Panasonic SC-EN25 Bedienungsanleitung

Panasonic Hi-Fi-Anlage SC-EN25

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Panasonic SC-EN25 (9 Seiten) in der Kategorie Hi-Fi-Anlage. Dieser Bedienungsanleitung war für 13 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/9
Operating Instructions
CD Stereo System
Model No. SC-EN27
SC-EN26
SC-EN25
System SC-EN25 SC-EN26 SC-EN27
Main unit SA-EN25 SA-EN26 SA-EN27
Speakers SB-EN25 SB-EN26 SB-EN25
SC-EN27 is used in
the illustrations unless otherwise mentioned.
These instructions are applicable to the following systems.
Dear Customer
Thank you for purchasing this product.
Before connecting, operating or adjusting this product, please read the
instructions completely.
Please keep this manual for future reference.
Troubleshooting guide
Before requesting service, make the following checks. If you are in doubt about any of the check points, or if the solutions indicated in the chart do not solve the problem,
refer to the “Customer Services Directory” on page 8 if you reside in the U.S.A., or refer to the “Limited Warranty” on page 8 if you reside in Canada.
No play.
• The disc isn’t correctly set.
• The disc is scratched or dirty. (Tracks skipped.)
• There is moisture on the lens. Wait for about an
hour and then try again.
MP3 cannot be read.
(SC-EN27)
• You may not be able to play MP3 if you have copied
a multi-session disc that has no data between
sessions.
• When creating a multi session disc, it is necessary
to close the session.
• The amount of data on the disc is too small. Set the
amount of data to greater than approximately 5 MB.
Sound is unfi xed,
reversed or comes
from one speaker only.
• Check the speaker connections. ( page 2)
No sound or there is a
lot of noise.
• Noise may occur when playing MP3 if recording
quality is poor.(SC-EN27)
• Keep this unit away from mobile telephones.
• Turn the volume up.
• Switch the unit off, determine and correct the cause,
then switch the unit on. Causes include shorting of
the positive and negative speaker wires, straining of
the speakers through excessive volume or power,
and using the unit in a hot environment.
Humming heard during
play.
• An AC power supply cord or fl uorescent light is near
the cords. Keep other appliances and cords away
from this unit’s cords.
This product may receive radio interference caused by mobile telephones during
use.
If such interference is apparent, please increase separation between the
product and the mobile telephone.
A beat sound is heard
while receiving a radio
broadcast.
• Switch the TV off or separate it from the unit.
A low hum or noise is
heard during AM
broadcasts.
• Keep the antenna away from other cables and
cords.
• Keep the AM antenna away from the unit.
The picture on the
television near the set
disappears or stripes
appear on the screen.
• The location and orientation of the antenna are
incorrect.
• The TV antenna wire is too close to the unit.
Separate the antenna wire of the TV set from the
unit.
Remote control
doesn’t work.
• Check that the batteries are inserted correctly. (
page 2)
• Replace the batteries if they are worn.
Display
– –:– –
• You plugged the AC power supply cord in for the fi rst
time or there was a power failure recently. Set the
time. ( page 5)
•
The total programmed play time is more than 200
minutes.
Tracks can still be programmed and played.
FULL • The number of programmed tracks is limited to 24.
No further tracks can be programmed.
NO/MP3
• A CD-ROM disc that is not CD-DA or MP3 format is
inserted.
It cannot be played.
ERROR • Incorrect operation performed. Read the instructions
and try again.
F76 • There is a power supply problem. Consult the
dealer.
Panasonic Consumer Electronics
Company, Division of Panasonic
Corporation of North America
One Panasonic Way Secaucus,
New Jersey 07094
http://www.panasonic.com
Panasonic Puerto Rico, Inc.
Ave. 65 de Infantería, Km. 9.5
San Gabriel Industrial Park, Carolina,
Puerto Rico 00985
Panasonic Canada Inc.
5770 Ambler Drive
Mississauga, Ontario
L4W 2T3
www.panasonic.ca
© 2005 Matsushita Electric Industrial Co., Ltd.
Printed in China
RQT8520-P
M1205KS0
P PC En
2
PHONES
SPEAKERS(6
)
R
L
HAU
T- PARLEURS
FM/AM ANT
AC IN
R
L
1
2
MUSIC PORT
Supplied accessories
The remote control
Use the numbers indicated in parentheses when asking for
replacement parts.
(As of December 2005)
In U.S.A. to order accessories, refer to “Accessory Purchases” on page 8.
1 Remote control
(N2QAGB000037)
(N2QAGB000038)
2 Batteries
1 FM/AM antenna
(N1DADYY00003)
1 AC power supply cord
(RJA0065-1D)
The included AC power supply cord is for use with this unit only. Do not
use it with other equipment.
Note
Batteries • Insert so the poles (+ and –) 
match those in the remote 
control.
• Do not use rechargeable type 
batteries.
Use
Remote control signal sensor
• Aim at the sensor, avoiding obstacles, at a
maximum range of 7 m directly in front of the
unit.
• Operation can be affected by strong light
sources, such as direct sunlight, and the glass
doors on cabinets.
Maintenance
To clean this unit, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this unit.
• Before using chemically treated cloth, read the instructions that came with
the cloth carefully.
Placement of speakers
Connections
1 Speakers
Before connecting, twist off
