Monacor PSL-18/24 Bedienungsanleitung

Monacor Schalten PSL-18/24

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Monacor PSL-18/24 (2 Seiten) in der Kategorie Schalten. Dieser Bedienungsanleitung war für 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/2
OVER TEMPERATURE
MAX. No. of PSUs on 16A
CIRCUIT BREAKER 17 units (circuit breaker of type B) / 28 units (circuit breaker of type C) at 230VAC
SPECIFICATION
MODEL LPH-18-12 LPH-18-36LPH-18-24
DC VOLTAGE
RATED CURRENT
CURRENT RANGE
RATED POWER
OUTPUT
LINE REGULATION
LOAD REGULATION
SETUP, RISE TIME
VOLTAGE RANGE
FREQUENCY RANGE
EFFICIENCY(Typ.)
AC CURRENT
INPUT
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSION
OTHERS
NOTE
PACKING
OVERLOAD
OVER VOLTAGE
12V 36V24V
1.5A 0.5A0.75A
0 ~ 1.5A 0 ~ 0.5A0 ~ 0.75A
18W 18W18W
120mVp-p 200mVp-p150mVp-p
±3.0%
±1.0%
±2.0%
1500ms, 30ms / 230VAC
47 ~ 63Hz
77% 82% 83%
0.3A/230VAC
0.25mA / 240VAC
Protection type : Hiccup mode, recovers automatically after fault condition is removed
20 ~ 90% RH non-condensing
-40 ~ +80 , 10 ~ 95% RH℃
± ℃ ℃0.03%/ (0 ~ 50 )
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.℃
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
5. Suitable for indoor use or outdoor use without direct sunlight exposure.
6. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.
18W Single Output Switching Power Supply
180-264VAC input only
Fully encapsulated with IP67 level (Note.5)
Protections:Short circuit / Overload / Over voltage / Over temperature
Cooling by free air convection
ⅡClass power unit, no FG
Pass LPS
100% full load burn-in test
Suitable for LED related fixture or appliance
(such as LED Decoration or Advertisement devices)
High reliability / Low cost
2 years warranty
LPH-18 s e r i e s
RIPPLE & NOISE (max.) Note.2
VOLTAGE TOLERANCE Note.3
ENVIRONMENT
SAFETY &
EMC
(Note 4)
PROTECTION
File Name: LPH-18-SPEC 2017-11-03
SAFETY STANDARDS
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
I/P-O/P:3KVAC
Above 105% rated output power
HOLD UP TIME (Typ.) 50ms/230VAC at full load
13.8~ 16.2V 27.6~ 32.4V 41.4 ~ 48.6V
Protection type : Shut off o/p voltage, clamping by zener diode
140*30*22(L*W*H)
COLD START 50A(twidth=155 s measured at 50% Ipeak) at 230VACμ
Hiccup mode, recovers automatically after temperature goes down
TUV EN60950-1, IP67 approved; design refer to UL1310 Class 2,CAN/CSA No. 223-M91
1200.6K hrs min. MIL-HDBK-217F (25 )℃
0.175Kg; 70pcs/13.3Kgs/0.71CUFT
â– Features :
IP67
LPS
I/P-O/P:>100M Ohms / 500VDC / 25 / 70% RH℃
180 ~ 264VAC 254 ~ 370VDC
-30~ +70 (Refer to "Derating Curve")℃
Compliance to EN55032 (CISPR32) Class B, EN61000-3-2 Class A, EN61000-3-3
Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria AEMC IMMUNITY
EMC EMISSION
Mechanical Specification Unit:mm
Derating Curve Static Characteristics
AMBIENT TEMPERATURE ( )℃
LOAD (%)
-30 0 10 20 30 40 50 70
20
40
60
80
100
(HORIZONTAL)
Block Diagram
DETECTION
PWM
CIRCUIT
EMI FILTER
POWER
SWITCH-
FILTER
&
RECTIFIERS +V
-V
I/P
ING
CONTROL
50
18W Single Output Switching Power Supply LPH-18 s e r i e s
UL 1015 18AWG
+V(Red)
-V(Black)
UL 1015 18AWG
INPUT VOLTAGE (VAC) 60Hz
180 190 200 220210 230 250240 264
LOAD (%)
90
100
80
70
60
50
40
fosc : 60KHz
RECTIFIERS
60
140
30
22
AC IN
DC OUT
AC/N(Blue)
AC/L(Brown)
300 20±300 20±
ψ3.6
ψ3.6
3.5
3.5
3.5
3.5
File Name: LPH-18-SPEC 2017-11-03
Recommend Mounting Direction
20
T case
※T case: Max. Case Temperature
56


Produktspezifikationen

Marke: Monacor
Kategorie: Schalten
Modell: PSL-18/24

Brauchst du Hilfe?

Wenn Sie Hilfe mit Monacor PSL-18/24 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Schalten Monacor

Bedienungsanleitung Schalten

Neueste Bedienungsanleitung für -Kategorien-