (fig. 1 and 2)

éWith the Wall Bracket held in place, ensure it is properly leveled.

Then, mark where the four holes must be drilled. (fig. 2)

Note: Use only the holes in Bracket.

“Remove the Wall Bracket, and using a 13/64" wood drill bit, drill the

four holes. (fig. 3)

‘Reposition the Wall Bracket, and with four lag bolts (fig. 4), secure

into place.Tighten with 13mm or 1/2" socket wrench. (fig. 5)

Note: Do not use plastic wall anchors with these lag bolts.

Note: Lag bolts must be fastened and centered securely into the stud.

Mounting Wall Bracket

fig. 1

fig. 2

420mm /16,54"

60,5mm / 2.38"

fig. 3

fig. 4

fig. 5

English

Mounting to concrete wall

&Determine desired location to mount Display Unit. Use the enclosed

template for alignment purposes. (fig. 1)

éWith the Wall Bracket held in place, ensure it is properly leveled.

Then, mark where the four holes must be drilled. (fig. 4)

“Remove the Wall Bracket, and using a 5/8" masonry drill bit, drill the

four holes. (fig. 2)

‘Insert a concrete anchor (with bolt) into each hole.

(Firmly tighten each bolt.Then, remove the bolts.

§Reposition the Wall Bracket, and with the four bolts (and washers),

secure into place.

Mounting to concrete block wall

&Determine desired location to mount the Display Unit.

Within this area, position the Wall Bracket so that the four end

mounting holes are located over the cavities of the concrete blocks

(refer to Figure 1)

éWith the Wall Bracket held in place, ensure it is properly leveled.

Then, mark where the four holes are to be drilled.

Note: Use only the four outside or end holes in the Bracket.

“Remove the Wall Bracket and reconfirm that the marks made in the

previous step are located in the cavities of the concrete blocks. Re-

locate the marks as required to ensure that they are in the cavities

of the concrete blocks.

‘With a 1/2” masonry drill bit, drill the four holes.

(Hinge the plastic legs of the toggle bolt into the channel of the metal

end of the toggle bolt so it can fit into the 1/2” hole drilled in the

wall (refer to Figure 2).

§Insert the toggle bolt into the hole in the wall and push it in until it

is in the cavity of the block.

èWith the plastic pull ring of the toggle bolt, pull the metal end of the

toggle bolt firmly against the back of the cavity of the concrete block

(refer to Figure 3).

WASHER

Cavities In Block

Fig. 1

Fig. 2

Fig. 3

!While holding the plastic pull ring, slide the plastic retaining sleeve

towards the wall until it fits into the hole in the wall. This will hold

the toggle bolt in the wall while the Wall Bracket is mounted (refer

to Figure 4).

Push down on the lower plastic leg of the toggle bolt and break it off

flush with the wall (refer to Figure 5).

Push up on the upper plastic leg of the toggle bolt and break it off

flush with the wall (refer to Figure 6).

Install the remaining 3 toggle bolts in the remaining holes the same

way that the first one was installed.

Position the Wall Bracket in place and install the four 1/4-20 bolts,

including washers, in each of the outside corner holes. Do not

tighten completely (refer to Figure 7).

Confirm that the Wall Plate is level, then tighten the bolts securely

(refer to Figure 8).

Mounting to metal stud wall

&Determine desired location to mount the Display Unit.

Within this area, locate the two 16.54” spaced metal wall studs that

must be used as the Wall Bracket mounting location.

éLocate the center of both wall studs at the height that the Wall

Bracket is to be mounted.

“With the Wall Bracket held in place, ensure it is properly leveled.

Then, mark where the four holes are to be drilled.

Note: Use only the four outside or end holes in the Bracket

(refer to Figure 1).

‘Remove the Wall Bracket and reconfirm that the marks made in the

previous step are located in the center of the metal wall studs. Re-

locate the marks as required to ensure that they are in the center of

the metal wall studs (refer to Figure 2).

Metal Wall

Studs

Fig. 1

Holes Centered In

Metal Wall Studs

Fig. 2

Fig. 4

Fig. 5

Fig. 6

Fig. 7

Fig. 8

Produktspezifikationen

Marke:	Philips
Kategorie:	Monitor
Modell:	MatchLine 32FD9954

Brauchst du Hilfe?

Wenn Sie Hilfe mit Philips MatchLine 32FD9954 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten

Ihren Namen*

Deine E-Mail*

Schreiben Sie hier Ihre Frage

Bedienungsanleitung Monitor Philips

Philips E Line 242E1G Bedienungsanleitung

4 Oktober 2024

Philips 246E9QHSW Bedienungsanleitung

3 Oktober 2024

Philips 243V7QSBP Bedienungsanleitung

23 September 2024

Philips 221B8LJEB Bedienungsanleitung

23 September 2024

Philips 246E8FJAW Bedienungsanleitung

19 September 2024

Philips S Line 201S8LHSB2 Bedienungsanleitung

9 September 2024

Philips Envia 32M2C3500L Bedienungsanleitung

6 September 2024

Philips 49B2U6900CH Bedienungsanleitung

6 September 2024

Philips 27M2N5500 Bedienungsanleitung

6 September 2024

Philips 43BDL4650D Bedienungsanleitung

5 September 2024

Bedienungsanleitung Monitor

Neueste Bedienungsanleitung für -Kategorien-

Acer EB321HQUDbmidphx Bedienungsanleitung

15 Oktober 2024

LG UltraGear 32GS85Q Bedienungsanleitung

15 Oktober 2024

LG UltraGear 27GS85Q Bedienungsanleitung

15 Oktober 2024

Bauhn APMTR-0624 Bedienungsanleitung

15 Oktober 2024

Acer K272HUL Dbmidpx Bedienungsanleitung

14 Oktober 2024

Hannspree Hanns.G HP 225 PJB Bedienungsanleitung

14 Oktober 2024

Asus VP249HR Bedienungsanleitung

13 Oktober 2024

Asus VE208N Bedienungsanleitung

11 Oktober 2024

NEC MD322C8-2 Bedienungsanleitung

11 Oktober 2024

ViewSonic V3D231 Bedienungsanleitung

10 Oktober 2024