the tip.
Red
Black
Black
Red
Copper (+)
Silver (–)
Silver (–)
Copper (+)
2 FM/AM antenna
Stand the antenna up on its base.
3 AC power supply cord
Connect the AC power
supply cord only after all
other connections have been
made.
Conserving power
The unit consumes 2.0 W even when it is turned
off with [POWER
8
]. To save power when the
unit is not to be used for a long time, unplug it
from the household AC outlet.
Remember to reset the radio stations and any
other memory items before using the unit again.
If the unit is left unplugged for longer than
approximately two weeks, all settings will revert
to the factory settings.
To household AC outlet
Portable audio equipment
(Cords and equipment not included.)
Portable audio player Plug type:
3.5 mm (1/8 )″
stereo
Use
Start Playback from the
Portable audio source.
Note
• Adjust the volume and sound quality of this unit and
the other equipment.
• For details, refer to the instruction manual of the other
equipment.
Select
“MUSIC P”
Headphones
(Not included)
Reduce the volume before connection.
Plug type: 3.5 mm (1/8 ) stereo″
Avoid listening for prolonged periods of
time to prevent hearing damage.
Note
(R6, AA)
The socket outlet shall be installed near the equipment and easily accessible or the mains plug or an appliance coupler shall remain readily operable.
Care of the CD lens
• Clean the lens regularly to prevent malfunctions. Use a blower to remove
dust and a cotton swab if it is extremely dirty.
Recommended product: Lens cleaner kit (part no. SZZP1038C).
• Do not use the lens cleaner of the CD type.
Place this unit in an area with more than 240 mm (9
7/16 ) of vertical space. ″
The CD lid may become damaged if it cannot open
completely.
Placement of speakers
Left and right speakers are exactly the same.
• Keep your speakers at least 10 mm (13/32 ) away ″
from the system for proper ventilation.
• These speakers do not have magnetic shielding.
Do not place them near televisions, personal
computers or other devices easily infl uenced by
magnetism.
•
To avoid damage to the speakers, do not touch
the speaker cones if you have taken the nets off.
Caution
• Use the speakers only with the
recommended system. Failure
to do so may lead to damage to
the amplifi er and/or the speakers,
and may result in the risk of
fi re. Consult a qualifi ed service
person if damage has occurred
or if you experience a sudden
change in performance.
• Do not attach these speakers to
walls or ceilings.
Note
Note
Remote control
Unplug the antenna connector by
holding the taped part.
SC-EN27
SC-EN25/SC-EN26
Taped part
FM antenna
AM antenna
3
OPEN/
CLOSE
q h
SLEEP
CLOCK/
TIMER ADJ
DISPLAY
TIMER
SET/CHECK
PGM/CLEAR
-
AUTO PRESET
OPEN/
CLOSE
1 2 3
4 5 6
78
0
9
>
=
10
MUSIC PORT
TUNER/
BAND
CD
SOUND
EQ
LIVE
VIRTUALIZER
PLAY
MODE
ALBUM
VOLVOL
g
q h
PGM
PGM
PGM
PGM
PGM
CD operations
1 Set the CD in place.
Main unit Remote control
The unit comes on and the CD lid opens.
Label must face outward.
Press until you hear it click into place.
Press [ ] again to close.;
Keep fi ngers away from the CD lid when it is closing to avoid possible minor injury.
2 Start play.
Main unit Remote control Elapsed playing time of track
Track number
Note
If the CD is already in the unit, the unit comes on and play begins.
(One touch play)
To turn on
the unit
To stop play
To skip/
search
To adjust the volume
0
(Minimum)
50
(Maximum)
1
Input using the
numbered buttons
To select a 2-digit number
e.g. 16: [ 10] [1] [6]→ →
To select a 3-digit number
e.g. 226:
[ 10] [→10]
→→→ [2] [2] [6]
2
To adjust the volume
Stop
Pause
Skip/
Search
Direct
access
play
Play starts
with the track
you select.
Main unit Remote control
Main unit Remote control
Main unit Remote control
Number of tracks
Total play time
Number of albums
Number of tracks
MP3
Press again to resume play.
Press to skip/
Press and hold to search
Note
• You can search during play or while paused.
• You cannot search through MP3 fi les. (SC-EN27)
• You can only search within the current track during
program play, one track repeat, and random play.
Select the desired track
Refer to page 6 regarding MP3 play. (SC-EN27 only)
Repeat play/
random play
1-&
: One track
repeat
&
: All track
repeat
RND
: Random
play
• Each time you press the button:
1-& & → → RND
(While stopped)
No display (Canceled)
Select the
play mode
Note
• During random play, you cannot skip to the previous
track.
•
You cannot select “RND” while playing MP3. (SC-EN27)
• You cannot use random play and program play at the
same time.
Program
play
This function
allows you to
program up to 24
tracks.
Press while
stopped Select tracks
(Maximum 24 tracks)
Start play
Track number
Sequence number
Track number
Total play time
(CD only)
• Erase a program
(While stopped)
Note
Program contents are stored in the unit’s memory
even after changing to a different function or turning
the unit off. All program contents are erased by
pressing [PGM/CLEAR] or by opening the CD lid.
• Confi rm a programmed
track (While stopped)
• Add a program track
(While stopped)
Select the track
you want to add
Note
• You cannot use random play and program play at
the same time.
(SC-EN27)
• Be sure to press the [OPEN/CLOSE]
button to open and close the CD lid.
•
Damage may occur if the lid is forced closed.
Note

Produktspezifikationen

Marke: Panasonic
Kategorie: Hi-Fi-Anlage
Modell: SC-EN25

Brauchst du Hilfe?

Wenn Sie Hilfe mit Panasonic SC-EN25 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Hi-Fi-Anlage Panasonic

Panasonic

Panasonic RB-HX220B Bedienungsanleitung

2 Oktober 2024
Panasonic

Panasonic SC-PM18P Bedienungsanleitung

29 September 2024
Panasonic

Panasonic SH-E75 Bedienungsanleitung

21 September 2024
Panasonic

Panasonic SC-PM4DB Bedienungsanleitung

6 September 2024
Panasonic

Panasonic SC-PM270 Bedienungsanleitung

3 September 2024
Panasonic

Panasonic SC-PM704 Bedienungsanleitung

3 September 2024
Panasonic

Panasonic SC-HC397 Bedienungsanleitung

3 September 2024
Panasonic

Panasonic SC-AK630 Bedienungsanleitung

2 September 2024
Panasonic

Panasonic RX-D15 Bedienungsanleitung

2 September 2024
Panasonic

Panasonic SC-VKX25 Bedienungsanleitung

28 August 2024

Bedienungsanleitung Hi-Fi-Anlage

Neueste Bedienungsanleitung für -Kategorien-

Lenco

Lenco MC-129 MP3 Bedienungsanleitung

16 Oktober 2024
Akai

Akai EIE Pro Bedienungsanleitung

14 Oktober 2024
Sennheiser

Sennheiser SZI 1029 Bedienungsanleitung

7 Oktober 2024
Yamaha

Yamaha MusicCast SRT-1500 Bedienungsanleitung

7 Oktober 2024
Kicker

Kicker 46HDTPH Bedienungsanleitung

7 Oktober 2024
Vtech

Vtech V-Kids Bedienungsanleitung

5 Oktober 2024
Hitachi

Hitachi AX-M10E Bedienungsanleitung

5 Oktober 2024
IDance

IDance XD8N Bedienungsanleitung

5 Oktober 2024
LD Systems

LD Systems DAVE 18 G3 Bedienungsanleitung

4 Oktober 2024
Pyle Pro

Pyle Pro PWMA1216BM Bedienungsanleitung

4 Oktober 2024